薄膜試驗 的英文怎麼說

中文拼音 [bómóshìyàn]
薄膜試驗 英文
film test
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 薄膜 : thin film; film; diaphragm
  • 試驗 : trial; experiment; test
  1. This test method is not intended for use in testing corrugated boxboard, liner board, or hardboards that tend to cut the thin rubber diaphragm

    這個試驗方法不用於試驗割成薄的橡膠橫隔膜的瓦楞盒紙板，墊板或硬紙板。
  2. Standard test method for sheet resistance of thin metallic films with a collinear four - probe array

    用共線四探針法對金屬薄膜的薄膜耐力的試驗方法
  3. Ions separation in liquid phase. polymeric ion exchange membranes. characterisation and test methods of homopolar membranes

    液相離子分離.聚合的離子交換薄膜.單極薄膜的特點和試驗方法
  4. Methods of testing plastics. other properties. determination of the gas transmission rate of films and thin sheets under atmospheric pressure manometric method

    塑料的試驗方法.第8部分:其他性能.試驗方法821a :在大氣壓力條件下薄片和薄膜透氣率的測定
  5. Plastics - films for agricultural soil desinfection - specification for methyl bromide barrier films and test methods

    塑料製品.農業土壤消毒用薄膜.溴代甲烷隔膜規范和試驗方法
  6. Standard test method for pentane insolubles by membrane filtration

    薄膜過濾法測定戊烷不溶物的標準試驗方法
  7. Test method for thickness of fine ceramic thin films - film thickness by contact probe profilometer

    精細陶瓷薄膜厚度的試驗方法.用接觸探針式表面光度計法測定薄膜厚度
  8. Testing methods for paints - part 5 : mechanical property of film - section 4 : scratch hardness pencil method erratum 2

    塗料試驗方法.第5部分:薄膜的機械特性.第4節:刮擦硬度
  9. Testing methods for paints - part 5 : mechanical property of film - section 5 : scratch hardness stylus method erratum 1

    塗料試驗方法:第5部分:薄膜的機械特性.第5節:刮擦硬度
  10. Actually the application and the feasibility of this method are testified by contrasting to the subsistent testing

    並且考慮薄膜效應與已有試驗相比較表明該方法的適用性和可行性。
  11. The method of concentrating the decoloration solution of tylosin is usually carried out by thin film vacuum concentration. in this experiment, the concentration process is modified by using the nanofiltration membrane technique which is free from corrosive due to the extractant solvent and in the same time, heating and decomposition of the antibiotic are eliminated, the concentration course ia also distinctly shortened. in this process the small molecule can be filtered by water, and the quality of the product such as, the tyramine content, the solubility of the product, improved significantly. in addition, the membrane filtration process could save consumption of steam and cooling water

    泰樂星提煉過程中原工藝脫色液用薄膜真空濃縮，本試驗改進為耐溶媒納濾膜濃縮，料液不需要加熱即可濃縮，防止了料液的高溫分解破壞，濃縮收率明顯提高在濃縮的同時，部分小分子雜質可以隨水分子一起通過納濾膜而除掉，成品質量明顯提高，解決了用原工藝成品酪胺、溶解度不合格的質量問題省去了原工藝濃縮中費用較高的蒸汽、冰鹽水，經濟效益可觀。
  12. 2, in the experimental study, 12 joints tests are completed, including 5 uniplanar x joints loaded with axial forces, 3 uniplanar x joints loaded with in - plane bending, 4 multiplanar xx - joints loaded with axial forces, with the emphasis on the influence of and the existence of the out - of - plane braces, of which the multiplanar xx - joints tests is the first experiment project in china

    其中，對等寬方管節點（ = 1 . 0 ）推求了考慮薄膜效應影響的極限承載力公式。 （ 2 ）試驗研究：本文共計進行了12個方管平面x型和空間xx型相貫節點試驗研究，進一步加深對方管相貫節點的感性認識，了解其實際破壞模式。
  13. In this paper, the mechanical behaviors of the polythiophene ( pth ) and ploypyrrole ( ppy ) films are experimentally investigated using an electronic speckle pattern interferometry ( espi ) method and an equipment with a sensitive mechanical sensor

    本文採用對面內位移敏感的電子散斑干涉技術和帶有自製的靈敏力傳感器的實驗裝置對不同厚度的聚噻吩薄膜試樣進行了拉伸實驗。
  14. Methods of testing plastics - thermal properties - flammability of a test piece 550 mm x 35 mm of thin polyvinyl chloride sheeting laboratory method

    塑料試驗方法.第1部分:熱性能.試驗方法140d : 550mm 35mm聚氯乙烯薄膜試片易燃性
  15. Tests relating to pavements. waterproofing materials for structures. determination of cracking stregth. part 1 : tests on adhesive thin film

    路面試驗.結構用防水材料.開裂強度測定.第1部分:膠粘薄膜試驗
  16. Standard guide for determination of thickness of plastic film test specimens

    塑料薄膜試驗樣品的厚度測定標準指南
  17. Zero - expansion models satisfy the request of space structures for they can possess high dimensional stability in temperature - change fields. the surface morphology, electrical conductivity and spectral reflectivity of al / kapton films before and after space environment simulated tests were

    對于al / kapton薄膜試驗分別採用原子力顯微鏡、四探針電阻測量儀、紫外可見分光光度計測試其空間環境試驗后的表面形貌、面電導率、光學反射率。
  18. Practice for cutting film and sheeting test specimens

    切削薄膜和薄板試驗樣品慣例
  19. Test methods of plastic films for electrical purposes

    電氣用塑料薄膜試驗方法
  20. Standard test method for static puncture resistance of roofing membrane specimens

    屋面薄膜試樣耐靜態穿孔性能的標準試驗方法
分享友人
分享到 Line

分享到臉書