苯乙定 的英文怎麼說

中文拼音 [běndìng]
苯乙定 英文
phenetidine
  • : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
  1. Analytical condition were as follows, column : 10 % modified polyethylene glycol 20m on acid washed 201, 2m column with 3 mm i. d., fid as detector, phe - nylmethyl ketone as internal standard compound

    以10 %改性聚二醇20m為固液,酮為內標物,氫火焰離子化檢測器,內標法量分析異辛酸。
  2. The results suggested that the ph value, the type of monomers, the type, concentration and surface properties of inorganic nanoparticles, the type and concentration of emulsifier have a great influence on the encapsulating emulsion polymerization and the obtained latex stability. if selecting cationic emulsifier ( ctab ), low water soluble monomers ( such as ba, st ) and hydrophobic nano - silica, the inorganic nanoparticles would be encapsulated by polymers through ultrasonic irradiation successfully under alkalescent condition

    系統研究了ba 、甲基丙烯酸甲酯( mmal烯舊t )以及它們的共聚體系在超聲輻照作用下包裹聚合的主要影響因素,結果表明: ph值、單體的種類、無機納米粒子的種類、濃度及表面性能、乳化劑的種類及濃度等對超聲輻照包裹乳液聚合以及復合體系的穩性有較大的影響。
  3. Phenolic foam is a new generation heat preservation prevent fire soundproof material and polystyrene together ammonia ester foaming rubber etc, material to compare, and it is good that its biggest characteristics is a heat - proofound the low temperature contractility is smatt, and have te special prevent burning wit the size stability under 2000 heat, not burning, not melt not contract constant form not poisonous spirit hove no thick smoke, just surface formation layer

    信息內容:酚醛泡沫為新一代保溫防火隔音材料與聚烯聚氨脂發泡橡膠比,其最大特點是耐熱性好,低溫收縮性小,具有獨特的阻燃和尺寸穩性,在焊槍火焰下,不燃燒不收縮不變形,無毒氣無濃煙,只是表面炭化,性質穩,耐化學腐蝕抗老化。
  4. We have calculated one - and two - photon absorption cross sections of the lowest excited states of a series of molecules combined with benzene, stilben, thiophene as center attached with amine, diphenylamine, diethylamine as electron - donor and nitryl as electron - acceptor ; the effects of molecular length, n center and electron - donor on two - photon absorption cross sections have been studied and all calculations have been carried out using the density functional theory at an ab initio level. it is found that the molecular length and the one - photon absorption intensity are quite strongly c orrelated factors, and that a corresponding correlation for the two - photon absorption is decreasing. it is also found that a most crucial role for the two - photon absorption is played by the n center

    我們分別以、二烯、噻吩為中心,氨基、二氨基和二氨基為電子給體,硝基為電子受體組合形成的分子為研究對象,在從頭計算的水平上用密度泛函理論計算了這些分子在低激發態下的單、雙光子吸收強度,重點研究了分子的長度、中心和給體的供電子能力對分子單、雙光子吸收的影響。研究結果表明,分子長度與單光子吸收強度之間有密切關系,而在雙光子吸收中這種關系較弱;中心在雙光子吸收中具有重要的作用;在中心和受體一的情況下,增加給體的供電子能力,可提高雙光子吸收強度。
  5. Three water - soluble acrylic resins are prepa red by polymerizing esters acrylate, acrylic acid , methylacrylic acid , esters methylacrylate with phenyl - ethene or ethylene acetate in present of water or alcohol and initiating agent. properties of the acrylic resins are characterized. results show that the resins possess excellent character, i. e. adhibity, water - solubility, expansion after dry for water , anti acidity or bascity and brightness in the products of same type

    以丙烯酸、丙烯酸酯、甲基丙烯酸、甲基丙烯酸酯等作為基料,在引發劑的存在下,以水或醇作溶劑進行聚合,加入烯、醋酸烯等改性,合成了3種不同的水溶性丙烯酸改性樹脂,並對其性能進行了測.結果表明:這3種樹脂的粘度、水溶解性、乾燥后膜的吸脹性、抗酸堿性、光亮度等性能均優于同類產品
  6. According to these the quantitative analysis for product citronellol is carried out by gc with fid ( fire iron detector ) as detector using hypnone as an internal standard

    採用標準圖譜比較和添加產物標準品對照的方法進行性分析;確立了酮為內標物和用內標法進行量分析的方法。
  7. Rubber - analysis by pyrolytic gas - chromatographic methods - determination of styrene butadiene isoprene ratio

    橡膠.熱解氣相色譜法分析.烯丁二烯異戊二烯烯比率的測
  8. The article analyze the concrete drying shrinkage mechanism, find the major factors of affecting the drying shrinkage, analyze the lack of shrinkage reducing agent, who be of low molecular weight and line chain, design a new shrinkage reducing agent ? ? shrinkage reducing agent of poly - acrylate. the shrinkage reducing agent of poly - acrylate is mainly composed of crylic acid 、 cinnamene 、 poly - glycol 、 solicitating agent 、 chain transferring agent and activator, which come by these processes of polymerization 、 esterifing and neutralization to form a pectinate polymer, which have a high molecular weight and many poly - oxidative alkenes

