補償反射 的英文怎麼說

中文拼音 [bǔchángfǎnshè]
補償反射 英文
compensatory reflex
  • 補 : Ⅰ動詞1 （修理; 修補） repair; mend; patch 2 （補充; 補足;填補） fill up; add supplement; supply; ...
  • 償 : 動詞1. （歸還; 抵補） repay; compensate for 2. （滿足） meet; fulfil
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 補償 : compensate; make up; make up for; make it up to sb. ; make sth. good; compensation; offset
  1. The scanning mirror system is execution component to compensates error brought by image movement. it is main component of aerial camera

    本文所研究的掃描反射鏡系統是斜視航空相機實現像移補償的執行元件，它是航空相機的重要組成部分。
  2. Some gas - sensitive test to deoxidizing gas have carried out based on tio _ 2 films by sputtering and doped some impurity. the experimental results showed that tio _ 2 films have different electron injecting principle and reactive mechanism, the behaviors of gas - sensor for hydrogen and ethanol manifest dissimilitude. this is due to that the oxygen vacancies were compensated by the impurity

    用濺射制備的薄膜摻入部分雜質對還原性氣體進行氣敏測試，發現tio _ 2薄膜對酒精氣體和氫氣有不同的反應機制和電子注入機理，氣敏特性也表現出不同，而雜質的引入反而降低了tio _ 2薄膜的敏感性，可能是由於雜質對氧空位的補償所引起。
  3. Any process that will compensate for such distortions of the initial pulse should improve reflection quality.

    任何補償這類初始脈沖畸變的處理，都能改善反射波的質量。
  4. The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on

    主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。
  5. The data processing part includes fft, filter and averaging, calibration algorithm, smith chart designing, s - parameter algorithm, transmission and reflection caculating, etc. the hardware interface consists of control information protocol, data transfer protocol, status information protocol and the synchronization protocol of the transfer of all the above information

    數據處理部分包括快速傅里葉變換、濾波與平均、用s參數表示的傳輸反射特性演算法、表示阻抗特性的史密斯圓圖演算法、校準補償演算法、以及實時測量的實現演算法等。介面部分包括控制信息協議、數據傳輸協議、狀態信息協議以及上述各種信息傳輸的同步協議。
  6. In addition. in cases where the subjects are too far away from cameras or where filters are used, certain exposure compensations are needed

    還有就是，距離主體太遠或濾光片的使用都會減弱光線從主體反射進相機，所以拍攝者必須就此作出適當的曝光補償。
  7. Application of automatic polarization compensation in testing system

    偏振自補償全反射棱鏡在液晶測試系統中的應用
  8. It analyses the causes to bright image movement, studies principle to compensate image movement, conforms project to compensate image movement, and designs framework to compensate image movement in the article ; to analyze and design configuration of the scanning mirror, to select matters of mirror and its support structures on the principle of consistent line expansion coefficient ; to ascertain type of moment electromotor by most rotating angle speed and most rotating moment which are required by loads in the period to take pictures, as well as by figuration size of electromotor ; to design retarder according as the electromotor parameters ; to design and optimize lightweighted mirror shapes, because the mirror is key part ; to design flexure support structure, to analyze static and dynamic characteristics of the support structure by name of patran program for validating desig n rationality ; to study function of the scanning mirror electric control system ; to test precision of the system, the results indicate the rationality of design of the scanning mirror system

    本文通過分析像移產生原因、研究像移補償原理，確定像移補償方案，並根據像移補償原理設計補償機構；分析與設計掃描反射鏡系統結構，根據材料線膨脹系數一致原則，選擇反射鏡及其背部支撐的材料；由掃描反射鏡在擺掃周期內的最大擺掃角速度確定力矩電機的額定轉速，根據負載力矩確定電機的額定轉距，綜合電機外型尺寸等因素，確定執行元件? ?電機的型號；根據所選電機的參數指標，設計1 ： 6速比的減速器；利用patran軟體對掃描反射鏡系統中的關鍵件? ?反射鏡進行輕量化設計與優化；設計反射鏡柔性支撐結構，並通過軟體分析支撐結構的力學特性，驗證反射鏡柔性支撐結構設計的合理性；從原理上研究掃描反射鏡控制系統功能；進行系統精度測試，測試結果表明掃描反射鏡系統設計的合理性。
  9. With the high accurate transfer function it is possible to design frequency characteristic compensator to eliminate the mechanic resonance frequency characteristic of the control object. the fast steering mirror system closed bandwidth is no longer restricted by the mechanic resonance frequency and the closed bandwidth is expanded effectively

