表面振動器 的英文怎麼說

中文拼音 [biǎomiànzhèndòngqì]
表面振動器 英文
float vibrator
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 振動 : vibrate; vibration; vibrance; vibrancy; vibra; vibes; shaking; rumble; jitter; chatter; sway; jar...
  1. Based on the comprehensive estimating method of the final drive, the analysis method is proposed to focus on analyzing one of the important testing targets ? the meshing states of the spiral bevel gears and differential gears of the final drive when they are working under the imitating conditions

    本文主要對汽車后橋主減速器殼表面的振動信號進行分析。這是在主減速器綜合評價方法的基礎上，針對其中一項重要的試驗參數? ?主減速器齒輪的嚙合狀況，而提出的分析方法。
  2. Ndfeb magnet is mainly made of neodymium iron and boron, with excellent magnetic property abundant raw material and reasonable prices, ndfeb magnet can be used as an ideal magnet in mini - motor permanent magnetic resonance sound device magnetic suspension system, magnetic transmission machine and iatrical apparatus and etc. for ndfeb, its surface is usually treatd with some special methods. the surface treatment method include zine nickel tin silver gold plating phosphor and spray epoxy resin etc

    其主要應用在微特電機、永磁儀表、電子工業、汽車工業、石油化工、核磁共振裝置、音響器材、磁懸浮系統、磁性傳動機構和磁療設備等方面。釹鐵硼磁鐵容易生銹、氧化，所以對釹鐵硼磁鐵，其表面通常需作電鍍處理，如鍍鋅、鎳、銀、金等，也可以做磷化處理或噴環氧樹脂來減慢其氧化速度。
  3. Secondly, through analyzing the failure instance of electrical connectors in using and testing environment, educed contact fault was a main mode of failure of electrical connectors. on natural working conditions, the main reasons which caused fault of electrical connector were contact stress decreasing, microseism wearing and tearing and surface film growing

    而在正常的工作條件下，造成電連接器電接觸失效，即決定電連接器工作壽命的主要原因是接觸壓力減小、微動磨損和表面膜層的生長，而影響接觸壓力、微動磨損和表面膜層變化的主要因素是環境振動和溫度。
  4. Non - sinusoidal oscillation has the characters that the upward time of the continuous casting mold is longer than the downward time. it can reduce the friction between the mold wall and the strand surface, and prevents the strand from leaking and cracking, it can also improve the surface quality of slabs. it is the main development of continuous casting mold in the future

    其中非正弦振動具有上升運動時間比下降運動時間長的特點，能減小結晶器與坯殼之間的摩擦力，防止坯殼的拉漏和拉裂，改善鋼坯的表面質量，是今後連鑄結晶器振動發展的主要方向。
  5. Surface acoustic wave ( saw ) motor is a novel micro actuator, which generates saw with the electroacoustic transducer and transfers it to the power of saw motor by the frictional force between the slider and the stator

    表面彈性波馬達是一種以電聲換能器產生表面彈性波，並通過馬達動子和定子的接觸摩擦將表面彈性波振動轉換為馬達動力的新型執行器。
  6. Piezoelectric elements were pasted on / under the cantilever beam where stress was the maximum or sub - maximum as actuators to control the vibration of the cantilever beam

    在懸臂梁振動時應力最大或次最大處的上、下表面同位元配置壓電片，作為抑制懸臂梁振動的致動器。
  7. At this time, the approximate mechanical model of devices has been put forward, which frequency is 70 mhz, then we analyzed the euler ? bernoulli equation, find that the frequency is determined by the resonator ’ s density thickness and length ; the free - free - beam 、 coupled beam 、 support beam 、 transducer have been designed ; the model was simulated and modal analyzed on the coventorware and were consistent with the designed parameter. the silicon surface microfabrication process was developed and emphatically introduced several key surface microfabrication technologies, and was simulated by coventorware

    本文通過分析歐拉-貝努立方程，得出濾波器的共振頻率主要由諧振梁的密度、厚度和長度決定，考慮切變形和轉動慣量的情況下，完成微機械諧振梁、支撐梁、驅動電容的設計;在coventorware軟體上進行模擬，分析結果與理論設計比較好地吻合;對微機械濾波器的加工工藝進行設計，給出器件的完整的工藝流程，重點介紹微機械表面加工工藝，並在coventorware上進行模擬。
  8. Ultrasonic motors are a new kind of solid actuators that come into being since 1980 ’ s, which use inverse piezoelectric effect of pzt to excite stator ’ s elliptical vibration and produce driving power by frictional coupling

    超聲波馬達是上世紀80年代開始發展起來的一種新型驅動器，它是利用壓電陶瓷的逆壓電效應激勵出定子表面質點的橢圓軌跡振動，依靠摩擦耦合來實現驅動。
  9. In chapter 4, the aeroelastic model of the whole test rig is first established by using jones ’ s approximation of theodorsen ’ s unsteady aerodynamics load. then, the numerical simulations and wind tunnel experiments for the sub - optimal flutter suppression of the airfoil model are presented

    數值模擬和風洞實驗研究表明，以超聲電機為控制面作動器可以有效地抑制翼段模型的顫振，顫振臨界速度提高了13 . 4 % ，數值模擬和風洞實驗結果基本吻合。
  10. The early studies are mostly focused on the method of gluing piezoceramics on structural surfaces, which has some disadvantages such as difficulties to protect the ceramics and the connection wires, bad coupling with only one surface glued on the base materials, low signal - to - noise ratio etc. these problems can be solved using the embedded piezoceramics, and furthermore, the piezoceramics can be placed in the optimal positions, especially in the optimal deepness for the piezo - actuators, according to an optimization algorithm befor e they are embedded, so the actuator effects and sensor signals are thereby enhanced

