表面狀態 的英文怎麼說

中文拼音 [biǎomiànzhuàngtài]
表面狀態 英文
apparent condition
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
  • 狀態 : status; state; condition; state of affairs: （病的）危險狀態 critical condition; 戰爭狀態 state o...
  1. Effect of pyrite surface oxidation on the desulfurization in coal flotation

    黃鐵礦表面狀態對煤浮選脫硫的影響
  2. Potato dextrose agar and grain medium were also used to identify fungi which were not determined by the primary culture. fungi were all secondarily cultured on sabouraud medium to observe the colony ' s texture, colour, growth rate, surface status and reverse pigment. the fungi should be examined by microscope to inspect their microscopic structure from 7th day to 21st day

    使用的培養基有沙氏培養基、土豆培養基、真菌試驗培養基和5種種子培養基，連續培養4周，並隨時觀察菌落的色彩、生長速度、表面狀態、背面顏色等，並從第7天?第21天連續鏡檢以檢查真菌的顯微結構，綜合菌落形態和顯微結構，以確定真菌的種屬。
  3. The photograph of sem showed that its surface have homogenously coated with nickel, although the hollow glass beads were crashed by agitation and heating. after pretreatment and nickel plating, the dispersity of mica powders evidently improved and the infrared emissivity decreased from 0. 85 to 0. 43, and has certain wave absorbability of radar

    對雲母的化學鍍鎳工藝研究中，發現經過預處理后雲母表面獲得了鎳層，通過掃描電鏡分析，鍍鎳后雲母的分散性提高，表面狀態發生了較大的變化，法向積分發射率顯著降低，由0 . 85降低為0 . 43 。
  4. Metal joinery. windows, curtain walling, metal frame panels. protection against corrosion and conservation of surface conditions

    金屬細木工.窗幕墻和金屬框板.防銹和表面狀態的保護
  5. Metal joinery - windows, curtain walling, metal frame panels - protection against corrosion and conservation of surface conditions

    金屬細木工.窗幕墻和金屬框板.防腐及表面狀態保護
  6. To change the surface condition of electrode and the potential distribution of boundary layer through adsorption, thus affecting the electrode process ; b

    通過吸附改變電極表面狀態及界面層中的電勢分佈，影響電極過程； b
  7. The new method of direct determination of micro amounts of elements in electrician silicon - steel chips is based on the high performance of pw 2400 x - ray fluorescence spectrometer system and its software. it can correct both the matrix effect and the influence of sample physical status. specimens of steel chips can be determined directly without any pretreatment. the method has high accuracy and precision, the operation is easy and the analysis is fast

    報道了x射線熒光光譜法直接測定電工硅鋼鋼屑樣品微量元素的新方法，校正了樣品中元素間的基體效應影響和校正了鋼屑樣品的不同顆粒結構，不同幾何形態及不同表面狀態的影響，使鋼屑樣品可不經處理直接測定，操作簡便。
  8. Final results indicated that the way being fit for plating copper on the surface of carbon fibers was that carbon fibers were oxidized in hot air and boiled in nitric acid at high temperature

    試驗發現採用熱空氣和濃硝酸聯合氧化的方法可使碳纖維獲得適于鍍銅的表面狀態。
  9. Hard chrome - coated surface. surfaces : mirror, halfmirror, fine mist and mist. jacket spiral cooling water forced heat exchange

    表面鍍硬鉻潞，鏡面、半鏡面、細霧面和霧面四種表面狀態。夾套螺旋式冷卻水強制熱交換結構。
  10. The variations of the surface state and environment conditions could change the procedure of exfoliation, therefore, the potentiometry and electric resistance methods in this paper are used to measure the exfoliation rate of aluminum alloys in a constant temperature, the experimental results show that relations of natural corrosion potential vs time have a resemblance to those of corrosion rate vs time, both relations are all at the different change rates in the front and back of 120 minutes

