萃取處理 的英文怎麼說

中文拼音 [cuìchǔ]
萃取處理 英文
extraction treatment
  • : Ⅰ動詞[書面語] (聚集) come together; assemble Ⅱ名詞1 [書面語] (聚在一起的人或事物) a gathering...
  • : Ⅰ動詞1 (拿到身邊) take; get; fetch 2 (得到; 招致) aim at; seek 3 (採取; 選取) adopt; assume...
  • : 處名詞1 (地方) place 2 (方面; 某一點) part; point 3 (機關或機關里一個部門) department; offi...
  • : Ⅰ名詞1 (物質組織的條紋) texture; grain (in wood skin etc ) 2 (道理;事理) reason; logic; tru...
  • 萃取 : [化學] extract; extraction
  1. Study on decontamination of solvent extraction ' s wastewater in tungsten hydro - metallurgy by potassium ferrate

    高鐵酸鉀鎢濕法冶金廢液的研究
  2. With the aqueous phase velocity increasing, the mass transfer flux increased, but the recovery extraction decreased

    由回收率的大小可以看出,電泳分離技術是一種很好的染料水的方法。
  3. In order to study the influence factors of aoa of rose flowers, the effects of drying and extraction methods on the aoa of rose flowers were investigated. the results indicated that drying after high - temperature short - time pretreatment was rather effective to maintain their aoa ; the aoa of water extracts was stronger when the temperature was raised from 25 to 100 ; by using orthogonal test, the optimum extraction conditions of rose flowers were : solvent - 75 % ethanol ; ratio of material and solven - 1 : 10 ; extraction times - three times with 24 h at one time, at the room temperature. the extracts obtained by 75 % ethanol were fractionatedly extracted with petroleum, diethyl ether, ethyl acetate and n - butanol in turn, and the various fractions " aoa were analyzed

    為了探討玫瑰花抗氧化活性的影響因子,比較了不同乾燥方法、提方法對其抗氧化活性的影響,發現:經短時高溫后再進行乾燥有利於較好地保持玫瑰花的抗氧化活性;以水作溶劑提時, 25 100范圍內水提液的抗氧化活性隨著溫度的升高而增強;通過正交實驗篩選得到常溫下玫瑰花抗氧化活性物質的最佳提方法為: 75乙醇為溶劑,液料比1 : 10 ,提3次,每次24h ; 75乙醇提物依次用石油醚、乙醚、乙酸乙酯、正丁醇等有機溶劑進行兩相分部,發現玫瑰花的抗氧化活性物質主要存在於乙酸乙酯部,說明玫瑰花抗氧化活性主要成分可能是單寧類、黃酮苷類和原花色素類化合物; 4
  4. Stir bar sorptive extraction ( sbse ), which was originally developed at the end of 1990s, is a kind of novel and solvent - free sample preparation technology with high sensitivity and reproducibility

    攪拌棒吸附是九十年代末發展起來的一種新型的樣品前技術,具有靈敏度高、重現性好、不使用有機溶劑等優點。
  5. The omt after its suspension treated with ultrasonic wave was inserted with poly ( styrene - butyl acrylate ) emulsion. xrd test found the layers of omt particles were dispersed partly in the composite ; extraction experiment of nano - omt / pba - st composite indicated a great amount of macromolecule has inserted into the interlayer of omt. dta analysis showed the decompose temperature of composite has improved by 73 at 4 % omt

    將omt的水懸浮液經超聲波,與苯丙乳液復合, omt p ( ba - st )復合物的和xrd試驗證明乳液的大分子已經大量嵌入omt層間,使大部分omt以納米級均勻分散於苯丙乳液之中; dta分析結果說明添加4 omt苯丙復合材料的分解溫度升高了73 。
  6. In the u. s. much of the desolventized crude oil is degummed at the extraction plant.

    在美國,多數脫溶原油,是在加工廠內進行脫膠
  7. A method was developed for the determination of free amino acids in tobacco of different areas ( yunnan, guizhou and henan ) and of different technological processes using reversed phase high performance liquid chromatography ( rp hplc )

    摘要選雲南、貴州、河南的經不同工藝生絲、薄板乾燥、高溫氣流乾燥的煙絲;採用微波協助技術進行樣品的前;經活化的陽離子交換柱進行純化,再用柱前衍生反相高效液相色譜的方法對其游離態氨基酸進行含量分析。
  8. By using liquid - liquid extraction and photochemical desulfurization process, the technology for photochemical degradation of sulfur compounds and kinetics of reaction was investigated

    摘要從液液光化學脫硫工藝入手,研究光化學反應降解含硫化合物技術並探討其動力學規律,同時還對光后的汽油烴族組成變化進行了考察。
  9. Bright stock refined, high viscosity lubricating oil usually made residual stocks by suitable treatment, such as a combination of acid treatment or solvent extraction with dewaxing or clay finishing

