診斷輸出 的英文怎麼說

中文拼音 [zhěnduànshūchū]
診斷輸出 英文
diagnostic output
  • 診 : 動詞（診察） examine （a patient）
  • 斷 : Ⅰ動詞1 （分成段） break; snap 2 （斷絕;隔斷） break off; cut off; stop 3 （戒除） give up; abstai...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 診斷 : diagnose; diagnosis; diacrisis
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. Delayed computed tomography scan with excretory phase revealed contrast medium extravasation from the left upj, and left renal pelvis rupture was diagnosed

    但在延遲性的電腦斷層檢查后發現，顯影劑由左側腎盂輸尿管接合處滲出，所以診斷為左側腎盂破裂。
  3. In the part of detector, it mainly introduces the design of liquor tubes, heater, pressurize, and thermocouple ; in the part of controller, this design uses tms320lf2407 as the cpu. the design part mainly introduces controller circuit design which mainly contains data collection circuit, prepositive magnifying circuit, a / d convert circuit, failure self - diagnosis circuit, the tms320lf2407 interface circuit, temperature control circuit, display circuit, 4 ~ 20ma standard signal output circuit ; in the software part, it mainly introduces software chart of main program and partly linearization subprogram design

    檢測器部分重點介紹了導流管的設計、加熱器的設計、密封技術的設計以及測溫電路的設計;控制器部分以tms320lf2407為核心，重點介紹了控制器電路設計，主要包括數據選擇電路、前置放大電路、 a / d轉換電路、故障自診斷電路、 tms320lf2407介面電路、控溫電路、顯示電路、 4 20ma標準信號輸出電路共八個部分;軟體設計重點介紹了主程序軟體設計及分段線性化子程序設計。
  4. After getting online results, combustion expert controller gained relevant ratiocinate output results by integrating technical parameters of online inspected system, combustion computed results and diagnostic and manipulated countermeasure of knowledge base, then which could propose operator for choosing a suitable control method using concentrated corresponding rules

    在得到在線計算結果以後，燃燒專家控制器綜合在線檢測系統提供的工藝參數，以及燃燒計算的結果，使用存放在知識庫中的診斷和操作對策，得到相應的推理輸出結果；利用規則集的相應規則，提示操作工選用合適的控制方法。
  5. The information of fault recorder and microprocessor - based protection is collected which directly brought up to the central dispatch station, the central dispatch station deals with the information together. by the conclusion of central station method, a system of analysis and diagnosis on the hv transmission network which based on the theory of multitude intelligence agent is proposed

    方案由調度中心站和分站組成，分站採集到錄波器以及微機保護的信息后，直接上傳到中心站，由調度中心站進行統一處理，在基於中心站方案的基礎上，提出了智能多agent原理的高壓輸電系統分析與診斷體系。
  6. The autocad is developed using visu al basic6. 0 and objectarx in order to drive the autocad drawing. as a result, the drawing can dynamically display the work states of the air - condition controller and locate the component on the center of picture - window

    利用visualbasic6 . 0和objectarx實現了對autocad2000的二次開發，完成了動態顯示電路工作狀態以及圖形定位的功能，實現了故障診斷結果的圖形輸出。
  7. Endometriotic ureteral obstruction is a serious event commonly diagnosed late and which usually results in a high rate of renal loss before recognition

    子宮內膜異位造成的輸尿管阻塞是很嚴重的問題，通常較遲才被診斷出來而且有很高的比例造成腎功能喪失。
  8. Adding momentum item while correcting weight and limiting range of input value reduce error and improve diagnosis correctness greatly. while normalizing the input value, a new way is put forward that normalization is performed item by item according to its sort. in this way error training can avoid going into the flat field that is caused by existing of 0 or 1 of the input value

    本文首先分析了故障診斷和神經網路的基本理論，並在此基礎上提出了神經網路對于變壓器故障診斷系統的適用性；文中將bp神經網路演算法用計算機實現；並針對其本身存在的一些缺點提出了一系列改進措施，通過在修正權值的時候增加動量項，並且限制輸入值范圍來減小誤差、提高系統的診斷正確率；在對輸入數據進行歸一化處理的時候，採取按類逐項歸一化的方法，避免了輸入數據出現0或者1而使訓練進入平坦區。
  9. Based on the analysis of pressure transient change within the oil transfer pipeline, a real time pressure model of oil pipeline is set up. software and hardware of the diagnosing system for leak detection & location were developed and the indoor experiment as well as site test was performed

    本文對輸油管道壓力瞬變過程進行了分析，建立了管道壓力實時模型，研製出輸油管道的泄漏故障實時診斷系統的軟、硬體，完成輸油管道泄漏檢測及定位的室內試驗和現場試驗。
  10. Performance of the proposed damage detection approach is demonstrated by the analysis of xiang jiang transmission tower structure

