蒸發壓力 的英文怎麼說

中文拼音 [zhēngfāyālì]
蒸發壓力 英文
evaporating pre ure
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  3. It decreases chamber pressure by chemical reaction of residual gases with an evaporated metal.

    它通過剩餘氣體與蒸發的金屬之間的化學反應減小了內腔的壓力。
  4. Getter-ion pumps decrease chamber pressure by chemical reaction of residual gases with an evaporated metal.

    吸氣離子泵通過剩餘氣體與蒸發的金屬之間的化學反應減少了內腔的壓力。
  5. The results indicate that the qualitative behavior in this process is similar to that observed in condensation of vapor at or above atmosphere pressure, the coefficient of heat transfer for condensation in tube, the coefficient of heat transfer in total increase with the increasing of heat flux density and vapor pressure. however, heat flux density and vapor pressure have a more significant effect on them

    發現水平管內低壓蒸汽冷凝過程與常壓條件下蒸汽冷凝過程相同，管內冷凝傳熱膜系數、總傳熱系數隨熱流密度、蒸汽壓力的增大而增大，但熱流密度、蒸汽壓力對低壓蒸汽冷凝有著更為顯著的影響，管外冷卻水流量對其影響並不明顯。
  6. The key items influent on the characteristics of spraying have been also studied in the dissertation, we can get a good spraying result by adjusting the related parameters efficiently. ( 3 ) the theoretical model of the dynamical parameters such as temperature, moisture, pressure and contour for hot medium and particle inside the drying chamber were obtained by model, utilized the computational fluid dynamics technique to solve the problem between spraying droplets medium by arranging the double grid dispersing structure and rotary outlet structure and the developed structure improved the drying efficiency and product quality

    （ 3 ）採用-模型實現了壓力噴霧乾燥塔的溫度場、濕度場、流場的理論建模，利用計算流體力學（ cfd ）技術來解決噴霧乾燥過程中熱介質與霧滴間的傳熱傳質以及動量傳遞和湍流擾動等問題，避免了乾燥過程中的設計不合理狀況；通過增加雙格柵均風裝置和旋轉出風裝置，改善了乾燥塔內的熱質傳遞，提高了乾燥塔的體積蒸發強度。
  7. The air thermal cnergy water heater creates the new generation hot water cquipments. it makes use of the negative card promise successfully, drieing a hot pump with the elcctrie power. equiping through a hot pump medium of compesing parts evaporate a machine. hot pump, congealed machine and inflate valve, urge the work quality completes evaporationt absorb calories within air continuously compress compress congealed reduce expenses evaporate of the thermody name energy cirenlation proess, transfer the calories in the environment to the water thus in, transfer the in great quantities free calories in the air to the life to use a water in

    空氣節能熱水器是創新一代熱水設備，它成功地運用逆卡諾原理，用電能驅動熱泵，通過熱泵裝置中的構成部件-蒸發器，熱泵，冷凝器和膨脹閥，促使工質不斷完成蒸發（吸收空氣中的熱量）壓縮冷凝節流蒸發的熱力循環過程，從而環境的熱量轉移到水中，將空氣中大量免費的熱量轉移到生活中水中
  8. As we all know, the back - pressure valve ( also called evaporating pressure regulator ) is often used to regulate the evaporating temperature of every high - temperature refrigeratory in the system containing many different temperatures but single engine of the ship. but it is neglected that the energy of the system is lost and the efficiency of the system becomes low

    眾所周知船舶單機多庫（簡稱為高、低溫冷庫）系統中，常用背壓閥（蒸發壓力調節閥）來調節各高溫庫的蒸發溫度，但忽略了系統無形損耗的能量，效率也有所下降。
  9. High water saturated vapour pressure leads to the more possible occurrence of cavitation phenomena in water hydraulic pump, and so as in sliding shoes hydraulic supporting without exception

    水的高飽和蒸汽壓力使得水壓泵中極易發生氣蝕現象，滑靴靜壓支承也不例外。
  10. The theory of interface of two - phase fluid id used to analyze the role of the interfacial heat transfer resistance in cond ensation process, it shows that the interfacial heat transfer resistance can not be ignored under such a vacuum condition, and the effect on heat transfer process becomes declined with the increasing of vapor pressure