    早期的研究主要集中在表面粘貼壓電片的結構，表面粘貼壓電片具有一些無法克服的缺點。本文著重進行利用埋入復合材料結構的壓電傳感器和壓電驅動器對其振動進行主動控制的相關理論和實驗研究，並介紹其相應結果。埋入型壓電材料的優點主要是能保護壓電傳感器和作動器及其連線、增強壓電材料和基體材料的耦合、優化埋入壓電陶瓷的深度和厚度可增強壓電傳感器的測量信號並提高信噪比等。
  11. With its excellent magnetic property, abundant raw material and reasonable prices, rare - earth permanent magnet can be used as an ideal magnet in mini - motor, permanent - magnet instrument, electronic industry, auto industry, petro - chemical industry, nuclear magnetic resonance, sound device, magnetic suspension system, magnetic transmission machine and magnetotherapy apparatus etc

    稀土永磁體及元器件以其優異的性能，豐富的原料，合理的價格，正在得以迅速的發展和廣泛的應用。其主要應用在微特電機，永磁儀表，電子工業，汽車工業，石油化工，核磁共振裝置，音響器材，磁懸浮系統，磁性傳動機構和磁療設備等方面。
  12. The effectivity of the approximation of rayleigh wave in semi - infinite media to the plane mode in the stator transducer of saw motor with finite thickness ( much bigger than the wavelength of the saw ) is evaluated first time by us

    首次探討了用瑞利波近似表面彈性波馬達定子換能器（厚度遠大於表面彈性波波長）平板振動模式的有效性。
  13. Ndfeb magnet is mainly made of neodymium, iron and boron, with excellent magnetic property, abundant raw material and reasonable prices, ndfeb magnet can be used as an ideal magnet in mini - motor, permanent magnetic resonance, sound device magnetic suspension system, magnetic transmission machine and iatrical apparatus and etc. for ndfeb, its surface is usually treatd with some special methods. the surface treatment method include zine, nickel, tin, silver, gold plating, phosphor and spray epoxy resin etc

    釹鐵硼永磁體以其優異的性能、豐富的原料、合理的價格正得以迅猛的發展和廣泛的應用。其主要應用在微特電機、永磁儀表、電子工業、汽車工業、石油化工、核磁共振裝置、音響器材、磁懸浮系統、磁性傳動機構和磁療設備等方面。
  14. Finally we conducts rig test with fuzzy control system. the test results indicate fuzzy control system is able to lower intensity of body vibration and the national standard on the vibration eligible class of the engine is met. it is demonstrated that the mathematical model and fuzzy control arithmetic presented by the paper are accurate and reliable, which make an active seek and research on control strategy of engine vibration

    以matlab + simulink為模擬工具，設計了模糊控制系統和被動控制系統兩類不同的模擬模型，並進行了對比模擬和結果分析，在此基礎上，設計開發了以80c196kc單片機為主控器件的模糊控制系統，進行了控制系統的軟、硬體設計，最後對所設計的模糊控制系統進行了臺架實驗，實驗結果表明模糊控制系統能有效地降低了內燃機整機振動的強度，達到了國標規定的合格級，證明了本文建立的數學模型和模糊控制演算法是正確可行的，在內燃機振動控制策略方面作了一個積極的探索和研究。
  15. But its performance is as same as common pll at a 5v voltage. so the pll performance is better than other plls at a 5v voltage, especially in power consumption and frequency. finally, the improved pll circuit used in the frequency synthesizer is composed of the improved vco, phase / frequency detector and charge pump. hspice simulation results show that the pll performance is better than other plls implemented by other vco in the same cmos technology

    綜合以上的研究與設計，本文用所改進的壓控振蕩器、無死區鑒相器及電荷泵電路組成了用於頻率合成的鎖相環電路，並對此電路進行整體設計及模擬，結果表明其在鎖定時間、頻率范圍、輸出相位抖動及功耗方面具有較好的性能，且對提高鎖相環頻率合成器的整體性能有一定的作用。
  16. This paper analyses and sums up the growing trends of the in - vehicle network so as well as the can - bus, smartly describes the mechanism of can protecol. the vechile elctronic techonology has developed into a phase of information and intelligence, for the competition of " infomatic design " has justly emerged. from the points of in vechile networks and can - bus ( controller area network ), this paper bring developed the viberation roller competing tester, and the vechile digital lcd dashboard. when developing the two electic devices, uses different serial communication buses, as can, i2c, spi, etc. these attemptes improve the complexity of whole control system, and enhance the performance of the instrumentes

    論文對國內外車輛網路和can介面技術的發展現狀和趨勢作了分析和綜合，簡明地介紹了can總線協議及工作機理。論文從車輛網路和can （ controllerareanetwork ）總線的角度出發，研製了振動壓路機壓實儀和車輛數字液晶組合儀表。在研製過程中，綜合應用了如can ， i ~ 2c ， spi等多種串列介面和新型電子器件，降低了車輛電子控制系統的復雜程度，提高了系統的性能。
分享友人
分享到 Line

分享到臉書