    對湘江輸電塔架結構的數值模擬分析，表明本文提出的損傷診斷方法的結果是令人滿意的，具有實際工程應用價值。
  11. In this thesis, the feature of fault information on hv transmission network has been firstly studied. a method of analysis and diagnosis on the network fault which based on fault recorder information associated with the network is proposed

    本文首先研究了高壓輸電網故障信息的特點，提出了基於故障錄波器故障錄波信息聯網組成的電網故障分析與診斷系統的方案。
  12. 1. the electrical system adopts programmable controller plc to control digital output and input apparatus. the control system includes security logic control and breakdown diagnosis system

    1電氣系統採用可編程式控制制器plc控制配備數據輸入輸出裝置，控制系統包括安全邏輯控制及故障診斷系統。
  13. In the middle 1960s, it began to be applied in detecting the fault of electronic facility in foreign countries. in the 1970s, thermal instrument had been installed in helicopter to detect the connection of power line and the determinant standard about infrared test had been established. in the middle 1980s, ir technology had a comprehensive application on the fault of print circuit board ( pcb )

    國外應用紅外技術檢測電氣設備故障始於六十年代中期，七十年代開始把熱像儀裝在麵包車或直升機上對變電站設備或高壓輸電線路連接件故障做巡迴檢測，並分別制訂出相應的技術規范或紅外診斷故障判定標準。
  14. A x - band six - cavity tro is studied. with the voltage 760kv 6ka and the magnetic field 2. 6t in the simulation, output power is about 1. 5gw is obtained, and interaction efficiency is 31 %. a noveland high accurate numerical synthetic technique is presented for determining the high frequency characteristics of six - cavity with open boundary

    對粒子模擬的輸出微波功率的作出診斷，找到讀取微波功率快速有效的方法：在電場和磁場同相的前提條件下，對時域波形進行傅立葉變換，微波功率頻域的二倍頻所對應的幅度即為微波x波段渡越輻射振蕩器的理論和實驗研究平均功率的大小。
  15. Then the difference between the output of the trained neural networks and that of the actual system is used as a residual, which detects the sensor fault. the diagnosis can then be performed by further exploiting the information provided from the residual signals according to certain rules introduced in detail in the thesis. simulating results show that the method can isolate any fault of the sensors in any input types and normal work frequencies

    模擬結果表明，基於神經網路觀測器的故障診斷方法在系統正常工作頻率范圍之內，不受系統輸入類型和故障的類型的影響，只要故障對系統的特性發生影響（系統參數漂移3 ） ，通過神經網路觀測器的殘差判別函數可以診斷出故障。
  16. This paper put forward a method of using amending sine value in the spwm sine table. this method can correct the distortion of the output voltage waveform, which resulted from the dead time used to the voltage type whole bridge main circuit. the inverter system adopts digital fuzzy controller with feed forward correction and which proportion coefficient and integral coefficient is changeable, so dynamic response is improved

    本文提出了一種採用修補spwm正弦表值的方法，用以改善電壓型全橋逆變主電路因上下橋的功率器件切換時先關斷后導通的死區時間而引起的輸出電壓波形畸變；逆變系統採用帶前饋校正的變比例變積分系數的模糊控制器，提高了系統的動態響應指標；系統設計了完善的保護措施，並具有市電電網的故障診斷功能。
  17. By using the psu / ncar mm5 model, we made a numerical simulation about the severe sand - dust storm that occured in the north china on 20march in 2002

    20 」強沙塵暴天氣過程進行了數值模擬，並利用模式輸出的各物理量對沙塵暴進行診斷分析，得出了華北地區沙塵暴的形成、發展機制。
  18. Secondly, according to these models, the measuring errors of the systems are decomposed into the component errors and traced to their sources, i. e. the units within the measurement system. lastly, accuracy - loss diagnosis of each system is performed based on the decomposing and tracing results of the output errors. the units are diagnosed, which are the main factors of the accuracy loss of the whole system

    在實踐上，以兩套實際的測量系統為研究對象，分別對其實際的動態測量誤差進行了建模、分解與溯源，將系統的輸出總誤差追溯到各單項誤差源? ?系統內部各組成單元所產生的誤差；而後，以誤差分解與溯源的結果為依據，分別對兩套系統進行了精度損失診斷，並分析了系統中對總的精度損失影響最大的環節，此結果可為測量系統的設計者提供系統優化設計依據。
  19. In visual c, even using warning level 4 generates no diagnostic output

    在visual c + +中，甚至使用警告等級4也不生成診斷輸出。
  20. During compilation, compiler outputs diagnostics to the console in utf - 16

    在編譯期間，編譯器以utf - 16格式將診斷輸出到控制臺。
分享友人
分享到 Line

分享到臉書