膜的形成 的英文怎麼說

中文拼音 [módexíngchéng]
膜的形成 英文
filming
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 的 : 4次方是 The fourth power of 2 is direction
  • 成 : Ⅰ動詞1 （完成; 成功） accomplish; succeed 2 （成為; 變為） become; turn into 3 （成全） help comp...
  1. Especially, at the site of implantation of day 5, 6, uterine stroma cell apposing the preimplantation blastocyst changed into the decidual cells and displayed a distinct immunostaining of phospho mapk. western - blot results showed p44 express stronger than p42 did, with both their peak expression were observed on day 5, during the period of uterine decidualization

    上述結果表明， ma衛k的激活與子宮內膜的接受性及蛻膜的形成有密切關系，推測mapk級聯通路激活對蛻膜化十分重要，蛻膜化可能與egf尼gfr直接或間接激活erk有關。
  2. It not only gains the physical contrastive datum mark, but also improves the blm stability. cyclic voltammetry is used to study the characteristic of blm attached to metal surface, as the forming of blm, the voltammetric characteristics of blm, the selection of ion and measurement of different ki concentration

    就以上提出的處理方法，採用循環伏安法詳細研究了金屬表面所覆blm的基本性質，如：膜形成液的配製、膜的形成、膜電阻、膜的伏安特性、膜的擊穿電壓、離子的識別性及對不同濃度的碘化鉀溶液的測試。
  3. The heat - reaction characteristics of ni / si and tin / ni / si structure and the regularity for forming the nisi film have been studied deeply and formed the excellent ni - salicide shallow junction diode

    文中對ni si和tin ni si的熱反應特性以及nisi薄膜的形成規律進行了詳細的研究。制備了優質的ni硅化物淺結二極體。
  4. The dissertation firstly discusses the reflectance of euv and soft x - ray in " multilayer system based on classical electrodynamics and optical characteristics of materials. the nns surface roughness in different spatial frequency range is carefully studied since scattering can seriously reduce the reflectance in euv and soft x - ray wavelength region. we discuss representative model of residual stress in

    首先從材料在極紫外、軟x射線波段的光學特性出發，討論了極紫外、軟x射線在理想和非理想多層膜系中的反射特性；研究了影響極紫外、軟x射線多層膜反射率的表面粗糙度的空間頻率范圍；重點探討了多層膜殘余應力的典型模型、應力形成機制以及薄膜的形成過程。
  5. In this chapter we consider the formation and characteristics of the flims

    在這一章中，我們考慮了膜的形成和特性。
  6. Scanning electron microscope ( sem ) and x - ray photoelectron spectroscopy ( xps ) studies indicated that the additive of cs _ 2 took part in the sei film - forming in the process of battery cycles. the elements of carbon, oxygen and fluorin are the main members in the compounds of sei film. sulfur is also one of the main elements of the sei film when the electrolyte included additive of cs _ 2

    利用掃描電子顯微鏡和x射線光電子能譜研究表明，二硫化碳在電池的循環過程中參與了sei膜的形成， sei膜的組成物質中主要是c 、 o 、 f三種元素，加入二硫化碳后， s元素也成為主要組分， sei膜的主要組成物質有烷基氧鋰、烷基碳酸酯鋰、碳酸鋰、硫酸鹽、聚烯烴及氟化鋰等。
  7. ( 2nyith n - a isotherm curves and n - t time curves, the adsorption beboen huinan serum albumin ( hsapo are on sufohases with arerent ph values is also systemahall studied, the result demonsan tha the veboty of adsorption and desorption of hihb and hsa gets to equation after about 1 hour. the collapse pressare and the mean area per molecul of monolayer keeps w aha the dsrption compared with tha prio to the adsorption, whil the hsa originall adsoibed on hihb is foed ou of the ds of m monofayer

    結果表明， hsa在hihb單分子膜面下的吸附解吸平衡在本實驗條件下約二小時達到； hsa在單分子膜二次壓縮的前期可能參與膜的形成，在壓縮的過程中，吸附在hihb上的hsa逐漸被擠出單分子膜面， hsa的存在基本不影響單分子膜的崩潰壓和平均分子占據面積。
  8. The paper is mainly focused on two fields. one is the formation of any thick porous silicon ( ps ) layers, which is content with 1c process. the other is the low - loss performance of passive elements fabricated on ps / oxidized porous silicon ( ops ) inter - layers under microwave operation

