膠體顆粒 的英文怎麼說

中文拼音 [jiāotǐkēlì]
膠體顆粒 英文
colloid particle
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 體 : 體構詞成分。
  • 粒 : Ⅰ名 （小圓珠形或小碎塊形物） small particles; grain; granule; pellet Ⅱ量詞（用於粒狀物）
  • 顆粒 : 1 （小而圓的東西） pellet; bead; dust; anything small and roundish （as a bean pearl etc ）2 （一...
  1. But in the forepassed research, the people all abstracted the colloid in the water as the sphericity and explained it by the known theory of the colloid chemistry. moreover some people modified the result by the grain coefficient in the derivation of theory. but this assume had more difference on the observed phenomena in the experiment, so it was not perfect in theoretical speaking

    關于絮凝的理論基礎在國外研究得比較多，但在過去的研究中，人們大都是將水中的膠體顆粒抽象為球形，用已有的膠體化學理論去加以解釋，並在理論推導中引入顆粒系數加以修正，這與實際實驗所觀察到的現象有較大的差別，從理論上說，是很不完善的。
  2. Viruses are colloidal particles.

    病毒呈膠體顆粒。
  3. The flocculation morphology is an advanced subject that researchs flocculation processes from the reality sha pe and size of the colloid and the flocculating agent in the water, according to the reality structure of flocks

    混凝形態學就是從水中膠體顆粒和所加混凝劑在水中的真實形狀和大小，以及由它們形成的絮凝體真實結構出發來研究整個混凝過程的一門較高層次的學科。
  4. The porous ceramics is composed of lots of bridge arch - shaped microspores that connected and well - distributed inside the material. when the fluid passes through these pores, the suspended matters, colloid particles and big molecular organic substances are withheld or absorbed to the inner surface of the pore, and result in filtration, purification adn even - dispersion, high strength, good resistance to abrasion, high temperature and corrosion, no pollution, long workinglife, and easy to regenerate, the porous ceramics are available for filtration and fluidization of variou gas and liquid

    微孔陶瓷過濾介質由許多大小分佈均勻，相互連通的橋拱狀開口氣孔組成.當流體從這些氣孔中通過時，流體中的懸浮物質，膠體顆粒，大分子有機物等被截留，吸附在微孔道內，從而達到了凈化和過濾均勻化的效果.微孔陶瓷強度高，耐磨損，耐高溫，耐腐蝕，無污染，氣孔分佈均勻，使用壽命長且再生簡便，特別適用於各種氣，液過濾和流態化過程
  5. Protective clothing for use against solid particulates - test method of determination of inward leakage of aerosols of fine particles into suits

    防固體顆粒用防護服.測定細粒氣溶膠向服裝內滲漏量的試驗方法
  6. Protective clothing for use against solid particulates - part 2 : test method of determination of inward leakage of aerosols of fine particles into suits

    防固體顆粒用防護服.第2部分:測定細粒氣溶膠向服裝內滲漏量的試驗方法
  7. Strong interaction of identical plates colloidal particles with surface high potential

    等同的平板型高電位膠體顆粒的強相互作用
  8. The urea - formaldehyde ( uf ) polymer / sio2 composite microspheres were prepared by polymerization - induced colloid aggregation ( pica ) method. the formation mechanism of composite microspheres is attributed to the fact that that urea and formaldehyde firstly undergo acid - catalyzed polymerization to form oligomers, and then the sol particles are adsorbed on the chain of oligomers by wan der walls force and hydrogen bonding. when the oligomers reach the critical chain length, they separate from solution due to phase separation

    對復合微球形成機理的研究表明，尿素和甲醛在酸性條件下自身聚合可以形成高分子微球，在sio _ 2酸性溶膠中發生聚和反應時，隨著反應的進行，齊聚物不斷生成， sio _ 2膠體顆粒逐漸吸附在齊聚物分子鏈上，當聚合物鏈達到沉澱臨界鏈長時，由於相分離作用，從前驅物溶液中析出，同時sio _ 2膠體顆粒均勻的分佈在脲醛聚合物網路中，隨之沉澱出來，形成脲醛sio _ 2復合微球。
  9. In this paper, to investigate the coagulation process of inorganic suspended particles ( isp ), online monitoring of the coagulation process was conducted by using pda2000. the process of floe formation and the morphological characteristics of floes were investigated in detail through tv - microscope. the mechanism of partical collision and coagulation kinetics were preliminary discussed

