芯體 的英文怎麼說

中文拼音 [xīntǐ]
芯體 英文
core
  • 芯 : 芯名詞1. （物體或器物的中心部分） core 2. （蛇的舌頭） snake's tongue
  • 體 : 體構詞成分。
  1. After 20 days at 450 or 1 day at 500, the u3si2 particles cracked and fragmented, there were a lot of cracks in al - matrix and reacted areas, there were also a lot of holes in the meat. the meat lost its continuity and perfection, and departed from clad. above 450 the volume fraction of the al - matrix and the u3si2 decreased and produced u ( al, si ) 3 in the meat, u3si2 particles invaded to clad

    在450熱循環20天後、 500熱循環1天後，燃料板的厚度變化一般0 . 04mm ，燃料板的翹曲現象嚴重； u _ 3si _ 2顆粒開裂及破碎，基體中產生大量的裂縫，反應層也存在大量的裂紋及孔洞，芯體已失去連續性、完整性，並且與包殼脫開。
  2. In - core temperature or primary envelope temperature measurements in nuclear power reactors. characteristics and test methods

    核動力反應堆中燃料芯體溫度或主包殼溫度測量.特性和試驗方法
  3. This product is a full electron construction in which its front - end adopts pressure sensor with baffle filled oil chip. output signal is sent the data to microprocessor from high - precision, low temperature drift and high - reliability amplification circuit and a d convert circuit, after operating, to transform by high - precision d a convert circuit into standard signal output

    該產品為全電子結構，前端採用帶隔離膜充油芯體的壓力傳感器，輸出信號由高精度低溫漂和高可靠性的放大電路和模數轉換電路將數據送入微處理器，經運算後由高精度數模轉換電路變換為標準信號輸出。
  4. I learned about serif and san serif typefaces, about varying the amount of space between different letter combinations, about what makes great typography great

    我學習細體和燈芯體，學習在字母組合之間變換著間距，學習優美字體之所以優美的原因。
  5. Attention is focused on the design and matching of heat exchangers

    通過計算機程序計算實現了換熱器芯體的匹配選擇。
  6. Core size 520 160 65

    芯體尺寸
  7. Core size 560 280 75

    芯體尺寸
  8. Core size 450 300 76

    芯體尺寸
  9. Core size 510 245 70

    芯體尺寸
  10. Core size 500 300 90

    芯體尺寸
  11. Core size 700 300 76

    芯體尺寸
  12. Cores made of soft magnetic materials - measuring methods - part 1 : generic specification

    軟磁性材料制芯體.測量方法.第1部分:總規范
  13. So the fabrication quality of fuel element plate should be controlled strictly

    燃料元件板的質量須嚴格控制，芯體燃料外露是很危險的。
  14. Standard practice for adhesive bonding of aluminum facings to nonmetallic honeycomb core for shelter panels

    保護板用非金屬蜂窩狀芯體鋁蓋面的粘合劑粘結標準規程
  15. It makes transportation system simple and transportation efficiency high. the cost of equipment and transportation is much lower than ordinary belt conveyor

    使運輸系統簡化、運輸效率高，設備成本、運輸成本遠遠低於一般織物芯體的膠帶。
  16. Conventionally the power capacitors were manufactured the way their wound cores should be heated and dried in a vacuum drying vessel first, and the cores should be pressed into capacitor shells, then all the unfinished capacitors were put into a vacuum pressure tank for inpregnation

    摘要傳統的電力電容器的生產工藝是將芯體元件卷繞后，先在真空乾燥罐內進行加熱和真空乾燥，然後將芯體元件壓裝到電容器殼內，再在另一臺真空壓力浸漬罐內進行真空壓力浸漬。
  17. Chaoli adopts 5s, jit to realize lean manufacturing and set up perfect production control system and organization system. we import top - ranking manufacturing and testing equipments from japan, south korea, us such as evaporator with inner fin production line, condenser production line, hvac production line, heater production line, bus a c production line, automatic a c controller, so that the production capacity is 600, 000 units per year along with sub - assemblies and parts

    超力高科從日本韓國美國等國家引進世界一流的生產設備和在線檢測設備與製造技術，擁有帶內翅片蒸發器芯體總成生產線冷凝器芯體總成生產線hvac總成生產線散熱器芯體生產線客車空調生產線自動空調控制器生產線，形成年產60萬套汽車空調系統的生產能力，可為用戶提供各種汽車空調系統分總成零部件。
  18. It has the same working principle as the ordinary belt conveyor. its belt is made of steel rope inside and rubber outside. therefore it has very high strength, large capacity and realizing long distance transportation

    鋼繩芯帶式輸送機是50年代興起的新型運輸工具，其工作原理與普通膠帶輸送機相同，它的膠帶用鋼繩代替帆布作芯體，外加橡膠?蓋層而製成，所以有很高的強度，能夠實現單機大運量、長距離運輸。
  19. After 60 days at 160, 250, 350 and 400, u3si2 particles are compact with al - matrix, the meat did not crack and there were no phase change. fuel meat and clad binded tightly, no crack was found at the boundary of the meat and clad

    從微觀觀察發現， u _ 3si _ 2顆粒與al基體結合緊密，沒有碎化，芯體沒有開裂，並且與包殼的結合處沒有脫開及發現裂縫，芯體中也沒有發生相變化，未發生鈾硅顆粒向包殼侵入的現象。
  20. No u3si2 particles invaded to clad and the clad did not become thinner ( > 0. 3mm ). the fuel meat exposing to air at 160 and 250 did not affect the thermal performance considerably, but at 350 and 400, u3si2 particles fragmented, the meat cracked, u3si2 particles invaded to clad and the clad became thinner ( < 0. 2mm )

    芯體暴露在160 、 250較低溫度下對包殼及芯體的性能均沒有顯著影響；但芯體暴露的金相預制試樣， 350 、 400熱循環60天後， u _ 3si _ 2顆粒的碎化現象嚴重， al基體中有大量裂縫及裂紋，嚴重時芯體已經裂開。
分享友人
分享到 Line

分享到臉書