計算矩陣 的英文怎麼說

中文拼音 [suànzhèn]
計算矩陣 英文
computational matrices
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • : Ⅰ動詞1 (計算數目) calculate; reckon; compute; figure 2 (計算進去) include; count 3 (謀劃;計...
  • : 名詞1. (畫直角或正方形、矩形用的曲尺) carpenter's square; square2. (法度; 規則) rules; regulations 3. [物理學] moment
  • : Ⅰ名詞1 (作戰隊伍的行列或組合方式) battle array [formation]: 布陣 deploy the troops in battle fo...
  • 計算 : 1 (求得未知數) count; compute; calculate; reckon; enumerate 2 (考慮; 籌劃) consideration; pla...
  • 矩陣 : [數學] matrix; array
  1. The overall idea is that the system of robotic manipulators is decomposed as two parts : one is nominal system with perfect knowledge of dynamic model and the other is system with uncertainties. ctc is used to control nominal system. for uncertainties system, we utilize the regressor of robotic system or bounding function on uncertainties to design

    基本思想都是將不確定性機器人系統分解成標稱系統和不確定系統:對于標稱系統,採用控制;對于不確定系統,利用機器人系統的回歸或集中不確定性上界的包絡函數,設不同的補償控制器。
  2. This thesis investigates parallel solving the generalized eigenvalue problem ax - bx deeply, and proposes some new algorithms

    本文從理論和實驗兩方面深入研究了分散式環境下實廣義特徵值問題ax = bx的并行,提出了一些新的演法。
  3. The property of symmetry can also be used to save a part of the computational effort required for matrix inversion or for a solution of equations.

    對稱的特性也可用來節省求逆中或求解方程中所需要的一部分量。
  4. In the self - calibration scheme, the thesis emphasizes the accuracy of camera intrinsic and extrinsic parameters. we presents an accurate f method based on corresponding point adjustment. the method adjusts coresponding points according to the fixedness of projective transformed cross ratio, then calculates f matrix accurately through linear and non - linear methods. when computing intrinsic parameter, a matrix, we simplify the step, and stress on the two important parameters of a. the result will be getten through solving kruppa equation based on svd decomposition. in order to compute extrinsic parameters, we use linear method to get initial r and t, then apply non - linear method to accurate them

    提出了基於匹配點調整的f求精方法,先根據攝影交比不見性對手工選擇的匹配點進行調整,再用線性、非線性結合的方法求精f;在內部參數a中,進行了一定的簡化,把重心放在a中重要的兩個參數上,用svd分解法kruppa方程;在外部參數時,首先用線性法求解r 、 t ,然後再用非線性法迭代求精。
  5. In order to satisfy the veracity and the robustness against time - variable noise of the aoct, a new square root kalman adaptive filter arithmetic with time - variable noise statistic is presented in this paper. in addition, the wavelet analysis is applied to inspect the singularity of the measured current, and an adaptive signal - noise decomposer for aoct is designed

    為了滿足aoct自適應控制的準確性和時變噪聲魯棒性的要求,論文將kalman濾波理論引入到自適應濾波中,並應用理論提出了一種新的時變噪聲統的平方根kalman自適應演法。
  6. The use of matrix methods in structural analysis has only been boosted by the introduction of digital computers.

    由於數字機的出現才促進了結構分析中方法的應用。
  7. For the anticounterfeiting of printings ( such as certificate ), the existent many ways ( such as rainbow holograms ) are not available as the need for special use : anti - distortion and anti - copy. basing in the double - random - phase transform, this article puts forward a new way that two - dimensional bar code is used as anticounterfeiting label with anti - printing ? scanning and anti - damage properties. the major job are : ( 1 ). basing in the ascii codes, numerals and alphabets are encoded and subsequently transformed into two - value bar code matrix figure. later, using amplitude - based double - random - phase transform, the enciphered gray scale figure is formed. by computer simulation ( 4f system ) and printing as well as scanning ( 20 times ), we get the result that the gray scale figure with little miscoding rate ( 0. 0026 ) by “ matrix expanding way ”

    本文主要開展了以下三項研究工作: ( 1 ) .用自定義編碼方案,將數字和字母( ascii碼)轉換成二值條碼圖;對該圖形進行振幅型雙隨機相位加密變換,得到原信息的加密灰度圖;通過4f光學系統機模擬和列印-掃描實驗,證明本文提出的「擴展法」灰度圖具有較小的誤碼率,對於20次列印-掃描實驗,誤碼率不大於0 . 0026 。
  8. Abstract : large time delay exists in complicated practical processes. for example, in fccu ( fluidized catalytic cracker unit ) reactor - regenerator, the feed is preheated through heat exchanging from fractional column slurry, thus results in large time delay. a predictive control system is designed for such processes, where the kernal algorithm is dynamic matrix control. application results show that the control behavior is improved than original pid control

