設備負荷系數 的英文怎麼說

中文拼音 [shèbèifùhéxìshǔ]
設備負荷系數 英文
apparatus load factor
  • 設 : Ⅰ動詞1 （設立; 布置） set up; establish; found 2 （籌劃） work out : 設計陷害 plot a frame up; fr...
  • 備 : Ⅰ動詞1 （具備; 具有） have; be equipped with 2 （準備） prepare; provide with; get ready 3 （防備...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 設備 : equipment; device; facility; implementor; apparatus; installation; appointment; furnishing; setou...
  • 負荷 : [電學] load; charge; weight
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. From the view of engineering economies, this paper get objective function of equipment selection for ice - storage system, and get the optimal equipment selection, in which introduce into uniform annuity and correction coefficient of designing date load

    摘要從工程經濟學角度，引進等額年金，設計日負荷修正系數，得出冰蓄冷空調系統設備選擇的目標函數，對各參數進行賦值，求得最佳的系統設備選擇，並用一個工程實例驗證，結果表明此數學模型是有效的。
  2. Analyses the determination of surface heat transfer coefficient, interior building envelope load, air infiltration load, equipment load and heat storage load, etc

    摘要分析了民用建築舒適性空調負荷計算中表面傳熱系數、內圍護結構負荷、滲透風負荷、設備負荷、蓄熱負荷的確定等問題。
  3. The results show that under the new power supply scheme, load rate of equipments, power factor of supply system and supply efficiency of system all have been greatly improved

    在新供電方案下，油田電網的設備負荷率、系統功率因數、供電效率都得到很大提高。
  4. Early exploited oilfields mostly adopt the power supply mode of single well & single transformer & single asynchronous motor, which causes that the load rate of equipments in oilfield network is low, the power factor of oilfield network is lower and the energy loss of oilfield network is bigger

    摘要早期開發的油田多採用「單井單變壓器單異步電動機」供電模式，造成油田電網的設備負荷率和系統功率因數過低，電網耗能較大。
  5. The paper discussed a method combining integer programming based on similarity coefficient with quadratic programming considering ratio of capacity to loading in workshop to obtain parts families and machines groups in two steps

    摘要採用了基於相似系數的整數規劃和考慮車間資源負荷分配比率的二次規劃相結合的方法，分兩步得到了零件族和設備組。
  6. It put out the system requirements from the whole structure, function structure, developing mode, user management, the design of software and database, safety design, system running efficiency, developing plan, etc. it put out the basic graphics operation, the module building and editing of the electrical network, the devices records and function management the devices operating management, the function producing the electrical subject chart, the outside interface function, the in - out function and webgis, etc. it discusses some advanced functions including the theory loss and practical loss computing of the distribution line, the reliability basic data producing and conversing tools, power cut management, the load supplying from other ways, the repairing management on user fault reports, th e new load installing assistant function, the management of hanging the cards and simulating operation, the monitonng and analyzing management of the running information, load monitoring and load density analyzing function and so on

    從系統總體結構，功能結構，開發模式，用戶管理，軟體和數據庫設計，安全性設計，系統運行效率，開發計劃等方面滿足了系統的總體要求；系統實現了基本圖形操作，電網建模與編輯，設備臺帳及運行管理，設備操作運行管理，電力專題圖生成，外部介面，輸入輸出， web - gis等基本功能;系統還具有配電線路理論線損計算及實際線損計算，可靠性基礎數據生成和數據轉換工具，停電管理，負荷轉供功能，用戶報修管理，用戶報裝輔助，掛牌管理和模擬操作，運行信息分析監控管理，負荷監控及負荷密度分析等高級功能:並能從運行方式，用戶權限，運行日誌三個方面闡述本系統的管理方式。系統總體結構合理，功能及介面齊全，配置擴展方便，可操作性強。
  7. Being basis on the 14 regional grid planning texts of historical data of hunan province, initially determining the factors that affecting power grid construction ; to reflect the distribution of information to determine the scale of construction leading indicators to assess the scale, with its own network of intelligence presented to the region to assess the scale of the distribution network - building indicators system ; establishes assessment models of evaluating 110kv distribution network building scale integrated ; considering the main factor that influencing the construction scale of the distribution network, the improvement method of 10kv distribution networks capacity - load ratio is proposed ; the combination of high voltage distribution network planning optimization technology results presented evaluation pressure distribution network building scale integrated assessment methods

    課題以湖南省14地區電網已有規劃文本歷史數據為基礎，初步確定各種影響電網建設的因素;以反映配電網建設規模的主導信息來確定規模評估指標，提出了符合自己網情的地區配電網建設規模的評估指標體系;建立了評價110kv配電網建設規模的綜合評估模型;通過研究各影響因素與負荷發展儲備系數參數的關系提出了確定10kv變電容載比的方法;結合高壓配電網規劃的優化技術成果，提出了評價中壓配電網建設規模的綜合評估方法。
  8. Stability of main steam pressure is the foundation of the key parameter stability ( include the main steam temperature, the vapor pack water level, the oxygen content in the smoke etc. ) in the units, deb system increase the dependability and the economy greatly with the settlement of the energy ' s equilibrium between the boiler and the steamer