    光亮油通常由渣油經加工而製成的精煉、高粘度潤滑油。加工的方式包括:酸(或溶劑)脫蠟(或粘土精製)相結合。
  10. Bright stock refined , high viscosity lubricating oil usually made from residual stocks by suitable treatment , such asa combination of acid treatment or solvent extraction with dewaxing or clay finishing

    光亮油通常由渣油經加工而製成的精煉、高粘度微個個潤滑油。加工的方式包括:酸(或溶劑)與脫蠟(或粘土精製)相結合。
  11. All heat treatment by quenching and tempering

    所有和回火的熱方法。
  12. A quantitative pretreatment scheme suitable to gc - ms analysis of bio - oil was proposed for the first time in china, and an extensive determination of the chemical composition of bio - oil fractions was performed by means of gc - ms coupling. these studies were crucial for the upgrading and utilization of bio - oil. using some novel designing method, which are suitable to biomass and pyrolysis characteristics, were applied in designing the fluid bed biomass flash pyrolysis system

    並且率先在國內提出了適合於gc - ms分析的生物油的量化預方案(液?液分離法) ,得出了各個組分(酸組分、堿組分、極性中性組分以及碳氫組分)在生物油中所佔的份額,並對預所得的各個組分分別進行了gc - ms分析,鑒定出了上百種化學成分。
  13. A review on the application of liquid membrane extraction for environmental sample preparation is presented

    摘要對液膜技術在環境樣品前中的應用進行了綜述。
  14. Review on the characteristics of organo - sulfonic acid manufacturing wastewater and the recent development of treatment methods, especially the progress in advanced oxidation process, complexation extraction and polymeric resins adsorption was presented

    摘要本文綜述了芳香磺酸類有機化工廢水的污染特徵和方法的現狀,特別對高級氧化法、絡合法、液膜法及樹脂吸附法的研究進展作了重點闡述。
  15. Removing chromium from industrial wastewater by complexing extraction

    工業含鉻廢水的絡合萃取處理工藝研究
  16. Electrochemical realkalization and chloride extraction treatments for reinforced concrete - realkalisation

    加筋混凝土的電化學realkalization和氯化物萃取處理. realkalization
  17. Electrochemical realkalization and chloride extraction treatments for reinforced concrete - part 1 : realkalization ; german version cen ts 14038 - 1 : 2004

    加筋混凝土的電化學realkalization和氯化物萃取處理
  18. The worm - like mesoporous materials were synthesized and characterized with tem, x - ray diffraction, nitrogen adsorption / desorption and ft - ir techniques, etc. the results showed that all the samples had larger porediameter than the samples through calcinations under resembled conditions, but the mesopore ordered poorly. ft - ir results showed hexagonal structural character were kept, but xrd, tem results showed that the samples have the structure characteristics of msu - x. it was analysized that all n2 adsorption isotherms of the samples belong to langmuir iv category which is related to mesoporous materials

    Ft - ir光譜表徵結果顯示,經萃取處理后的介孔sio _ 2材料保持了六方的結構特徵;經xrd 、 tem進一步分析,證實所合成的介孔氧化硅材料具有msu - x材料的結構特徵, xrd譜圖表明樣品具有短程有序性:所合成的材料低溫n _ 2吸附測試結果表明,各樣品的n _ 2吸附等溫線均與中孔(介孔)特徵的第類曲線基本相符;由kelvin公式計算得到的孔徑分佈曲線說明,介孔材料具有較為集中的孔徑分佈;各樣品的bet比表面積比較高。
  19. The polystyrene particles with 2. 8 micrometer mean diameter were prepared by dispersion polymerization and hollow porous micro - sphere were prepared by extraction after seeding emulsion polymerization. particles with multi - hollow structure were obtained and characterized by sem, additionally the mechanism and factor about formation of porous structure were also discussed. to prepare the biodegradable nano - particles, reversed - phase micro - emulsion and ionotropic gelation methods were used

    利用分散聚合法制得了粒徑約為3 m的聚苯乙烯種子微球,再通過溶脹、交聯、種子乳液聚合及萃取處理,最後得到中空多孔的聚合微球,並討論了其成孔機和各博士論文功能型復合超微粒子的制備研究因素的影響。
  20. Ft - ir, xrd results showed hexagonal structural character were kept, xrd and tem results showed that the samples have the well ordered degree. it was analysized that all n2 adsorption isotherms of the samples belong to langmuir iv category which is related to mesoporous materials. the samples had uniform mesoporous distribution and high surface areas

    Ft - ir 、 xrd分析顯示,萃取處理方法得到的介孔材料保持了六方周期性排列的結構特徵, xrd衍射峰較窄,說明介孔具有長程有序性,同時tem照片也表明了介孔氧化硅材料具有長程有序的結構特徵。
分享友人