    應用兩相界面理論分析了汽液界面熱阻在水平管內低壓蒸汽冷凝過程中所起的作用，發現實驗范圍內汽液界面熱阻不可忽略，且其對冷凝傳熱過程的影響隨蒸汽壓力的增大而減弱。
  11. Two typical examples analyses are conducted for the average conditions both of winter and summer climates under vapor diffusion and air leakage. a further discussion is set forth to determine the main factors that the moisture accumulation in wall is affected. it is found that the factors are the relative humidity at the wall surface, indoor temperature, permeability, air pressure difference and rate of the infiltrative or exfiltrative airflow

    本文首先研究了墻體內的濕氣遷移過程，詳細分析了濕積累現象形成的原因，通過對夏、冬兩季平均氣候下墻內溫度、水蒸氣壓力、相對濕度及濕積累在僅有擴散、擴散與空氣滲透同時存在等情況所作的具體計算，發現墻內、外表面的相對濕度、室內溫度、滲透率、空氣壓差以及空氣的滲流速度是影響墻內濕積累的主要因素。
  12. The experiment took water as the medium and experiments on two jet modes were carried out under the falling film vacuum evaporating. the experimental results indicated that the two ejectors in series compensation method could adjust the variational work situation due to the decrease of primary steam or secondary steam and insure the normal production. at the same time, the ejector ' s best work situation founded in the experiment would provide reference for ejector ' s design and usage

    本實驗建立了一套降膜真空蒸發裝置，以水為介質，對變工況下單級和串聯噴射熱泵蒸發進行了實驗，結果表明兩級串聯補償噴射裝置能對由引射蒸汽和工組蒸汽壓力降低所造成的混合蒸汽壓力降低進行調節，達到了變工況下正常生產的目的。
  13. The results show that while the mass flow of refrigerant is 1. 85g / s, the inlet temperature of refrigerant is 18. 9, the evaporating pressure is 0. 62mpa, the mass flow of water is 31. 1g / s, and the inlet temperature of water is 36. 9, the refrigerant of miniature evaporator wholly vaporizes in the tube, and the heat transfer rate is 342w. it achieved the demand of design

    經過實驗測試，當製冷劑質量流量為1 . 85g / s ，製冷劑入口溫度為18 . 9 ，蒸發壓力為0 . 62mpa ，水的質量流量為31 . 1g / s ，水的入口溫度為36 . 9 ，此時，螺旋管蒸發器內製冷劑完全蒸發，換熱量342w ，達到了微型蒸發器的預期設計要求。
  14. The pressure of steam in the engine is controlled by this button

    發動機里的蒸汽壓力由這個按鈕控制。
  15. This article emphatically discussed and analyzed following points : load command feed forward function can improve the rapid respond character of steam turbine generator ; lead of load command have advance control function on boiler main control and can highly improve the stability of main steam pressure ; the use of predict control and state space variable function can improve the quality of boiler steam temperature control effectively, control the steam temperature in the defined range and increase the boiler and turbine life and efficiency even if working state changed in a big range ; linear compensation can restrain the vibration of generator load in the condition of big loa d change

    本文重點討論、分析提出負荷指令前饋作用可以提高汽輪發電機快速響應特性；負荷指令的導前功能對鍋爐主控有超前控製作用，能顯著提高主蒸汽壓力的穩定性；採用預測及狀態空間法能有效改進鍋爐蒸汽溫度控製品質，在大幅度工況變化下仍有效控制蒸汽溫度在額定范圍內，提高鍋爐、汽輪機壽命及其效率；汽輪發電機組的快速響應性與汽輪發電機組負荷振蕩問題間的平衡關系，採用線性補償可以有效抑制在負荷變化梯度較大情況下發電機負荷振蕩問題。
  16. Crude oil and petroleum products - determination of vapour pressure - reid method

    原油和石油產品.蒸發壓力的測定.里德法
  17. Attentions should be played to the following three systems in parallel multi - condensing unit : lubricant control system, evaporating pressure control system and computer controller

    並聯機組的關鍵點有三個： （ 1 ）潤滑油控制系統（ 2 ）蒸發壓力控制系統（ 3 ）電腦控制器。
  18. Evaporator pressure regulator

    蒸發壓力調節器
  19. Hydrodynamics simulated experiments of the driving force fornatural cycle of self - cleaning evaporators

    自然循環自動清洗式高效蒸發器對蒸發壓力的適應性
  20. In this paper, the function of compressive refrigeration equipment ( include : condensing press, evaporative press, automatic regulation and protection of refrigeration equipment ) is analyzed

    摘要對蒸氣壓縮式製冷裝置的性能（主要包括冷凝壓力、蒸發壓力、製冷裝置的自動保護和自動調節）進行了分析。
分享友人
分享到 Line

分享到臉書