自動切換開關 的英文怎麼說

中文拼音 [zìdòngqiēhuànkāiguān]
自動切換開關 英文
automatic changeover switch
  • 自 : Ⅰ代詞（自己） self; oneself; one s own Ⅱ副詞（自然;當然） certainly; of course; naturally; willin...
  • 切 : 切Ⅰ動詞1 （合; 符合） correspond to; be close to 2 （用在反切后頭 表示前兩個字是注音用的反切）見 ...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  • 自動 : 1 （自己主動） voluntarily; of one s own accord 2 （不憑借人為的力量） automatic; spontaneous 3 ...
  1. Manufacturer of ce certified pilot lamps, push button switches, selector switches, cam switches, and terminal blocks

    -生產智能控制器，自動轉換開關器，機電連鎖裝置，智能雙電源自動切換開關產品。
  2. The core products include telecom power systems, board mounted power supplies, custom power supplies, ups, precision air conditionings, outdoor shelter solutions, automatic transfer systems, network power protection products, vrla batteries, lv & precision distribution cabinets, centralized power and environment monitoring systems, dc power systems and ac motor drive inverters used in electric utility power systems

    艾默生網路能源產品涉及通信電源、印刷板板裝電源、客戶定製電源、 ups 、機房專用精密空調、戶外一體化通信機櫃、自動切換開關、動力網路保護產品、蓄電池、低壓配電和精密配電櫃、動力設備及環境監控系統、電力操作電源、交流變頻調速器等領域。
  3. Rational control of the pump ' s work and rest time is the key to solve the problem of void pumping. this essay gives theoretical analysis and cost comparison of every detective method, considers power detection as the most effective method, and puts forward several ways of power consumption and effectiveness power consumption at the same time. the designed electricity saving controller integrate all the above four methods, and it can work with different methods by switch between automatic and manual to broaden its accommodation

    解決油井空抽現象的關鍵是合理控制開機時間與停機時間長度，本文對各種檢測方法進行了理論分析及成本比較，認為功率檢測最行之有效，同時提出了功率檢測的幾種實現方法，即瞬時功率法、人工電耗法、設定功耗法及效益功耗法，所設計的節電控制器集以上四種方法於一身，可通過自動手動切換採取不同的功率檢測方法，使其適應范圍增寬。
  4. Toggles autoattack on / off, just like " a " key

    切換自動攻擊模式開或關，預設是按" a "鍵。
  5. For ballasts with rest mode facility changeover from rest mode to normal mode shall occur automatically at greater than 0. 9 times the off cycle extended to 3 s and the ballast put into the rest mode after 2 s of the off periods in the 500 switching cycles

    帶有休止狀態裝置的自容式應急燈具，從休止向正常狀態的轉換應在不大於0 . 9倍額定電壓下自動運行3秒，在500次開關周期結束切斷電源的2秒時間內應使自容式燈具進入休止狀態。
  6. Low - voltage switchgear and controlgear - part 6 - 1 : multiple function equipment ; automatic transfer switching equipment

    低壓開關設備和控制設備.第6 - 1部分:多功能設備.自動轉接切換設備
  7. The system solves the problem that one device can control many parameters testing. it can complete auto - test and auto - data - collection of acting time difference between the 8 contract resistances and 6 switches without debugging the power by hand. serial communication program can automatically transmit the testing data and information to the upper computer after the data testing

    機車電器測試系統解決了一臺裝置進行多項參數測試的計算機控制問題，能進行8路接觸電阻、 6路開關的動作時間的自動測試、通道的自動切換及數據採集；並無須人工調試電源；串口通信程序在測試完畢后自動向上級計算機傳輸測試數據和信息交換。
  8. Automatic changeover switch

    自動切換開關
  9. During unit startup and load is lower than 15 %, drum level is controlled by feedwater control valve, feedwater pump remains at minimum safety speed ; when load is between 15 % and 25 %, feedwater control valve is closing at fixed speed determined by function module, main motor - operated - valve is opened automatically, control mode of drum level is transferred to feedwater pump automatically and bumplessly ; when load is between 25 % and 50 %, control valve is closed fully, and main motor - operated - valve is open fully, drum level is controlled by one pump ; when load is more than 50 %, first pump is kept in operation, second pump is putting into operation automatically and

    在機組啟動、沖轉及機組並網至15 %負荷階段，給水泵維持在最低安全轉速下運行，汽包水位由低負荷給水調節閥自動控制; 15 %至25 %負荷階段，給水調節閥由函數模塊按照一定的速率自動平滑關閉，主給水電動門自動打開，汽包水位控制方式自動無擾切換為給水泵自動控制;負荷在25 %至50 %階段時，給水調節閥已完全關閉，主給水電動門已完全打開，水位控制已全由單臺給水泵承擔;負荷大於50 %后，在第一臺給水泵運行的同時，第二臺給水泵自動無擾投入。
  10. The study shows that this control approach can overcome those shortages of the methods which are adopted to control voltage and reactive power in substation nowadays, it can hold the voltage level in the regular bound and maintain the balance of reactive power in substation to the greatest extent, and it have the ability to seek the best solution. adopting this methods, the switching times of loaded taps and capacitors can be decreased efficiently and advance the running life - span of the transformer and capacitors and improve the economy benefits. this control approach is a advanced way ii and it is worth to study more and utilize

    利用模糊神經網路對較好地實現對變電站的電壓、無功自動控制，能克服了目前在變電站電壓無功控制中普遍運用的分區方法存在的不足之處，不但可保持變電站電壓在合格的范圍內，盡量維持無功功率平衡，而且具有較好的尋優能力，有效減少變壓器有載調壓開關的切換次數和電容器組的投切次數，提高了變壓器和電容器的運行壽命，提高了經濟效益，是一種值得進一步探索和運用的較為先進的方法。
  11. Once you have selected the option that enables outlining mode in your development language, commands become available from the shortcut menu of the code editor that will expand and collapse selected sections, expand and collapse all definitions, expand and collapse every collapsible section, and toggle automatic outlining off and on

    在開發語言中選擇啟用大綱顯示模式的選項后，您便可以使用代碼編輯器快捷菜單中的命令進行以下操作：展開和折疊選定的部分、展開和折疊所有定義、展開和折疊每一個可折疊的部分、在自動大綱顯示的開和關之間進行切換。
  12. Double switching power supply, be capable of automatic power switching

    雙開關電源，具備電源自動切換功能
  13. Automatic transfer switch

    自動切換開關
  14. ( 4 ) the adaptive reconfiguration control with its application in the fault detection of flight control systems is researched by simulation. we design a automatic switch in the system, which make the system switch to the adaptive reconfiguration control automatically when faults occur. and when the system is without faults, the adaptive reconfiguration control is not added, which simplifies the system in very great degree

    （ 4 ）對自適應重構控制在飛行控制系統故障檢測中的應用進行了模擬研究，在系統中設計了一個自動切換開關，使系統發生故障后能自動切換到自適應重構控制，而當系統沒有故障時不加入自適應重構控制，在很大程度上降低了整個系統的復雜性。
分享友人
分享到 Line

分享到臉書