    在獲得對象的高精度傳遞函數以後，使用零極點對消的方法補償系統的機械諧振，有效地擴展了快速控制反射鏡系統的帶寬，使快速控制反射鏡系統的閉環帶寬不再受制於系統的開環諧振頻率。
  10. Finaly, to reduce the reflected volt of the middle element, namely compensating mutual coupling, we may put metal between the elements in its e - faces because in this place the mutual coupling effects is much more serious

    最後，為了減小陣列中心陣元的反射電壓，在陣元間互耦效應大的e面方向加置一層金屬條塊進行互耦補償，討論了不同掃描角下周圍陣元對中心陣元的影響。
  11. At first the leaking of the strobe pulse and its removing method are introduced. and then the timing jitter and its compensation method are introduced

    首先，介紹了選通脈沖泄漏及其去除方法;其次，介紹了時基抖動及其補償方法;最後，介紹了反射及其去除方法。
  12. By calculation to fact examples, we confirmed the reliability of that testing method, and make comparison with the method of compensation reflection inside the asphere

    通過實例計算驗證了該檢驗方法的可靠性，並與內部反射補償檢驗非球面的方法進行了比較。
  13. If they are observed under polarized light with a red compensator, they appear yellow ( negatively birefringent ) in the main ( " slow " ) axis of the compensator and blue in the opposite perpendicular direction

    如果用紅光補償棱鏡在偏振光下觀察，在補償棱鏡的主（ 「慢」 ）軸方向呈黃色（反雙折射）而在相反的垂直方向呈藍色。
  14. Centering at soft x - ray multilayer uniformity technology, we introduce general situation of multilayer, design of multilayer structure, simulation calculation, ion - beam sputtering deposition and evaluation of samples. above all, we carry out study of improving uniformity of period thickness spatial distribution, and develop correction mask for controlling period thickness. as a result, we improve uniformity from 4. 5 % to 2. 0 %, the error of period thickness on ( 130nm field is controlled within 0. 18nm, and the reflectivity reach 35 % at center wavelength 17. 1nm

    特別地，我們設計並應用膜厚擋板補償技術控制多層膜的膜厚分佈，將膜厚分佈非均勻性從4 . 5減小到2 ，周期厚度絕對差值控制在0 . 18nm以內，並且制備得實際多層膜樣品在中心波長17 . 1nm處實測反射率達到35 ，達到實用水平。
  15. The mutual coupling between phased array antennas elements causes the loss of reflected power. following the changes of scanning angle, mutual coupling between elements will also change, so the comensation of mutual coupling should become difficult

    相控陣天線單元間由於互耦效應引起的反射功率損耗，隨著掃描角的變化而隨之發生變化，這給互耦補償帶來了極大地困難。
  16. Then, after the structure and characteristic of awg is described in brief, we put emphasis on the deduce of the dispersion equation of ufbgs in the vicinity of its reflection band gap ( rbg ) in light of coupling theory. in terms of this equation, the dispersion compensation of the optical signal in every channel in the wdm system, which has eight channels, is calculated and analyzed theoretically. during the course, some important parameters of ufbgs in the compensator are computed

    在簡要敘述了陣列波導光柵的結構及其特性后，著重從光纖光柵耦合波理論導出了均勻光纖光柵在反射帶隙（ rbg ）外附近的色散特性方程，並根據這一特性方程，對8通路的wdm系統中各分亡巴八碩士學位論文tinv坯1 ： e 』 sthe狠波光信號的色散補償進行了數值計算與分析，由此確定補償器中各均勻光纖光柵的相關參數。
  17. Three different compensators are discussed respectively by means of both parameters of reflective amplitude coefficient ratio

    引入反射振幅系數比的兩個參數分別對這3種不同結構組成的補償器進行討論。
  18. The results show that these reflective phase compensators own some advantages of high - reflectivity, continuous tunable phase compensation etc

    分析結果表明，這些反射型相位補償器都具有反射率極高、相位補償連續可調等優點。
  19. The experimental results show that the fiber phase conjugator can compensate for the beam distortion cased by thermal effects of amplifier and 60 % sbs reflectivity can be reached

    實驗結果表明，光纖相位共軛鏡能很好補償放大器熱效應造成的光束畸變，在100hz時獲得近60的sbs反射率。
  20. In order to make new optical devices with photonic crystal, three reflective phase compensators made of 1 - d photonic crystals are investigated with transfer matrix method and numerical value calculation

    摘要為了製作新的光子晶體器件，採用傳輸矩陣法，通過數值計算，研究了3種一維光子晶體製作的反射型相位補償器。
分享友人
分享到 Line

分享到臉書