蒸發材料 的英文怎麼說

中文拼音 [zhēngfācáiliào]
蒸發材料 英文
evaporation material
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. On the one hand, it, by succeeding to the research methodology of the abstract regulation which has been refined out of all - round phenomena, by specifically analyzing and masticating the historical materials of management thoughts, has marked out the logic starting point of western management studies, and has extracted the three abstract regulations from the hundred - year - long history of management thoughts

    一方面，繼承了「從完整的表象蒸發出抽象的規定性」的研究方法。通過細致剖析、咀嚼管理思想史的材料，界定了西方管理學的邏輯起點，並從百余年管理思想史中「蒸發」出三個抽象的規定性。
  2. The main scattering mechanism is ionized impurity scattering and acoustical phonon scattering. the experimental results show that the high quality of zno. al films were obtained

    實驗結果表明利用電子束蒸發技術制備的zno ： al薄膜材料，具有較好的結構及光電特性。
  3. This material has the ability in humidity absorbing and releasing and evaporate cooling. through theoretically analysis on this new building material - porosity moisture - conditioned material, a testing equipment is set up, the performance curve of the moisture - conditioned material ability in humidity absorbing and releasing and evaporate cooling is obtained, meanwhile, porosity moisture - conditioned material ' s validity to building energy efficiency design is proofed

    在分析這種新型建築材料多孔調濕材料的理論分析基礎上，搭建了測試風道並進行了實驗研究，得出了調濕材料的自動吸放濕能力及蒸發冷卻性能曲線，證明多孔調濕材料對于建築節能設計的有效性。
  4. On the background of the innovation of the wall material and the current situation of the development in china, the regenerative material is synthetically used to prepare new wall material, including high - environmental - protection steam - maintain fly ash bricks ( hsfab ) and self - aerated lightweight concrete ( salc ). the mechanics characteristic, durability and micro - structure of the new wall material are analysed. it shows that the materials are the perfect replacement products of the traditional solid clay brick. two systems of hsfab - cement - steel slag - fly ash - slag and lime - steel slag - fly ash - slag - are designed to fit for the requirement of performance, cost and environmental - protection, etc.

    本課題以國家和地方墻體材料改革政策和發展現狀為背景，綜合利用當地可再生資源研製開發了新型墻體材料體系，該體系包括承重墻體材料? ?高綠色度蒸養粉煤灰磚（ high - environmental - protectionsteam - maintainflyashbricks ，以下簡稱hsfab ）和非承重墻體材料? ?自發氣輕質混凝土（ self - aeratedlightweightconcrete ，以下簡稱為salc ） 。
  5. Beginning with a glass substrate, different materials are deposited layer by layer

    製作過程要將組成的材料蒸發，然後凝結在基板上。
  6. A high - pressure mercury lamp in which the light is produced partly by the mercury vapor and partly by a layer of fluorescent material on the inner surface of the outer bulb excited by the ultraviolet radiation of the discharge - for example : hpl - n, hplr - n lamps

    一種高壓汞燈，其中一部分光由汞蒸氣輻出，另一部分由放電輻出的紫外線激發后的熒光材料塗層發射得到，該熒光材料塗層位於外泡殼的內表面。
  7. Automotive air conditioner accessories : automotive air conditioner cooler, evaporator, heat sink, air conditioner, temperature adjuster, heater, central cooler, air desiccators, cooling fan controller, internal heat exchanger, compressor, motor, air warmer, warm air device, electronic fan for cooling condenser, liquid can, thermal expansion valve, air condition pipeline, switch, clutch, connector, height valve, shunt valve and all kinds of automotive air conditioner production materials ( body aluminum, copper materials, etc ), production equipment, measurement equipment, etc

    車用空調配件：各種車用空調冷凝器、蒸發器、散熱器、空調器、調溫器、加熱器、中冷器、空氣乾燥器、冷卻風扇控制器、內部熱交換器、壓縮機、電動機、暖風機、暖風裝置、各種冷凝器電子扇、貯液灌、熱力膨脹閥；各種車用空調管路、開關、離合器、接頭、高低閥、換向閥及各種車用空調生產材料（車用鋁材、銅材等） 、生產設備、檢測設備等。
  8. Theoretical and experimental study of ellipse tube type indirect evaporative cooler wrapped with absorbing water materials

    包覆吸水性材料橢圓管式間接蒸發冷卻器的理論與實驗研究
  9. The rate of evaporation depends on the material and such factors as the temperature, the surface area, amount of ventilation, and the pressure exerted on the surface

    蒸發速率取決于材料及諸如溫度、蒸發面積、通風量和施加在此蒸發面上的壓力等因素。
  10. Should the packing material be found insect infestation by quarantine inspection office at the port of destination, the seller shall bear the cost of fumigation or replacement of the packing

    如果貨物運達目的地后，包裝材料被檢驗檢疫部門發現蟲子，賣方應該承擔熏蒸的費用或者替換包裝的費用。
  11. Evaporative cooling has been regarded as a new cooling technology on hydro - generator, and it not only could increase the ratio of material utilization and reduce the difficulties of making large - scale hydro - generators, the running difference in temperature, the stress of the generator ' s stator and the possibilities of the incidental occurrences, but also has better performance than internal water cooling