    本機組利用先進的硬體設備dcs和優化的控制策略deb ，圓滿解決了機組協調控制系統中主汽壓力穩定性及負荷適應性這一主要矛盾。主蒸汽壓力穩定是機組一切關鍵參數（包括主蒸汽溫度、汽包水位、煙氣含氧量等）穩定的基礎， deb系統解決了機組鍋爐和汽輪機之間能量平衡，使機組可靠性和經濟性大大提高。
  9. From the calculation for the system of refrigeration, the choice of equipment, to the calculation for the temperature field and velocity field, the emphases is building model for evaporator in static state and dynamic state, do calculation and analyse for the whole space with temperature field and velocity field

    從製冷系統的負荷計算，設備的選型到溫度場和流速場的計算，其中重點是為蒸發器製冷劑側和空氣側參數建立穩態和動態數學模型，對整個冷庫的庫體空間進行溫度場和流速場的分析計算。
  10. With the development of the electrical power enterprise and computer technology, it is important to design a highly efficient ， better maintainable and graphic interface based software package for power system analysis and computing in the paper ， the author put forward a kind of new sensitivity analytical method which take into account load characteristic to fix on the weak bus, and with example to prove the exactness of the algorithm ; developed the visual electrical power system analysis and computing and graphic sporting system, the software package was developed by using the idea of object oriented programming ， the method of class ' s inheritance ， polymorphism and virtual function, and set up equipment - chart element - the interreaction between class this make it easy to expand, maintain and replant

    隨著電力事業和計算機技術的發展，研製高效率、可維護性強、具有良好用戶界面的圖形化計算分析軟體成為電力系統分析計算研究的重要任務之一。本文提出了一種計及負荷特性的靈敏度分析方法來對薄弱母線進行確定，並用算例驗證了演算法的正確性；開發了圖形化的電力系統分析計算軟體和圖形支持系統，該軟體完全採用面向對象的設計方法，充分利用了類的繼承、多態性質和虛函數的方法，建立起設備圖元類之間的相互關系，使軟體具有高度的開放性、可維護性、可移植性。
  11. The scale, facility, setup mode and the topper application are increasing, but the network management system still adopts a centralizing structure based on manager / agent model. in the centralizing structure, the network management system can ’ t change with the scale and complexity, which made the system bigger and bigger. all management logic is computing in one workstation, that will occupy too many bandwidth, depress performance and made the workstation become the weakest part, if the workstation overrun or dead, agent can ’ t come back because it must wait manager ’ s command

    目前，我國電信網路正處于高速發展中，網路的規模越來越大，設備種類越來越多，組網方式越來越多樣化，應用越來越復雜，但是網路管理系統仍然普遍採用管理員/代理的集中式管理方法，在集中式網路管理模式中，網管系統不能隨著網路規模和復雜度的變化而變化，致使網管系統越來越龐大;網路管理邏輯全部集中在一個管理工作站中計算，需要佔用大量的帶寬來傳輸設備數據，有效性差，同時管理工作站是系統中最脆弱的部分，一旦管理方超負荷或死機，代理方因為必須等待管理方的指令而無法恢復系統，導致系統崩潰。
  12. Why power quality questions are attracting attention increasingly has three chief reasons : the electricity load structure occurs the great change in the modern power system ; very sensitive to power quality control equipment and the electronic installation service based on the computer system of large numbers have been used ; in the power market under the operating mechanism, power is as the commodity, and users certainly puts forward the more and more higher requirement to the commodity quality

    電能質量問題之所以日益受到重視主要有三個原因：現代電力系統中電負荷結構發生了重大變化，諧波源的種類和數量增加；大量對電能質量非常敏感的基於計算機系統的控制設備和電子裝置投入使用；在電力市場運行機制下，電能作為商品，用戶必然對商品質量提出越來越高的要求。
  13. Air conditioning load, unit numbers of the chiller, location of the equipment, accessory equipment, and terminal equipment should be considered when choosing the heat pump system, noise and vibration to the surroundings are important factors

    在熱泵型機組的空調系統的選型中應考慮空調負荷、機組類型數量、安裝位置、附屬設備、末端設備等多項因素，特別注意噪音和振動對周圍環境的影響。
  14. With the broad application of the electrical and electronic technology in the industry branches and the power apparatuses, the number of non - linear loads is much more and more, and the capacity of them is biggish, so a mass of harmonic is injected into the power system, which produces the waves of voltage and current in power system to be aberrant seriously

    隨著電力電子技術在各工業部門和用電設備上的廣泛應用，非線性負荷數量越來越多，容量也越來越大，諧波大量注入電網，使電力系統電壓、電流波形發生嚴重的畸變。由於大多數儀器、儀表是針對工頻正弦波設計的，因而造成指示數據不正確。
分享友人
分享到 Line

分享到臉書