膠乳試驗 的英文怎麼說
中文拼音 [jiāorǔshìyàn]
膠乳試驗
英文
latex test- 膠 : Ⅰ名詞1 (某些具有黏性的物質) glue; gum 2 (橡膠) rubber 3 (姓氏) a surname Ⅱ動詞(用膠粘) st...
- 乳 : Ⅰ動詞(生殖) give birth to Ⅱ名詞1 (乳房) breast2 (奶汁) milk 3 (像奶汁的東西) any milk lik...
- 試 : 名詞(古代占卜用的器具) astrolabe
- 驗 : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
- 試驗 : trial; experiment; test
-
The results of the tests indicated that latex and polyurethane foam mattresses burned fastest.
試驗結果表明,天然乳膠和聚氨基甲酸乙酯泡沫床墊燃燒得最快。Rubber latices - methods of test - determination of alkalinity for polychloroprene latex
橡膠乳.第3部分:試驗方法.第25節:聚氯丁橡膠堿性測定Methods of test for petroleum and its products - bs 2000 - 521 : bitumen and bituminous binders - determination of adhesivity of bitumen emulsions by water immersion test - aggregate method
石油及其製品的試驗方法. bs 2000 - 521 :瀝青和瀝青粘合劑.水浸入試驗測定瀝青乳膠的粘度.集料法Standard test method for aging effects of artificial weathering on latex sealants
人工風蝕對膠乳密封料老化效果的標準試驗方法Test method for rubber latex - styrene - butadiene copolymer - determination of residual styrene
橡膠膠乳試驗方法.苯乙烯丁二烯共聚物.殘留苯乙烯的測定An emulsion under test must always be exposed to light of the correct wavelength and wavelength range.
試驗的乳膠必須始終對恰當的波長和波長范圍進行曝光。Standard test method for wet adhesion of latex paints to a gloss alkyd enamel substrate
將乳膠塗料濕粘合到光澤醇酸磁漆底層的標準試驗方法Rubber latex products - test method for resistance to steam ageing
膠乳製品蒸汽老化試驗方法Standard test method for low - temperature coalescence of latex paint films
乳膠漆膜低溫聚結的標準試驗方法Standard test methods for rubber latices - synthetic
合成橡膠膠乳的標準試驗方法Test method of resistance to steam ageing for rubber latex products
膠乳製品蒸汽老化試驗方法Natural latex rubber condoms - requirements and test methods
天然乳膠陰莖套.要求和試驗方法Standard test method for nonvolatile content of latexes
乳膠的不揮發物含量的標準試驗方法Standard test method for low - temperature flexibility of latex sealants after artificial weathering
膠乳密封料受人工氣候影響后的低溫柔韌性的標準試驗方法Rubber latices - methods of test - preparation of dry films from natural rubber latex concentrate
橡膠乳.第3部分:試驗方法.第24節:天然膠乳濃縮物干膜制備With the reference of many relevant materials, the author prepared a fined molybdenum disulfide powder with a average size of 800nm by ball milling, and a nano - copper with average size of 30nm in micromulsion solution method, and synthesized surface - modified titanium dioxide nanoparticles with average size of 40nm in organic media via sol - gel method. the tribological performances of three particles were studied by universal test as well, with the result of fined molybdenum disulfide powder with good reducing wear and antiwear performance at low load, nano - copper with good reducing wear and antiwear performance at high load, surface - modified titanium dioxide nanoparticles maintaining stable reducing wear and antiwear performance from low load to high load due to its characteristics of organic and inorganic nanocomposite. the results indicate that the nanocomposite is the most perspective oil additive. the reducing wear and antiwear mechanism of nano oil additive was studied with in - situ tribochemical principle. nano additives possess broadly developing prospect with its above - mentioned performance
在參閱了大量文獻的基礎上,分別採用了球磨法、微乳液法、溶膠?凝膠法制備了超細二硫化鉬、納米銅粒子、表面修飾納米二氧化鈦,經原子力顯微鏡測試,獲得的超細二硫化鉬的粒度平均在800nm以內,納米銅粒子平均粒度約為30nm ,表面修飾納米二氧化鈦平均粒度約為40nm ,在萬能摩擦磨損試驗機上測試了三種粒子的摩擦學特性,結果表明:在合理的添加濃度范圍內,超細二硫化鉬在低載時具有優良的減摩抗磨性能,納米銅在高載時具有比較好的減摩抗磨性能,表面修飾二氧化鈦粒子因具有有機與無機復合物的特性,從低載到高載都保持穩定的減摩抗磨性能。Styrene - butadiene rubbers and oil extended styrene butadiene. emulsion polymerised types. test recipe and evaluation of vulcanisation characteristics
丁二烯一苯乙烯橡膠和加油丁二烯一苯乙烯.乳狀聚合物型.試驗配方和硫化特性的評定Standard test method for effectiveness of liquid, gel, or cream insecticides against adult human lice
抗成蟲虱子的液狀膠狀或乳狀殺蟲劑效果的標準試驗方法Rubber latices - methods of test - determination of surface tension
橡膠乳.第3部分:試驗方法.第10節:表面張力測定Testing of latex - determination of total solids content
乳膠的試驗.總固體含量的測定分享友人