膠凝狀的 的英文怎麼說

中文拼音 [jiāoníngzhuàngde]
膠凝狀的 英文
gelatinous
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 凝 : 動詞1. （凝結） congeal; curdle; coagulate 2. （注意力集中） fix
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 的 : 4次方是 The fourth power of 2 is direction
  1. Sponges have an irregular, asymmetrical body architecture ; there are two cell layers separated by a gelatinous mesenchyme containing amoeboid cells and skeletal spicules and fibers

    海綿動物有不規則、不對稱的體制；二層細胞是由中間的凝膠狀的間葉細胞分開，內含有變形細胞（阿米巴細胞） 、骨針和纖維。
  2. Two cell layers ( diploblastic ) separated by a gelatinous mesoglea

    兩層細胞（兩胚層） ，中間是凝膠狀的中膠層。
  3. Inorganic anti - cracking reinforced chemical additive, called wj, generates some tittle expansive crystals in hydration process in concrete to reduce the porosity and improve the distribution of pore size. the expansive power is process in common to tumefaction that petty crystalloid aft suck water and pressure to concrete pores that aft crystal gather volume. its adding weight was 8 % - - 12 % in cement, its restrained expansive ratio was about 0. 02 % - - 0. 06 %, and relevantil brought self - stress 0. 2mpa ?. 6mpa

    無機增強抗裂材料wj摻入普通混凝土中，在水化硬化過程中生成一定量的微膨脹結晶體，降低空隙率，改善混凝土中孔結構分佈。其膨脹驅動力是凝膠尺寸的晶體鈣礬石吸水腫脹和結晶狀鈣礬石對孔隙產生膨脹壓的共同作用。當wj摻量為8一12兒在鋼筋和鄰位的限制下，使混凝土產生0
  4. Powdery propellant, oxide, polymer and agent can be mixed to make slurry explosive, the sensitivity of slurry explosive is discussed ; slurry explosive can be made into special shape destructor, it results of the area, height and setting angle of explosive is related to the destr ucted effect ; the destroying effect of slurry explosive is also studied from the experiment in the air and on the steel plate

    在粉碎后的發射藥顆粒中加入氧化劑、膠凝物及交聯劑等能製成漿狀炸藥，研究了影響其感度的因素；根據漿狀炸藥的特點可以用來製造一些特殊形狀的爆破具並其進行了對比實驗；對漿狀炸藥在空氣中和鋼板上的破壞作用也進行了對比實驗研究。
  5. Status and prospects of the sol - gel coating technology

    溶膠凝膠塗層技術的現狀與展望
  6. Development and application situation of acid gelling agent home and abroad

    國內外酸化用膠凝劑的發展及應用現狀
  7. In this paper, the history, basic process and characteristic of the sol - gel theory and technology are first introduced in brief. then it presents the newly research progresses and the applications of the sol - gel method in preparing bulk, fiber, coatings and films, powder and complex materials. then the kind of sio2 - zro2 gel bulk glass - ceramic is prepared by using sol - gel method and the water - exchanging method

    本文首先簡要介紹了溶膠?凝膠理論和技術的歷史背景、基本工藝過程及特點，並著重評述了溶膠?凝膠技術在制備塊狀、纖維、薄膜與塗層、粉末和復合材料方面的最新研究進展及其應用；採用溶膠?凝膠法與水置換法制備了尺寸較大的sio _ 2 - zro _ 2系玻璃-陶瓷，採用分步水解法制備了摻釹sio _ 2 - al _ 2o _ 3激光玻璃-陶瓷。
  8. The temperature from amorphous to crystal of tungsten oxide sol - gel films with catalyst is increased and the reason is in studying. as results of tunnel scan - afm, both pt sputtered tungsten oxide films and pt sputtered tungsten oxide sol - gel films there is distinct and out - of - order parallel line structure on the surface of amorphous. molecules of the sample tend to tetrahedron and the former has more planarer structure

    隧道-原子力顯微鏡測試結果表明:非晶態時，磁控濺射摻鉑薄膜樣品表面和溶膠凝膠摻鉑樣品表面都有明顯的平行線狀結構，長程無序，分子趨於四面體結構，只是前者比後者表面較平整;晶態時，磁控摻鉑樣品在自然生長面上原子呈平面分佈，長程有序，溶膠摻鉑樣品則呈wo6面心結構。
  9. The fluorescence intensity of tb observed in pt / tb sol was stronger than that in powders. the network made of o, ti, such as sol and noncrystalline powders, determined the fluorescence intensity of pb

    Pb離子的熒光與pb所處環境相關，既可出現在液相體系，又可出現在固相粉末體系中，也即處于o ， ti等離子構成的無規則網路結構狀態下的溶膠、凝膠或非晶固態時。
  10. The doped material performed well electrochemical property for cycling. the initial discharge capacity of doped material was 165mah / g. after 80 cycles, the capacity loss was about 20 %

