膠乳濃度 的英文怎麼說

中文拼音 [jiāonóng]
膠乳濃度 英文
degree of latex
  • : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
  • : Ⅰ動詞(生殖) give birth to Ⅱ名詞1 (乳房) breast2 (奶汁) milk 3 (像奶汁的東西) any milk lik...
  • : 形容詞1. (液體或氣體中所含的某種成分多; 稠密) dense; thick; concentrated 2. (程度深) (of degree or extent) great; strong
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 濃度 : potency; thickness; concentration; consistence; strength; consistency; density
  1. The latex concentration is raised by evaporation or centrifugation.

    通過揮發或離心作用提高
  2. The remaining 5 percent of the ingredients are non - organic or synthetic, and include baking powder, pectin to make yogurt thicker, or carbon dioxide to keep products, like cottage cheese, fresher longer

    其餘5 %的成分為無機物質或人工合成物,包括用來製作高酪的發酵粉,質,或可使像松軟乾酪一類產品保持持久新鮮的二氧化碳。
  3. Their properties have been investigated by using scanning electronic microscopy ( sem ), differential scanning calorimetry ( dsc ), x - ray diffraction ( xrd ), thermogravimetry - differential thermal analysis ( tg - dta ), infrared spectroscopic analysis ( ir ), and gas chromatography ( gc ), etc. the effects of the mulser ' s stirring rate and the emulsifier concentration on the properties of encapsulated pcms have been systematically studied, and nanopcms have been obtained by increasing the stirring rate or the emulsifier concentration. the influences of different nucleating agents on micropcm performances have also been investigated in detail to search for a suitable nucleating agent to prevent micropcms from super - cooling

    首先,系統研究了化機轉速和化劑囊性能的影響,並通過提高轉速或化劑獲得相變材料納囊;其次,系統研究了不同成核劑對微囊性能的影響,找到合適的成核劑抑制了相變材料微囊的過冷現象;再次,詳細研究了環己烷對囊性能的影響,並通過添加適量環己烷提高了相變材料微囊及納囊的耐熱溫
  4. Natural rubber latex concentrate. prevulcanized rubber latex. determination of viscosity

    縮天然硫化的測定
  5. Natural rubber latex concentrate. prevulcanized rubber latex. determination of swelling capacity

    縮天然硫化溶脹的測定
  6. Natural rubber latex concentrate - determination of alkalinity

    縮天然.堿測定
  7. Abstract : this paper researches into the complex adhesive , which was mainly made by the soy protein isolate ( spi ) and polyvinyl alcohol or polyvinyl acetate. different composition of protein and polymers can perform different characters, together with other ingredients. the factors, which are related to the first adhesive strength and adhesive strength, are mainly studied and discussed. the first adhesive strength of the complex adhesive is related to the content of spi, and the adhesive strength is related to the content of the complex adhesive. on the basis of the researching, we can make the plant fibre box for food in the future

    文摘:對大豆分離蛋白?聚乙烯醇、大豆分離蛋白?白復合粘劑進行了研究,採用不同混合比例及添加其他助劑,得到較好性能和可生物降解的復合粘劑,為製造一次性植物纖維快餐盒打下基礎.主要研究了影響這種復合粘劑粘接木塊的初粘力(剪切和拉伸強)和粘接強的因素,實驗表明: 9 . 2 %的大豆分離蛋白的初粘力(剪切和拉伸強)優於10 %的聚乙烯醇和33 %的白;大豆分離蛋白復合粘劑的初粘力主要與大豆分離蛋白含量有關,其最終粘接強液固含量正相關
  8. With the reference of many relevant materials, the author prepared a fined molybdenum disulfide powder with a average size of 800nm by ball milling, and a nano - copper with average size of 30nm in micromulsion solution method, and synthesized surface - modified titanium dioxide nanoparticles with average size of 40nm in organic media via sol - gel method. the tribological performances of three particles were studied by universal test as well, with the result of fined molybdenum disulfide powder with good reducing wear and antiwear performance at low load, nano - copper with good reducing wear and antiwear performance at high load, surface - modified titanium dioxide nanoparticles maintaining stable reducing wear and antiwear performance from low load to high load due to its characteristics of organic and inorganic nanocomposite. the results indicate that the nanocomposite is the most perspective oil additive. the reducing wear and antiwear mechanism of nano oil additive was studied with in - situ tribochemical principle. nano additives possess broadly developing prospect with its above - mentioned performance

    在參閱了大量文獻的基礎上,分別採用了球磨法、微液法、溶?凝法制備了超細二硫化鉬、納米銅粒子、表面修飾納米二氧化鈦,經原子力顯微鏡測試,獲得的超細二硫化鉬的粒平均在800nm以內,納米銅粒子平均粒約為30nm ,表面修飾納米二氧化鈦平均粒約為40nm ,在萬能摩擦磨損試驗機上測試了三種粒子的摩擦學特性,結果表明:在合理的添加范圍內,超細二硫化鉬在低載時具有優良的減摩抗磨性能,納米銅在高載時具有比較好的減摩抗磨性能,表面修飾二氧化鈦粒子因具有有機與無機復合物的特性,從低載到高載都保持穩定的減摩抗磨性能。
  9. As far as the new technology of selective diffusion, the method of printing is used and the phosphoric paste ( high concentration ) is printed at the electrode - site in silicon. afterwards, a thin layer of phosphoric source ( low concentration ) is sprayed on the surface of the non - electrode - site in silicon

    在選擇性擴散新工藝中,我們採用絲網印刷電極的方法在矽片的電極位置印刷較高的磷漿(摻磷sio _ 2) ,在非電極區噴塗一層較低的磷源,擴散后形成重摻雜和輕摻雜。
  10. Results indicated that the concentration of salvolatile and the conserved effect was in proportion because of the capability to counteract the acids produced by microbe

    實驗結果表明,越高的碳酸銨鹽溶液的保存體系,其緩沖能力越大,越能很好地中和細菌代謝產生的脂肪酸,以防止天然的迅速凝固,保存效果越好。
  11. 7. sodium chloride has slight effect on the heat of micropcm phase transition, but it easily leads microcapsules to stick together. for the microcapsules feeding more than 6 % sodium chloride in the emulsion, their super - cooling can be prevented availably ; however, their mechanical intensity and their thermal stabilities turn worse and they cohere each other

    7 、 nacl對微囊的相變熱影響較小,但容易造成微囊粘結;液中的naci超過為6 %合成的微囊的過冷現象得到明顯改善,然而,囊的機械強與耐熱性能均下降,微囊之間發生粘結。
  12. The method by which the inhibitory action of instable emulsification on evaporation of oils is first suggested here, which is demonstrated to be feasible. the evaporative characteristic of unstable shengli oil emulsion has been inspected thought pan evaporation method. it has been concluded that the combination and interaction of

    結合化動力學過程的探討,對mackay方程式進行改進,即通過改變瀝青質和質組分,計算蒸發對化的影響,認為化的化學條件滿足時,一定時間后完全化。
  13. Accurate measurement in highly concentrated solutions has always been a desire of latex manufacturers because of concerns about particulate changes arising during dilution

    為了避免稀釋造成的微粒變化,製造者總是希望在高溶液中進行精確測量。
分享友人