蒸塗 的英文怎麼說
中文拼音 [zhēngtú]
蒸塗
英文
coating by vaporization-
The driving wheel and front end beam was painted red color, and inside of operation room were painted ocher color. these are the standard painting color of the steam locomotives of china
塗裝落車輪前端梁赤白塗分運?室內黃土色中國蒸?機?車標準的塗裝Metallic coatings - porosity tests - porosity in gold or palladium coatings by sulfurous acid sulfur dioxide vapour iso 15721 : 2001 ; german version en iso 15721 : 2001
金屬塗層.孔隙率試驗.用亞硫酸和二氧化硫蒸氣測定金Water borne paints like acrylic lacquers dry by evaporation of the solvent - be it water based solvent
如同丙烯酸漆一樣，水性塗料的乾燥也通過樹脂溶劑的蒸發來實現。If fluxed parts are allowed to stand, the water in the flux will evaporate, and dried flux is liable to flake off, exposing metal surfaces to oxidation
如果允許塗上焊劑的部件處于直立狀態，那麼焊劑中的水分會蒸發掉，而乾燥的焊劑很容易脫落，致使暴露的金屬表面容易被氧化。Paints. determination of the evaporation curve of a solvent
塗料.溶劑蒸發曲線的測定Test method for porosity in gold coatings on metal substrates by nitric acid vapor
硝酸蒸氣測試金屬基體上金塗層孔隙率的方法Standard test method for porosity in gold coatings on metal substrates by nitric acid vapor
用硝酸蒸汽測試金屬基體上金塗層孔隙率的標準試驗方法A high - pressure mercury lamp in which the light is produced partly by the mercury vapor and partly by a layer of fluorescent material on the inner surface of the outer bulb excited by the ultraviolet radiation of the discharge - for example : hpl - n, hplr - n lamps
一種高壓汞燈，其中一部分光由汞蒸氣輻出，另一部分由放電輻出的紫外線激發后的熒光材料塗層發射得到，該熒光材料塗層位於外泡殼的內表面。Paints. thick plastics coatings. test for blister formation under water vapour diffusion
塗料.厚塑料塗層.在水蒸氣滲透作用下塗層起泡的試驗Vacuum distillation of solvents from solvent - reducible paints for analysis
從溶劑稀釋塗料中真空蒸餾出分析用溶劑的方法Horizontal road marking. markings applied on the roads. determination of volatile contents of paints and cold plastics by vacuum distillation
路面水平標記.馬路標記.通過真空蒸餾測量冷油漆和塗料的揮發餾分At the same time i also did many primary experments on separator and these polymer membrane can be used in as soft packaging li - ion battery ’ s separator. used polyvinylidene fluoride ( pvdf ) as the basic material, added cotton fibre and starch in, cooked with 100 in boiling water afer 3 hours, the starch inflate, and then acquire porous polymer membrane. in the process of coating polyester film, copper foil and aluminum boil were used to as carrier,
選用的基體材料為pvdf ，同時向其中添加棉纖維和澱粉，最後利用100沸水對隔膜進行3小時蒸煮處理使澱粉溶脹，從而達到造孔的目的。在塗布工藝的篩選中，通過對麥臘片、銅箔、鋁箔進行篩選，最後選定以銅箔為載體來進行塗布處理。當以銅箔為載體時，可以使隔膜正反兩面物理性質達到基本一致。For fungal infection of the body or feet, make alcohol extract of ding xiang or water decoction. apply on the affect parts
將丁香用酒精浸泡或煎蒸，將浸出液體或煎液塗抹于皮膚患處，治療體癬及足癬。Then the gel film can be prepared by dip - coating or spin - coating technique on the surface of glass and followed by drying in the ethanol vapor
使用浸漬提拉法或旋轉塗敷法，並通過放在乙醇蒸汽中乾燥，可在玻璃表面得到均勻的凝膠膜。Standard test methods for water vapor transmission of organic coating films
有機塗層薄膜水蒸氣滲透性標準試驗方法Length, diameter, density, fresh weight, dry weight, water content, osmotic potential and element concentrations ( ca, mg, na, k, cl ) were determined for each. seedling of b. gymnorrhiza and a. corniculatum were cultured for 60 days on various salinity of seawater ( 0, 5, 10, 15, 20, 30, 40, 50 ) in green house. samples were taken at 3, 7, 11, 15, 22, 30, 45 and 60 days after planting, separated into root, hypocotyl, stem and leaf
本文研究了福建九龍江口木欖和桐花樹胎生繁殖體從果實形成到發育成熟過程中形態、生物量、含水量、胚軸密度、滲透勢、五種主要礦質元素（ ca 、 mg 、 na 、 k 、 cl ）等的變化和溫室內人工鹽度梯度栽培下木欖和桐花樹成熟繁殖體長成幼苗（ 0 60d ）過程中形態、生物量、含水量、滲透勢、光合蒸騰特性、五種主要礦質元素（ ca 、 mg 、 na 、 k 、 cl ）等的變化；並且在野外自然條件下，跟蹤調查不同灘塗位置下秋茄成熟繁殖體定居成活、自然死亡狀況以及測定幼苗生長過程中（ 1年）形態、生物量、含水量、光合蒸騰特性等的變化。Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上Metallic coatings - determination of porosity on gold coatings on metallic substrates - nitric acid vapour test
金屬塗層.金屬基質金塗層孔隙率的測定.硝酸蒸發試驗Composition and structure of ti6ai4v alloy surface on which pure titanium was coated by vacuum - evaporating at high temperature
鈦合金表面高溫真空蒸鍍鈦塗層的組成和結構分享友人