    文摘:實際的復雜工業過程,往往具有大的時滯,例如:煉油廠催化裂化裝置的反應再生系統,其原料油預熱通過油漿換熱實現,因此時滯特別大.本文針對這一類大的時滯過程,設了以動態控制為核心演法的預測控制系統,運行實踐表明:這一控制方案比原pid控制在控制質量上有較大提高
  9. ( 4 ) on the efficient method for the dynamical core of the new generation multi - scale forecasting model i ) we present a new multi - level sparse approximate inverse preconditnioner for the complicated 3 - d helmholtz equations in the new generation weather forecasting model. as a result, the new sparse approximate inverse preconditioned gcr and gmres algorithms are given and successfully applied in the dynamical core. numerical tests show that the new algorithms perform very efficiently, and can greatly improve the efficiency of numerical model

    對此,本文提出了一種基於逐層門限技術的近似逆稀疏模式預選方法,並構造了相應的稀疏近似逆預條件子,結合gcr演法和g州[ r衛s演法,首次將逐層門限稀疏近似逆預條件子應用於新一代多尺度預報模式動力內核的實際,數值實驗表明這里給出的方法可以大大提高數值模式的效率。
  10. Among them the gray level co - occurrence matrix ( glcm ) and gray gradient co - occurrence matrix ( ggcm ) methods, which attributed to the statistic textural analysis scheme were then chosen to extract the textural features of five kind areas on satellite images. in the second part the principle of classification and bp neural network were introduced. combined with textural features, the improved bp neural network successfully performed on the classification of the satellite images

    論文的第一部分介紹了進行紋理特徵研究的一些典型的方法,利用其中的基於統的紋理分析法中的灰度共生以及灰度一梯度共生法,分析了衛星雲圖上五類區域的紋理特性;第二部分主要介紹了遙感圖像分類原理以及神經網路中的bp演法,在對演法原理進行深入理解的基礎上,把紋理特徵與神經網路進行組合,實現對衛星雲圖進行分類分析;第三部分內容是在前面圖像分類結果的基礎上,對序列圖像用相關匹配法進行運動分析,反演雲跡風風場。
  11. Compared with the traditional methods of window functions and remez optimal algorithm, the optimum algorithm, the optimum design method in the paper need not compute inverse matrix, thus overcoming the difficulty to compute high - order inverse matrix in remez optimal design method

    與傳統的窗口函數法和雷米茲優化設方法相比,其優化設方法不需要計算矩陣的逆,因而克服了雷米茲優化設方法求高階逆的困難。
  12. Calculates the inverse of a matrix

    計算矩陣的逆
  13. The astringency, error and stability of the numerical method are researched. zero matrix method, constant matrix method, and jacobian matrix method are constructed in order to improve numerical precision and efficiency. the steps for calculating matrix exponential function using pade approach method are given out

    研究了所提西安理工大學博士學位論文數值方法的誤差、穩定性、收斂性等數學性質,在精度和效率兩方面提出了一些改進措施,構造了零法、常數法、雅可比法等格式,給出了利川pade逼近計算矩陣指數函數的求解步驟。
  14. Firstly, with the help of angular momentum coupling theory, the hamiltonian for multi - electron adorns is rewritten in terms of spherical tensors. the advantage of this form is that the radial, angular and spin parts are separated completely, which makes it easy to calculate the angular matrix elements by means of irreducible tensor. secondly, theoretical expressions of the relativistic corrections including the relativistic mass correction, the darwin correction terms, the electron - electron contact terms and the orbit - orbit interaction which contribute to the non - relativistic energy for two - electron atom are theoretically derived in the lsmlms scheme

    具體內容包括:首先,藉助角動量耦合理論,將多電子原子哈密頓符中的自旋-自旋、自旋-其它軌道以及軌道-軌道相互作用全部改用球張量表示,這種球張量形式的優點在於已將原子哈密頓符中的徑向、角向和自旋部分完全分開,從而便於計算矩陣元,而且角向元可以方便地利用不可約張量理論來進行
  15. To further speed up the solution of scattering from three dimensional electrically large object by multilevel fast multipole algorithm ( mlfma ), a local multilevel fast multipole algorithm ( lmlfma ) based on local interactions is proposed to evaluate matrix - vector multiplication

    摘要為了進一步加速多層快速多極子演法求解電大尺寸目標電磁散射,提出了一種基於局部耦合技術計算矩陣矢量相乘的多層快速多極子方法。
  16. A neural network algorithm for

    一種計算矩陣特徵值特徵向量的神經網路方法
  17. On the confirmation of the eigenvalues and the eigenvectors of matrix

    用神經網路計算矩陣特徵值與特徵向量
  18. A neural network algorithm for computing matrix eigenvalues and eigenvectors

    一種計算矩陣特徵值特徵向量的神經網路方法
  19. 6 kinds of methods to calculate the high power of matrix are given and examples of applying each method are explained

    摘要代數中高次冪的運量較大。針對不同類型的,給出計算矩陣高次冪的6種方法,並對其應用進行舉例。
  20. The combined simulation matrix of a finite number of primitive parts is deduced by the finite difference control volume conservation method and interaction principle, based on the fundamental physical laws

    通過控制容積法及相互作用原理,導出了空調元件有窮組合的模擬計算矩陣
分享友人