    為了考察無機懸浮顆粒體系的混凝過程，研究絮凝體的構造特徵，本文通過pda2000對無機懸浮體系的混凝進行光學在線監測，運用電視顯微攝像儀對絮凝體的形成過程及其形態學特性進行了系統的研究，對膠體顆粒碰撞機制及混凝動力學作了初步探討。
  10. Sometimes it is necessary to use two or three - dimensional medium to improve the entirety, the tensile and shear strength of the soil. geosynthetics meet these requirements quite well

    土本身是一種弱膠結顆粒的集合體，有時它需要一種二維或三維的連續介質去提高其整體性，改善其抗拉、抗剪性能。
  11. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  12. The output signal of pda is affected by the suspended particle concentration, particle size, and the type and dosage of coagulant as well. by analysing the fi curve, it is found that the characteristic parameters of fi curve closely relate to aggregates size and turbidity removal the aggregates size and turbidity removal achieve the maximum when the amplitude of fluctuation is the maximum. the mean diameter and fractal dimension increase with agitation time, and finally reach a steady - state

    通過對混凝過程的在線監測和對pda輸出信號fi曲線的數學解析表明： fi曲線綜合反映了懸濁液中膠體顆粒濃度和顆粒粒徑，混凝劑種類和投量很大程度上影響了fi曲線形狀， fi曲線的特徵值與絮凝體平均粒徑和濁度去除率之間具有良好的相關關系，在振幅最大處，濁度去除率達到最高，絮體平均粒徑最大，該條件下對應的投藥量為最佳投藥量。
  13. Rubber compounding ingredients - carbon black - determination of individual pellet crushing strength

    橡膠配合劑.炭黑.個體顆粒破碎強度的測定
  14. The porous structure is proved by observation with scan electron microscope. the aperture is 0. 13 - 2. 0 u m which can block off the solid particulate and suspension impurity

    溶膠凝膠法：其「微孔穴」結構，葉阻擋固體顆粒及懸浮雜質的于擾。
  15. A simple, but practical theoretical mode established in this paper is used to describe the < wp = 6 > dependence of the particles size on the reaction, where the experiment data of optical absorption have been employed in the model

    採用化學方法在常溫下成功地制備了zno膠體，顆粒尺寸在5nm以下。根據吸收譜實驗數據和建立的理論模型估價了膠體顆粒的大小與反應時間的關系。
  16. It ' s indicated that the zeta potential and total interaction energy of the colloidal particles are both at a maximum when the nitric acid concentration is 0. 22mol / l for the alumina sols with a mol ratio of 1 : 50 between asb and h2o,

    結果表明，膠體顆粒的雙電層厚度隨硝酸的濃度的增加不斷減小，對異丁醇鋁與水的摩爾比為1 ： 50系溶膠，硝酸濃度為0 . 22mol l時膠體顆粒的zeta電位和作用位能最大。
  17. It was found that the zeta potential and average size of the colloidal particles increase earlier and drop later with the addition of sec - buoh and both of them reach the maximal values which are 790nm and 20mv respectively when the mol ratio between sec - buoh and asb is 30

    結果表明，膠體顆粒的平均粒徑和zeta電位隨異丁醇的增加先升高後下降，當沉積時間為1h時，異丁醇asb為40時膜的厚度最佳。
  18. There are certain theory and practical application for the conclusion developed in this paper. in the first place, the cognition is deepened about colloid flocculation. in the second place, it can be used to improve the coagulation process for sewage containing cationic surfactants

    本文對陽離子表面活性劑作用下膠體顆粒的混凝機理進行研究，對加深有關膠體絮凝理論的認識，優化陽離子表面活性劑微污染情況下絮凝工藝具有重要意義。
  19. And the quality control system was developed for ddmbac. the coagulating property of ddmbac was discussed and the interaction model between ddmbac and colloidal particles was developed. the influence of ddmbac on coagulation using aluminum sulfate ( as ) or polyaluminum chloride ( pac ) was also investigated based on analytical method and interaction model

    本文探討了ddmbac對高嶺土顆粒的混凝除濁性能，提出了ddmbac與膠體顆粒間的相互作用機理模型;在已有的研究成果基礎上，分析研究了不同混凝條件下ddmbac對硫酸鋁、聚合氯化鋁混凝效果的影響規律和機理。
  20. 1 " protective clothing against liquid and gaseous chemicals, including liquid aerosols and solid particles - part 2 : performance requirements for " gas - tight " type 1 chemical protective suits for emergency teams "

    防液體和氣體化學製品包括液體氣溶膠和固體顆粒的防護服.第2部分:急救隊用氣密性
分享友人
分享到 Line

分享到臉書