蒸發區段 的英文怎麼說
中文拼音 [zhēngfāqūduàn]
蒸發區段
英文
boiling section-
It is considered that the sequence evolution in the palaeozoic went through the following three stages, the filling of evaporate platform, the filling of carbonate and detrital rock mixed deposits in epiric sea, and the filling of detrital deposits of lake - deltas in paralic inland sag
認為研宄區古生界層序演化經歷了以下三個階段：蒸發臺地充填階段、陸表海碳酸鹽巖與碎屑巖混合沉積階段，以及近岸內陸坳陷的湖泊三角洲碎屑巖沉積階段。Examinations of steady status and analysis of dynamic experiments have been conducted on band - tube evaporator and parallel - flow condenser using r134a refrigerant. the steady examination show that the model error was under the allowable error, the inlet mass and enthalpy disturb experiments indicate that the subsection model, be good at reflecting the change of parameters of the heat exchanger, accord with the basic principle of thermodynamics theory and the actual work status. hence, the subsection simulation model research has important benefits both on theory and engineering application
在進行模擬試驗時，以使用r134a作製冷劑的管帶式蒸發器和平行流式冷凝器為對象，完成了穩態模擬計算、試驗和動態模擬分析，穩態計算結果和試驗數據對比表明，其誤差在允許范圍內；進口質量和焓值的擾動試驗結果表明：本文所建的區段式換熱器模擬模型，能很好的反映換熱器性能參數的動態變化，與系統熱動力學理論和冷凝器、蒸發器的實際工作過程基本一致。Aiming at illustrating how the regional evaporation capacity was affected by human activities, this paper, by adopting statistics method, analyzed the materials covering fifteen evapotranspiration sites in chao lake valley spanning twentity years from 1981 to 2000, and then explored the relationship between the features of spatial distribution of evapotranspiration and relief, temperature, wind velocity, the amount of precipitation and other factors, as well as on the characteristics of evapotranspiration variation within a year and the trend of its annual changes
採用了統計學方法，對巢湖流域15個蒸發點20年（ 1981 - 2000年）的資料進行了分析，初步探討了巢湖流域的蒸發量空間分佈特徵與地勢、氣溫、風速、降水量等因子的關系，以及蒸發量在1年內的變化特徵和年際變化趨勢，試圖說明研究時段內人類活動對區域蒸發量的影響。Based on the experiments, the simulation of the heat exchanger and scroll compressor was accomplished which also offered a favorable condition to the establishment of the whole gwshp methods were used to improve the veracity and astringency of the model, such as : dividing the condenser into several tiny segment with equal area ; separating the condensing process into single - phase region and double - phase region ; the comparing result showed that most of the error between the data of simulation and experiment was within 5 % while the maximal error was 8. 35 %
在建模過程中，從大量蒸發和冷凝的換熱關聯式中，通過與實驗數據的比較找出了與實驗結果最為接近的換熱關聯式在建模過程中，針對冷凝器及板式換熱器的特點，採取將冷凝器按面積分成若干個微元段，並將冷凝過程分成單相區和兩相區的方法。同時對渦旋壓縮機進行建模和分析同時在熱力學平衡基礎上與實驗數據比較，經過驗證，對于換熱器模型，模擬計算與實驗結果的誤差一般都在5以內，最大為12 。分享友人