    使用溶膠凝膠法對層狀limno2進行2 % al3 +的摻雜改性，初始放電容量可達165mah / g ， 80次循環后衰減約20 % 。
  11. Xrd measurements showed that tio2 in the composites was anatase nano - crystallite with 5 - 10 nm size. sem images showed that some of the tio2 nano - crystallites coated on the surface of the mmt and some of them plugged into the gap between flakes of mmt. combining xrd result with sem images, it was clearly that the mmt and tio2 nanocrystallites formed a netlike nanocomposite structure

    用改性的溶膠凝膠法制備了一種mmt tio _ 2復合電流變顆粒， xrd ， sem分析證實tio _ 2是以納米晶的形式沉積于mmt的片層結構之間及顆粒表面，形成了一種網狀包覆的納米復合結構。
  12. It is introduced that the main factor of the lithium - ion battery characteristic of request, indicated the superior electronic properties is mainly related to the cathode material preparation. the paper investigated the synthesis process of tricobalt tetraoxide fine particles by the uniform sol - gel method, using a few analysis equipments test the particles

    首先提出均勻凝膠沉澱法新方法，採用此新技術合成了超細co3o4 ，研究了各種因素對合成過程的影響，採用復配沉降劑，獲得了絮凝狀中間體，經測試證明絮凝狀中間體含有大量羥基。
  13. Results show that c2s, c3s and ca ( oh ) 2 in hydration sample with steel - making slag powder are more than those in hydration sample with fly ash or blast furnace slag. sequence of capacity bonding water

    結果表明，含摻合料膠凝材料的水化產物形貌與純硅酸鹽水泥的水化產物形貌比較相似，在較短齡期水化樣的孔隙中能明顯觀察到針狀
  14. Used to make gels by absorbing fluids to form gel - like texture. can be used to make facial gels and serums. origins : japan. suggested usage : ~ 4 % - 8 %

    又稱為凝膠形成劑，這是一種高分子聚水物，可結合水分形成果凍狀的膠質。可用作製作凝膠、精華素。產地：日本。建議使用量： ~ 4 % - 8 % 。
  15. Dawn came glassy orange, stained from below by a gelatinous band of pale green

    天邊是耀眼的橙紅色曙光，下面點綴著一條凝膠狀的淡綠色帶子。
  16. In this work, zno thin films were prepared by sol - gel method on the glass substrate in order to study the influence of the preparation techniques on the crystallization, orientation and morphology of the films. we adopted a two - step heat treatment technique to optimize the micrcjstructure of the films, and subsequently discussed the forming process of the zno thin films

    本論文研究了在載波片和si （ 001 ）上溶膠凝膠旋塗法的制備工藝對薄膜的結晶、取向狀況以及薄膜形貌的影響，探討了溶膠凝膠旋塗法制備的氧化鋅薄膜的形成過程，同時引入兩步熱處理方法來優化薄膜的結構。
  17. Abstract : the technical characteristics, research status and recent progress in preparing nanometer particles by liquid - phase synthesis including precipitation, solvent evapration, hydrothermal, sol - gel and microemulsion technigues have been reviewed in the paper

    文摘:論述了目前常用的液相合成技術（包括沉澱法、溶劑蒸發法、水熱法、溶膠-凝膠法和微乳液法）制備納米顆粒的技術特點、研究現狀及其進展。
  18. Thermosetting powder paints. determination of the gel time at a given temperature

    熱固性粉末狀塗料.在給定的溫度下膠凝時間的測定
  19. The sanitary napkin with high effective gel layer can congeal the infiltrating liquid to jelly, not flow back after pressing, and you won ' t feel sticky on the surface

    內含高效膠化層的衛生巾，可把滲入的液體凝結成?喱狀，受壓后不回滲，表面沒有粘乎乎的感覺。
  20. The samples were characterized contrastively by sem, tem, saed, positron annihilate and the different mechanism for two methods were preliminarily discussed. the experimental results showed that nano - cuo prepared by sol - gel method was spherical, which was agglomerated badly and can aging easily. however, nano - cuo prepared by pressure - hydrothermal method has loose and thin - piece appearance structure

    結果表明，溶膠-凝膠法制得的氧化銅粉末呈類球形，團聚嚴重，易老化；而壓力-熱液法制得的氧化銅具有疏鬆的、薄片狀的外觀結構，粒子厚度約為20nm ，分散性較好、抗老化能力強；壓力-熱液法制備的氧化銅比溶膠-凝膠法制備的氧化銅缺陷濃度小。
分享友人
分享到 Line

分享到臉書