衰減極點 的英文怎麼說

中文拼音 [shuāijiǎnjídiǎn]
衰減極點 英文
attenuation pole
  • 衰 : 衰動詞（衰弱） decline; wane
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 衰減 : attenuation; decay; damping; reduction; rejection; weakening; deamplification; dampening; dying o...
  • 極點 : 1 （頂點） limit; top; apotheosis; perfoot; the extreme; the utmost; culminating point; [數學] ve...
  1. At last distribution functions of load modes in life service are presented. based on the resisting force model and load model, the limit state equations of rc bridge are formulated. according to the resisting force is time - dependent and vehicle load is the non - gaussian distribution, jc method is applied to calculate the time - dependent reliability index of rc bridge

    在抗力衰減模型及橋梁荷載模型的基礎上，將可靠度理論引入橋梁結構的評定中，推導出了橋梁結構耐久性極限狀態方程，並根據耐久性極限狀態方程中抗力是時間的函數，以及車輛荷載為非正態分佈的特點，應用當量正態法（ jc法）編制相應的程序計算橋梁構件的時變可靠度指標。
  2. Then the behavior of the free joint when we bring the periodic perturbation through controlling the actuated joint is analysed, we can find in the result that the behavior of the free joint in the phase plane follows an ordered closed trajectory with the center equilibrium point + 2 in the case where the amplitude of the input is small, we can define a weakening factor to make the position of the free joint reach the center equilibrium point + 2

    通過相平面分析的方法分析了當驅動臂施加周期擾動對非驅動臂運動的影響，其結論為通過調整驅動臂周期擾動的幅度及極性，可以使非驅動臂沿著圍繞平衡點2的極限環軌跡運動。在此基礎上，提出衰減因子的概念，通過衰減因子調整驅動臂擾動的幅度和周期，使非驅動臂能夠穩定在平衡點2 。
  3. Through comparing and analyzing of bearing capacity, development of crack and strain of reinforced, the results show that the load - deflection plots f or specimens from the finite element analysis agree well with the experimental data, and choosing the rightful stress - strain relationship, utilizing ansys program, the test process can be well simulated. at the same time, making used of the program, the traditional shear wall is analyzed. it shows that comparing with the traditional shear wall, the hollow shear wall ' s cracking load drop 16 %, yield load and failure load drop 13 %, stiffness drop 13 % ~ 22 %

    其次在試驗的基礎上，將試驗手段、有限元數值模擬方法和理論分析結合起來，利用有限元程序ansys對其中的兩片墻板進行非線性有限元分析，並對前後的承載性能，裂縫發展、鋼筋應變進行了比較和分析，結果表明有限元節點模型分析的荷載-位移曲線和試驗測得數據符合良好，選用合理的材料本構模型，利用ansys可以較好的模擬試驗過程；同時利用有限元模型對比分析了普通剪力墻和空心剪力墻，空心剪力墻與普通剪力墻對比，其開裂荷載下降16 ，屈服荷載、極限荷載下降13 ，剛度下降13 22 ，開裂至屈服、屈服至極限荷載階段的剛度衰減規律與普通剪力墻基本一致，空心剪力墻的後期剛度比較穩定。
  4. In this paper, we analyzed the theory of several linear methods for the pole extraction, such as prony method, kt method and matrix pencil method. then, numerous results based on scattering responses synthesized from weighted sums of two exponentially damped sinusoids are provided to compare theirs performance

    本文主要分析了幾種極點求解線性演算法? ? prony法、 kt法、矩陣束法的基本原理，並比較了這幾種演算法對于只含兩個指數衰減信號模型參數估計的模擬結果。
  5. Lithium manganese oxides have advantages as the positive active materials for lithium - ion batteries, such as non - toxicity, low cost etc. however, the capacity fade of lithium manganese oxides makes its application difficulty

    鋰錳氧化物由於具有污染低，價格便宜等優點，己經成為最有吸引力的鋰離子電池的正極材料。但其容量衰減、循環壽命短等問題，成為困擾它商品化應用的主要障礙。
分享友人
分享到 Line

分享到臉書