    論文分析了混凝土乾燥收縮的機理,確了影響乾燥收縮的關鍵因素,分析已有低分子量的、直鏈型減縮劑的不足,設計了一種新型的減縮劑? ?聚丙烯酸鹽類減縮劑,其主要由丙烯酸、烯、聚二醇、引發劑、鏈轉移劑、催化劑等經過聚合、酯化和中和反應,生成一種高分子量的、含聚氧化烯鏈的聚合物。
  9. The sensor exhibits a linear response to c3 in the concentration range 6. 5ng / ml to 75ng / ml, correlation coefficient 0. 973. 4 ) a novel enzyme - link fluoroimmunoassay system using 2 - chloro - 10 - [ 3 - ( 4 - methyl - l - piperazinyl ) propyl ] 10h - phenothiazine ( prochlorperazine ) as substrate to determine the goat anti - igg was developed by using polystyrene ( ps ) as carrier. the hrp - labled goat anti - igg can catalyze the oxidation of prochlorperazine to cause the increasing of fluorescence

    4 )以聚烯( ps )製成史持體,通過疏水性非特異吸附將igg固在其表面,然後與gaigg和酶標gaigg進行競爭免疫反應,以雙氧水和甲哌氯丙嗪混合溶液為熒光底液,通過測395nm處熒光增強的多少來測gaigg的濃度,熒光響應與gaigg濃度在2n留ml到60n留ml之間呈準線性關系。
  10. Test method for rubber latex - styrene - butadiene copolymer - determination of residual styrene

    橡膠膠乳試驗方法.烯丁二烯共聚物.殘留烯的測
  11. 05. 01 butadiene dimer and styrene in butadiene concentrates by gas chromatography, method of test for

    用氣相色譜法測丁二烯濃縮物中丁二烯二聚物和烯的試驗方法
  12. Standard test method for butadiene dimer and styrene in butadiene concentrates by gas chromatography

    氣相色譜法測丁二烯濃縮物中丁二烯二聚物和烯的標準試驗方法
  13. We selected styrene as monomer, diethylene glycol dimethacrylate as cross - linking agent. the copolymerization technique was used in preparing the probe. the ph fluorescent indicator was immobilized in the probe as the sensitive element

    我們選擇烯為聚合單體,雙甲基丙烯酸一縮二二醇酯為交聯劑,採用交聯共聚技術制備氨多孔塑料傳感探頭,並將ph熒光指示劑固於共聚體中作為氨的敏感元素。
  14. Determination of molecular weight averages and molecular weight distribution of polystyrene standards by steric exclusion chromatography

    體積排斥色譜法測烯標準樣品的平均分子量及分子量分佈
  15. Three methods for synthesis of mandelic acid were introduced in the article, and their advantages and disadvantages were compared. the method of mandelic acid synthesis using hypnone was selected, and flow chart and operation process were studied

    本文對扁桃酸常用的三種合成方法進行了介紹,對其工業化生產的優缺點進行了對比,最終選酮法,並給出了工藝流程圖和操作步驟。
  16. China university of science and technology li yin - mei group, proposed to dark field microscopy observation of light scattering technology and optical tweezers capture the idea of combining the traditional optical microscope optical tweezers system from the side of a bouquet of flake coupling laser irradiation samples, laser incident in a specific location, so that samples of the particles scattered light through the microscope imaging ; overcome the well - optical tweezers and microscopic imaging of laser irradiation, as well as strictly coincidence of the three key technologies to achieve the optical tweezers capture 100 nanometer - styrene ball at the same time also in the entire field of view of microscopic observation of nano - particles, to capture optical tweezers nanoparticles can also observation purposes

    中國科學技術大學李銀妹課題組,提出將暗場顯微術觀察光散射的技術與光鑷捕獲相結合的設想,在傳統光學顯微鏡光鑷系統上從側面耦合一束片狀激光照射樣品,在特的激光入射位置,使樣品中粒子的散射光可通過顯微鏡成像;克服光鑷的阱位與顯微成像面以及激光照射面三者嚴格重合的技術關鍵,實現了光鑷捕獲100納米聚烯小球的同時也能在整個顯微視場中觀察納米粒子,達到了光鑷捕獲納米粒子的同時也能觀測的目的。
  17. Polystyren composite wood wool slabs. definition. designation

    烯復合木絲板.義.命名
  18. Standard test method for colorimetric determination of p - tert - butylcatechol in styrene monomer or ams alpha - methylstyrene by spectrophotometry

    用分光光度法對烯單體或ams中一叔丁基鄰二酚比色測的標準試驗方法
  19. Abstract : unsaturated polyester with low shrinkage composied of anti - shrinking agent, thermoplastics, dispersion - stabilizer, a kind of graft copolymer made from styrene and saturated polyester, shaped like a comb for its molecular structure and upr in certain structure and some factors effecting on low shrinkage were introduced in this paper

    文摘:研究了當用熱塑性樹脂作為不飽和聚酯樹脂低收縮劑時,合成了以烯為主鏈,聚酯為枝鏈的梳狀接枝共聚物,作低收縮劑的分散穩劑,配合相應組成的不飽和聚酯樹脂得到了具有低收縮特性的不飽和聚酯組成物。
  20. The membrane properties were found to be dependent upon the content of styrene. the membrane physic - chemical properties compare to nafion 117 except that their chemical stability has to be further improved to make them acceptable for practical use in the proton exchange membrane fuel cell. the proton transport through the membrane follows the " liquid - like " proton conductivity mechanism y and the water balance is important for the working condition of the fuel cell

    對磺化膜的研究分析表明:膜的性能參數如離子交換容量、吸水率、水合系數、形體穩性、導電性能、化學與熱穩性等依賴于膜中烯含量,且接枝烯相互間的位阻效應對膜性能影響很大;膜的性能可與nafion膜相比較;質子在膜中的傳導遵循「似液體」質子傳導機理;電滲析與擴散作用使膜保持水平衡。
分享友人