    本論文主要的研究內容分為兩個方面：其一是厚度可控的與ic工藝兼容的多孔硅膜的形成技術研究；其二是研究在多孔硅氧化多孔硅介質膜上制備無源器件的微波低損耗特性之可行性。
  9. The researchers showed that gallium killed microbes, and prevented the formation of biofilms

    研究人員表明鎵能夠殺死微生物，阻斷被膜的形成。
  10. This paper analyses the water - film formation in steam heating roller and its influence on heat conduction performance to roller, and then provides a better settlement scheme for the problem of how to eliminate the water - film and improve the heat conduction performance of the roller

    摘要就蒸汽加熱輥中水膜的形成、對輥筒的導熱性能的影響進行了分析，針對如何消除水膜、提高輥筒導熱性能的問題提出了解決方法。
  11. The formation process, dynamic variation, deciduous causes of oxide film of work roll are analyzed, and the control methods have been put forward

    分析了氧化膜的形成過程、動態變化及脫落原因，並提出了控制方法和措施。
  12. The formation mechanism and the structural adjustment of nano aluminum anodic oxide film

    納米級鋁陽極氧化膜的形成機理及結構調整
  13. The transfer film make the surface more smooth and decrease the wear ratio greatly

    認為轉移膜的形成令磨損表面更加光滑，有利於改善摩擦材料的耐磨性能。
  14. The formation and evolution process of the aao accords with the model of electric fuleld dissolution

    多孔有序陽極氧化鋁膜的形成更符合「電場支持下的溶解」模型。
  15. Through the ir transparent spectra, we found anion of anodizing electrolytes, also participate the formation of porous membrane during the anodizing procedure

    通過ir光譜的譜線發現，在陽極氧化過程中，電解液中的陰離子也參與了多孔膜的形成。
  16. Anodization of high purity al foil in phosphoric acid solution at different pressures was experimentally studied to understand the formation mechanism of the nano - porous anodic alumina membranes

    摘要為探討多孔鋁陽極氧化膜的形成機理，研究了不同氣壓條件下鋁在磷酸溶液中的陽極氧化過程，發現在真空下進行陽極氧化，氧氣析出非常明顯。
  17. We make up a simple model based on the microscopic mechanism of the membrane to investigate this phenomenon. the model proves reasonable after we quantify the velocity of the pearls drift slowly towards the laser trap

    對於此動力學行為，本文從膜的微觀結構出發，建立了一個簡單的模型，解釋了珠鏈狀膜的形成以及光鑷熄滅后水珠的運動。
  18. The purpose of this study is to investigate the formation of liquid falling film and its flow behavior on the surface of a horizontal twisted and fluted tube used in the case of wet flue gas desulfurization, desalination, and so on

    本文從理論上研究了水平螺旋槽管壁面液膜的形成機理及流動特性，為工業生產過程中高效換熱器的應用提供理論基礎。本文做的主要工作有： 1
  19. On the other hand, the phenomenon which cac2o4 agglomerates in the self - assembly film of cs is observed by afm. the results show that liesegang loops can be formed from caca2o4 when the concentration of cs is just fit for forming reticulation ( 1. 0g / l ). the elementary explanation is presented in this study including electric charge conglomeration and the matching of geometry crystal lattice

    用afm研究其形成的凝膠網路結構，並涉及到這種高分子濃度以及金屬鈣離子對自組裝結構的影響，結果表明當cs濃度為1 . 2mg ml時， ca ~ （ 2 + ）能很好的誘導cs自組裝膜的形成，這種自組裝結構會隨時間發生形態學改變，具有不穩定性。
  20. In the light of the specific characteristics of structure of traction drivespeed - raising system, its structure is modified and resistance method is introduced to measure the lubrication film ; besides, computerisused to colle ctandanalyze data. thus effectivemeasure mentmethod for similar structure is provided

    針對牽引驅動增速系統結構的特殊性，對該系統的輸出軸進行了改造，採用電阻法對其油膜的形成進行了測試，並利用計算機採集數據、進行分析，為類似結構的油膜測試研究提供了一種行之有效的研究方法。
分享友人
分享到 Line

分享到臉書