試件模盒 的英文怎麼說

中文拼音 [shìjiànmóhé]
試件模盒 英文
specimen carrier
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 盒 : 名詞（盛東西的器具） box; case
  1. Firstly, itis explained that the application research of smart layer. to laod detecting and simulative damage for the model of wing - box, fbg fiber smart layer and pzt smart layer are designed, and manufactured. so, those are surface - mounted respectively on the stiffened skin of aluminum alloy and carbon fiber reinforced. data acquisition system based on different signal processing technique are designed

    針對機翼盒段試件結構載荷識別和模擬損傷監測的功能要求，結合智能夾層的設計製作工藝，設計製作了基於fbg傳感器的光纖和壓電兩種智能夾層，並分別安裝在機翼盒段試件上的鋁合金和碳纖維制蒙皮上。
  2. By redefining the cardinality of set, we establish the relationship between the domain / range ratio and the testability metric. pie model can help us doing white box test in unit test phase. based on the fault / failure model and conditional probability, a formula is found to get testability metric, with which we prove there is a max value in software testability metric

    在單元測試階段可以運用pie模型幫助進行白盒測試，本文在軟體的錯誤/故障模型的基礎上，運用概率論中條件概率的相關知識，建立了可測試性的一個計算公式，並使用該公式證明了軟體的可測試度存在一個最大值。
  3. This study is the validation test setup for identifying the srs sensing module component and package system response

    摘要本研究為汽車安全氣囊感測系統模組設計完成前，針對其系統套件與安裝盒組所建立之測試驗證。
  4. In this paper, through stress analysis of region about conical and spherical parts during drawing, a calculating formula of maximum tangential compressive stess in unsupported wall region is deduced. and this is condition of causing internal wrinkle. then on the premise to guarantee not breaking workpiece, a critical calculating formula is presented

    通過圓筒形及盒形件拉深前後網格變化分析，並確定變形區和非變形區，由此得到不規則盒形件毛坯展開形狀由不變形區和參與變形拉深線組成，並用此方法計算出汽車制動閥安裝板的毛坯形狀和尺寸，在試模時一次即獲得成功，具有一定的實用價值。
分享友人
分享到 Line

分享到臉書