表機粘力計 的英文怎麼說

中文拼音 [biǎojīniánlìjì]
表機粘力計 英文
tacciometer
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 機 : machineengine
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. Abstract : in this paper, an analytical study of the dynamics of the piston in a reciprocating internal combustion engine is conducted. the equations of reynolds and moving of piston are derived. a useful method of solution is obtained. the method is applied to s1100 diesel engine. the results of this study indicate that piston oil film is found to be sensitive to the piston - cylinder bore clearance, the location of the wrist pin and lubricant viscosity

    文摘:對往復式內燃機活塞的動力特性進行了分析研究，導出了活塞潤滑的雷諾方程和活塞運動方程，給出了可供實用的求解方法，並採用這種計算方法對s1100柴油機進行了設計計算與試驗研究.研究結果表明，活塞潤滑油膜歷程與活塞& &缸套的間隙、活塞銷的位置、潤滑油的粘度等因素密切相關
  3. In this paper, single fiber composite fragment ( sfc ) method, which is one of the most widespread and effective experimental methods for determining the mechanical properties of interface, was adopted to study the load transfer mechanism and to evaluate the adhesion performance of composite with surface - treated fibers. this is helpful for optimization design of interface

    本文採用了目前最為流行、最為有效的直接測定界面力學性能的實驗方法之一? ?單纖維復合材料斷裂實驗研究了纖維樹脂界面載荷傳遞機理，分析了幾種纖維表面處理復合材料界面的粘結情況，對界面的優化設計具有一定的指導作用。
  4. In order to predict hydrodynamic characteristics a computational system is developed including determination of the pressure distribution on a wing section by use of the conformal mapping method and panel method respectively and of the flow in boundary layer according to the thin shear layer approximation ( tsl ) for navier - stokes equation approach. the wing sections of naca4412 and naca0012 are applied to test the computational system. the numerical inspection shows that the panel method with better precision and the momentum and the displacement thickness of boundary layer can be used to complete this calculation

    本文分別用守屋的保角變換法和基於源匯渦分佈的面元法，建立了計算槳葉表面壓力分佈的數學模型；應用納維-斯托克方程的薄層近似理論模式和有限差分數值方法，建立了計算機翼表面邊界層內部流動的數學模型；應用槳葉表面邊界層內部粘性流動和外部勢流流動在邊界上的匹配演算法，建立了槳葉表面二相流流動的計算方法和相應的計算機程序。
  5. Based on the method of limitation analysis of soil plasticity, researching from the soil arching mechanism of soil - nailing retaining, the upper limit of the critical height of soil - nailing slopes and the minimum horizontal length from coping of the potential slide surface to the edge of deep excavation are obtained through the analysis to weight of soil and vertical loading and the mechanism of soil and soli - nailing acting reciprocally

    摘要基於土的塑性極限分析方法，以均質土坡為例，從土釘支護結構的準粘聚力理論出發，綜合考慮土體自重、坡頂的條形荷載，以及土釘與土體的相互作用的機理，推導出了土釘支護的臨界高度的上限值和潛在螺旋曲線滑動面在坡頂方向距基坑邊沿的最小水平距離解析表達式，可供基抗支護設計參考。
  6. Analysis of the inter - velution ship and its influence factor between loess landslide slope failure and charecterisitics of soil and rock mass show that the range of landslide slope failure enlarges with the development of earthquake intensity, coeffient of pore pressure and cohession. it delarges with the development of angle of internal friction ; use simplicity bishop method and computer to get simplicitely and quickly usable stability anlytic figures and data table

    分析黃土滑坡與巖性的內在關系及其影響因素表明，滑坡范圍隨地震烈度、孔隙水壓力系數、粘聚力的增大而增大，隨土體內摩擦角的增大而減小;採用簡化畢消普法，藉助計算機，獲得了簡捷明快、使用方便的穩定分析圖表。
  7. The effect of the change of surface elevation on the wave development and elimination is pointed out for the first time, which provides the necessary theoretical basis for the development of united current - wave - tide model ; hi the discussion of the effects of waves on currents, a variety of wave - induced forces on the geostrophic and viscous condition and their producing mechanism are introduced systematically, their corresponding wave - induced currents are also analyzed qualitatively. moreover, a complete expression of wave - induced reynolds stresses tensor is presented for the first time

    在浪對流作用的討論中，系統的闡述了海浪在地轉作用和粘性條件下所產生的各種作用力，詳述了它們的生成機制，並定性的分析了相應的波生流，同時，首次提供了地轉條件下浪致雷諾應力張量的完整表達式，為實現海流模式與海浪模式的并行數值計算提供了一種簡便的途徑。
  8. Abstract : the article introduces cement slurry rheological characteristics and the method of determining the main parameters for cement slurry rheological characteristics, and analyses the difference between the rotation type and funnel type of viscometers in measuring plastic viscosity and apparent viscosity of cement slurry, and then the limitation of the funnel type of viscometer is described. the difference between rigidity and yield value is pointed out. finally through analysis of cement slurry rheological characteristics, the cement slurry filling mechanism is proposed, and the main factors affecting cement slurry are studied

    文摘:介紹塑性流體水泥漿的流變性及確定水泥漿主要流變參數的一般方法；分析旋轉式粘度計與漏斗式粘度計在測定水泥漿塑性粘度、表觀粘度時的區別，說明漏斗式粘度計在使用上的局限性；針對粘聚力（動切力）的測定進行分析，認為粘聚力與動切力為不同的概念.通過對水泥漿流變性分析，提出水泥漿充填機理，並對影響水泥漿擴散的主要因素，即粘度影響水泥漿在節理裂隙中向前擴散的速度，動切力限制水泥漿擴散距離作了說明
分享友人
分享到 Line

分享到臉書