    蒸發冷卻作為水輪發電機的一種新型冷卻技術，不僅可以提高材料利用率，減小特大型發電機製造難度，降低發電機定子繞組運行溫差和發電機定子的應力，減少事故隱患，更重要的是蒸發冷卻比水內冷具有更好的優越性。
  12. Proceed from energy - conserving angle of building, a kind of passive evaporative cooling way is proposed that applies to the wall surface, namely porosity moisture - conditioned material is used on building envelope

    摘要從節能角度出發，提出一種應用於建築墻體表面的被動蒸發冷卻方式，即將多孔調濕材料貼附於墻體外表面，這種材料兼具自動吸放濕性能和蒸發冷卻性能。
  13. In this dissertation, high quality ( 002 ) textured zno films were prepared on silicon substrate using electron beam evaporation method. in addition, zno nano - particle material embedded into mgo thin films was prepared by a co - evaporation ( thermal and electron beam evaporation, simultaneously ) method and a following post - annealing process in oxygen ambient

    本文介紹了採用電子束蒸發方法在si襯底表面上制備出了具有c軸擇優取向的高質量氧化鋅薄膜材料，另外，還採用共蒸發（通過電子束蒸發與熱蒸發同時進行）及後退火的簡單方法制備出包埋到介電物質mgo薄膜中的zno量子點材料。
  14. As well - known, there is an induced current on the surface when metal material is in the high frequency electromagnetic field, since tending to skin heating effect to make the temperature of metal material surface go up promptly, surface beginning melt when temperature reaches the melting point of metal, metal material is heated up continuously by surface to core till the metal droplet of melting

    自懸浮定向流技術制備金屬納米微粒與一般的蒸發冷凝法有所不同，其原理是：金屬材料在高頻電磁場中產生表面感生電流，由於趨膚加熱效應使得金屬材料表面的溫度迅速升高，當溫度達到金屬的熔點時表面開始熔化，通過熱傳導作用金屬材料由表面到芯部不斷加熱直至熔化成金屬液滴。
  15. In this dissertation, nanometer zno thin films on si ( 100 ) substrates were prepared by using thermal evaporation technique following by two - step annealing process : high quality zno thin films and mgxzn1 - xo alloy films have been grown on si ( 100 ) substrates with mgo buffer layers by using thermal evaporation technique following by two - step annealing process

    本文介紹了採用電子束蒸發方法在si補底上制備出了高純度的金屬鋅膜，然後通過二次退火得到了具有六角結構的高質量氧化鋅多晶薄膜材料，另外，還採用電子束蒸發mgo薄膜作為緩沖層二次退火金屬鋅膜的方法制備出了高質量氧化鋅多晶薄膜材料和mgzno合金薄膜材料。
  16. This paper has first summarized the experiment of granular film and theoretical research progress and the present major problem to be solved, has discussed the purpose meaning of this paper on this foundation, has introduced us soon afterwards with magnetic metal - non - magnetic metal material adopt for studying object to co - vapored deposited system such as the fexcu1 - x of different fe content x granular film sample, carrying out annealing handling for some of samples, using x ray diffraction instrument xrd ), scanning electrical microscopic ( sem ), vibrating sample magnetometer ( vsm ) the tiny structure for sample, appearance and the magnetic result that can carry out detection

    本文首先綜述了顆粒膜的實驗和理論研究進展情況和目前待解決的主要問題，在此基礎上論述了本文的目的意義，隨后介紹了我們以磁性金屬?非磁性金屬材料為研究對象，採用共蒸發法制備不同fe含量x的fe _ xcu _ （ 1 - x ） ，顆粒膜樣品，對部分樣品進行退火處理。給出了用x射線衍射儀（ xrd ） 、掃描電鏡（ sem ） 、振動樣品磁強計（ vsm ）對樣品的微結構、形貌及磁性能進行檢測的結果。
  17. It is of pipe type used for evaporation, heating, condensing, cooling operations, materials for this unit are optional as per the physical, chemical and corrosive properties

    這是一種管殼式換熱器，可用於蒸發、加熱、冷凝、冷卻等工藝，由介質的物理、化學和腐蝕等性能來選擇適宜的材料製作。
  18. In this study, si nanomaterials were prepared by a thermal evaporation system, and four kinds of si nanomaterials, nanoparticles, nanoclusters, nanoclusters with hf treatment, and nanoclusters with ch3cooh treatment, were studied

    本研究系以熱蒸鍍系統制備奈米矽，並探討四種不同形式的奈米矽材料的發光機制，分別為矽奈米粒子、矽奈米團塊、以及經由氫氟酸和醋酸處理后的矽奈米團塊。
  19. Vacuum processes experience in oled evaporation & encapsulation are advantage. : new graduates in physics, chemical engineering, material engineering, or related majors are also considerable

    （真空工藝?有oled蒸發和封裝經驗者優先考慮?如物理?化學工程?材料工程或相關專業的應屆畢業生也可考慮。 ）
  20. The probability of injecting cold water into the steam generators in operation in the internal structures and connected pipings to prevent thermal shock or fatigue should be reduced by considerations in design

    應該在設計時考慮並降低在蒸氣發生器中注入冷水使內部構造和相連管道運轉以防止熱沖擊或材料腐朽的可能性。
分享友人
分享到 Line

分享到臉書