    超硬鋁合金表面狀態、環境條件的變化，均可能改變剝蝕的發展過程，為此，本文提出在恆溫條件下，用電位法、電阻法定量研究鋁合金的剝蝕性能。實驗結果顯示了lc4cs鋁合金的自腐蝕電位與時間的關系，和腐蝕速率與時間的關系有著十分相似的規律，兩者均在120分鐘前後有不同的變化。
  11. The sto, ybco and sto / ybco thin films were deposited on laalo3 ( 001 ) ( lao ) substrate by pulsed laser deposition ( pld ). the effects of deposition parameters, such as the substrate temperature, the of target - substrate distance, laser energy density, on the properties of the thin fillms were systematically studied. the surface morphology of the thin films was investigated by atomic force microscopy ( afm ) and scanning electron microscopy ( sem )

    採用脈沖激光沉積技術在laalo3 （ 001 ） （ lao ）基片上生長ybco 、 sto以及sto / ybco集成薄膜，系統研究了基片溫度、基片表面狀態、氧分壓、激光能量密度、脈沖重復頻率等工藝參數對薄膜表面性能、結晶情況的影響，優化了ybco 、 sto薄膜生長的工藝參數，運用afm 、 sem 、 xrd等分析手段表徵薄膜的微觀性能，分析結果表明：薄膜表面平整、結晶良好、 c軸織構。
  12. Sem standard test method for scanning electron microscope analysis of metallic surface condition for gas distribution system components

    氣體分配系統組件用金屬表面狀態的掃描式電子顯微鏡
  13. Pressed - on assemblies. dimensions, tolerances and surface condition of usual assemblies

    固定環連接.尺寸公差和常用組件的表面狀態
  14. Press polishing not only possess the characteristic and advantages of polishing, but also can it change the dried surface into a smooth mirror

    壓光不但能具備上光的效果和優點，而且能夠改變乾燥后的上光塗層的表面狀態，使其形成理想的鏡面。
  15. Abstract : the influence factors, such as the composition of base sheet and galvanizing liquid, the strip surface condition, the temperature of galvanizing and sheet entering zinc pot, on the performances of zinc coat are described

    文摘:論述了熱鍍鋅原板化學成分、帶鋼表面狀態、鋅液成分、鋅液溫度和帶鋼入鋅鍋溫度對熱鍍鋅鋼板鍍層性能及表面狀態的影響。
  16. Surface - state charge density

    表面狀態電荷密度
  17. Test method for energy dispersive x - ray spectrometer analysis of metallic surface condition for gas distribution system components

    氣體分配系統元部件用金屬表面狀態的能量分散x射線分光光譜分析試驗法
  18. According to the requirement of innovation engineering in chinese academy of sciences, the work in this thesis focused on fabrication of soi material with epitaxial layer transfer of porous silicon and study of luminescence of modified porous silicon, and we obtained the following new results : the effect of doping and anodizing condition on the properties of porous silicon, including the microstructure, ciystallinity and surface morphology, has been studied systematically. it is found that the porous silicon and substrate have the same orientation and share a coherent boundary. but at the edge of pores, the lattice relaxes, which induces xrd peak moving of porous silicon

    Soi技術和多孔硅納米發光技術研究是當今微電子與光電子研究領域的前沿課題，本文根據科學院創新工程研究工作的需要，開展了多孔硅外延層轉移eltran - soi新材料制備與改性多孔硅發光性能的研究，獲得的主要結果如下：系統研究了矽片摻雜濃度、摻雜類型和陽極氧化條件等因素對多孔硅結構、單晶性能和表面狀態的影響，發現多孔硅與襯底並不是嚴格的四方畸變，在多孔硅/硅襯底的界面上，多孔硅的晶格與襯底完全一致，但在孔的邊緣，多孔硅的晶格發生弛豫。
  19. There exists a strong correlation between initial surface morphology prior to ht growth and ht gan growth mechanism and eventual threading dislocation density in epilayers

    發現高溫生長前樣品的表面狀態對隨後生長的gan生長機制及最終外延層中的位錯密度有很大影響。
  20. Surface texture standards kit

    表面狀態標準匯編
分享友人
分享到 Line

分享到臉書