膠合性的 的英文怎麼說

中文拼音 [jiāogěxìngde]
膠合性的 英文
agglutinative
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 的 : 4次方是 The fourth power of 2 is direction
  1. The lightning impulse breakdown and steep - front impulse breakdown test of silicone rubber are also performed, which give a reference for other so lid materials. the result of this research also will give a reference to revises the standard of steep - front wave impulse voltage test

    為了配合本課題的研究還做了硅橡膠材料的雷電沖擊耐受強度和陡波沖擊耐受強度試驗，這兩個試驗對了解其它固體材料的雷電沖擊系數和伏秒特性也具有參考價值。
  2. Methods of testing plastics - chemical properties - determination of butyl rubber content of low density polyethylene compounds

    塑料的試驗方法.化學性能.低密度聚乙烯化合物中丁基橡膠含量的測定
  3. Its mechanism is to reduce the surface tension of solution, to enhance the efficiency of nebulization, to generate glue group of chemical combination and to concentrate molybdenum by surfactant

    其機理是溶液表面張力的降低、霧化效率的提高、膠團化合物的形成及表面活性劑對鉬的富集作用。
  4. Many methods are used to improve properties and performance of emulsion adhesives, including changing proportion of monomers or initiator system, improving emulsion polymerization, mixing or chemical combination with other polymers

    討論了通過改變單體組成或引發體系、改進聚合工藝、通過共混或化學結合引人其他聚合物的方式改進乳液型膠粘劑性能的方法。
  5. Clinical study of ganshao capsule in treating clomiphene - resistant polycystic ovarian syndrome

    甘芍膠囊治療耐克羅米芬性多囊卵巢綜合征的臨床研究
  6. Study on gelation character of pvc with high degree of polymerization

    高聚合度聚氯乙烯凝膠特性的研究
  7. Standard test methods for measuring adhesion by tape test

    膠帶試驗用測定粘合性的標準試驗方法
  8. Self adhesive tapes. measurement of bonding of thermosetting adhesive tapes after curing

    自粘帶.固化后熱固性膠粘帶粘合性的測試
  9. The experimental results indicated that the tea waste powder as an additive to uf resin could reduce its free formaldehyde content and reduce the formaldehyde emission of uf resin bonded plywood ; the tea waste powder with much less size was easily mixed with uf resin and acted much more effective ; the tea waste as an additive to uf resin in a proper amount did nut decrease the bond strength of plywood

    實驗結果表明，茶葉廢料作為填料添加到脲醛樹脂膠黏劑中，能夠降低其游離甲醛含量以及其黏接膠合板的甲醛釋放量；茶葉廢料顆粒度越小，與脲醛樹脂混合性越好，消除甲醛效果越顯著；茶葉廢料的適量加入不會降低膠合板膠合強度。
  10. Standard test method for adhesion of pressure - sensitive tape to fiberboard at 90 angle and constant stress

    在90角度和恆定應力下纖維板上壓敏膠紙帶粘合性的標準試驗方法
  11. Its registered capital is rmb 5 hundred thousand. the company is a leading one that engages in business and trade of goods

    位於中國膠東半島美麗的繽海城市-煙臺，屬物資綜合性的大型商貿流通企業。
  12. Building construction - jointing products - determination of adhesion cohesion properties of sealants after exposure to heat, water and artificial light through glass

    房屋建築.連接件.受熱水和透過玻璃的人造光照射后密封膠的粘合性的測定
  13. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它的研究，往往只考慮棱鏡膠合層的兩切割斜面上的主透射光束，至多同時考慮次級透射光束對出射光強的影響，或直接將光束光強透射比的實驗值的平均結果作為棱鏡的一個性能指標給出，很少考慮棱鏡膠合層間光束的多次反射對輸出光強的影響以及結構誤差和使用調整誤差對棱鏡光強分佈的影響。
  14. But during the construction of high - grade highway, our highway departments have concentrated on the capacity of pitch mixtures and ignored the capacity of the rock materials. the small scale, clutter kinds, high cost and different quality of rock material production lead to the large gap between the standard of our pitch pavement and foreign modern standard

    但在高等級公路的建設過程中，我們的公路部門大都將注意力集中於瀝青膠合料的性能上，往往忽視了礦料的性能，加上石材生產規模性差、品種雜、成本高、質量參差不齊等問題，使得我國瀝青路面的建設水平與國外先進水平相比差距較大。
  15. Standard test methods for rubber property - brittleness point of flexible polymers and coated fabrics

    橡膠特性的標準試驗方法.撓性聚合物和塗層織物的脆化點
  16. Testing of plywood ; determination of modulus of elasticity in tension and of tensile strength

    膠合板的檢驗.拉伸-彈性模數和抗拉強度的測定
  17. The curing time of the modified pf resin and the adhesive strength and emission of formaldehyde of the plywood bonded with this modified pf resin was measured in this paper

    結果表明:紫膠改性酚醛膠的固化時間與普通酚醛膠接近，粘接膠合板的粘接強度達到類膠合板的要求，膠合板的甲醛釋放量降低。
  18. Abstract : through copolycondensation method, a phenol - melamine - urea - formaldehyde resin was prepared. the discussion was concentrated on the preparation method of the resin and it ' s application condition in pressing exterior - type medium density fiberboard

    文摘:通過共縮聚的方法，制備了具有良好的耐水性能和膠合性能的苯酚-三聚氰胺-尿素-甲醛樹脂。著重討論了該樹脂的制備方法以及在壓制室外型中密度纖維板中的應用情況。
  19. Standard test method for rubber property - measurement of the viscous and elastic behavior of unvulcanized raw rubbers and rubber compounds by compression between parallel plates

    通過平行板之間壓力測定橡膠化合物和非含硫生橡膠黏性和彈性的橡膠特性的標準試驗方法
  20. " determination of the bond behaviour between reinforcing bars and autoclaved aerated concrete by the " push - out " test. "

    "推出"試驗法測定鋼筋和高壓蒸養加氣混凝土間的膠合性能
分享友人
分享到 Line

分享到臉書