試驗能力 的英文怎麼說

中文拼音 [shìyànnéng]
試驗能力 英文
trialability
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : 能名詞(姓氏) a surname
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • 試驗 : trial; experiment; test
  • 能力 : ability; capacity; capability
  1. 05. 01 test method for ultraviolet absorbance and absorptivity of petroleum products

    石油產品的紫外線吸收率和吸收方法
  2. Test method for mechanical property of aerated concrete

    加氣混凝土學性方法
  3. Test methods of oxyen - enriched capacity for aerator

    增氧機增氧方法
  4. The research results show that when the fly ash content is under 30 %, the strength of rcc can be increased but the effect is a little ; and with the fly ash content increased the dry shrinkage of the rcc reduced straightly, and the abrasion resistance and freeze resistance increased obviously. ( 3 ) fly ash can increase durability of the rcc and under the experiment condition, the perfect mixing content is 30 %

    結果表明: ( 1 )粉煤灰摻量小於30 %時提高碾壓混凝土強度但影響度不大; ( 2 )隨著粉煤灰摻量的增加,碾壓混凝土的干縮呈直線降低,且抗磨性和抗凍融明顯提高; ( 3 )粉煤灰有效提高碾壓混凝土的耐久性,且在條件下的最佳摻量為30 % 。
  5. In the dissertation ' s chapter 3 to chapter 5, the mechanical and physical performances of the engineering plastics are analyzed, the failure mode and the designing computing methods of engineering plastics member suffering the static load, dynamic load, impact load, pulse load, are studied. by the practice application and ball firing experiment of the engineering plastics key piece in the weapons, the precious experiences, for engineering plastics application and confirmation of the material performances guideline in the weapons, are obtained

    論文的第三章至第五章,分析了工程塑料物理機械性,研究了受靜載荷、動載荷、沖擊載荷及脈沖載荷下工程塑料構件的失效模式和設計計算方法,通過工程塑料在槍械關鍵受結構件上的實際應用和實彈射擊,取得了寶貴的經,為高性工程塑料在槍械上的應用和材料性指標的確定奠定了基礎。
  6. To study the flexural behavior, ultimate bearing state and laws of internal force redistribution of prestressed concrete continuous beams cast by different construction methods, the model tests for three pieces of the continuous beams were carride out, in which three kinds of the construction methods, such as those of lowering formwork supports at one time, transferring simply - supported structure into the continuous one and casting the beam by cantilever construction, were considered

    摘要為研究不同施工方法下預應混凝土連續梁的彎曲性、極限受狀態及內重分佈規律,進行了3根連續梁模型,分別考慮一次落架、簡支變連續和懸臂施工3種施工方法。
  7. Test method for water - holding capacity of bibulous fibrous products

    吸水纖維製品蓄水方法
  8. Through the approach of investigative questionnaire and ability examination, considering both teachers " teaching practice in senior high school and students " need in analyzing and resolving problem, taking the method of fixing the quality and quantity, we make a demonstration research. at last, we draw a conclusion that the 19 manifestations of chemistry ability can be reduced to three levels : the basal level, called repeating thinking, includes distinguishing and judging the chemical fact and relations of quantity in chemical reaction, comparing and summarizing the chemistry fundamental knowledge ; innovative thinking level includes illogical thinking and logical thinking. illogical thinking mainly contains intuition, association and space imagination of micro - particle

    通過調查問卷、等途徑,結合教師在中學化學的教學實踐和學生在分析、解決問題的實際需要,採用定性與定量結合的方法,進行實證研究,得出結論:化學學科的19種表現形式歸納為3個層次:最基礎的再造性思維層次包括對化學事實和化學反應中量的關系的識別和判斷、對化學基礎知識的比較概括;以培養創新為核心的創造性思維層次包括化學直覺思維、聯想、對微觀粒子的空間想象為主的非邏輯思維和靈活運用已學的化學知識通過分析、綜合地解決問題為主的邏輯思維;化學實層次是化學學科的最高層次,它以思維為基礎,集中體現了化學教學的基本特徵,實層次包括:選用實方法和設計實方案,對實的評價,研究和處理實事實、資料、數據,發現規律,表達實及其結果,最終解決問題的和發散思維。
  9. Electro - hydraulic servo loading system ( ehsls ) is an important simulation system in hard ware - in - loop flight simulation laboratory, which can simulate aerodynamic loads acting on flight vehicle, such as missiles, planes. its performance of test is important on the design of flight vehicle

    電液伺服負載模擬器是半實物模擬室中模擬飛行器在飛行中舵面所受空氣動載荷的重要設備,它的試驗能力高低對飛行器設計起著重要作用。
  10. Regarding the capability of local laboratories to perform such tests, we have thoroughly consulted local laboratories and the hong kong association of certification laboratories limited. the association has confirmed that local laboratories are capable of performing the tests required by the scheme

    就本地實室提供測,我們曾向本地實室及香港檢定協會詳細諮詢,該協會表示香港的實室有按計劃的需要提供測
  11. Gb1094. 5 - 85 power transformers part 5 ability to withstand short circuit only applies to power transformers, not to balanced transformers. if short - circuit test on balanced transformers can be performed by means of single phase supply instead of three phase supply, and other special transformers can also be done in this way, so it is very significant to improve test capacity of transformer laboratory in our country

    變壓器的短路強度只通過短路證,國家標準gb1094 . 5 - 1985 《電變壓器第5部分承受短路的》只適用於電變壓器,對平衡變壓器等特殊變壓器並無具體規定,對于平衡變壓器,如果可以用單相電源預先短路法模擬三相電源的短路,那麼其它特種變壓器的短路也可以參照進行,這對提高我國變壓器室的試驗能力具有重要意義。
  12. In order to test resistance parameters and general properties of the idler automatically and continuously, by using " the rotating inertia method " to construct mechanical drive control system, theory of realizing double parameters measurement of the idler was discussed, and by using pressure transducer parts to control the experiment pressure, method of examining the idler was also put forward

    摘要為實現對托輥阻參數及綜合性的自動化、連續化的測,論述了利用理論學中「轉動慣量法」構建機械傳動控制系統,實現托輥阻雙參數測量的原理,闡明了採用壓傳感器部件控制,達到托輥產品在規定壓下跑合要求的檢測方法。
  13. Trial - use standard for testability and diagnosability characterisics and metrics

    試驗能力和診斷特性和度量的用標準
  14. Therefore in the product research and development, the examination experiment ability appears extremely important

    因此在產品研發中,檢測試驗能力顯得非常重要。
  15. So experimental study of dual - mode scramjet engines puts higher demands on simulating capability of ground test facilities and measurement technology, and greatly increases test cost and time

    因此,雙模態沖壓發動機的研究對地面設備的試驗能力和測量技術提出了更高的要求,也大幅度地增加了的周期和費用。
  16. Therefore, it is academically significant and valuable for scientific application to establish an internet based network aiming at more efficient sharing of the resources and advance capability

    因此,以共享現有資源並提升整體試驗能力為目標,利用網際網路將多個實室聯合起來形成網路化結構實室的研究具有重要的理論意義和科研應用價值。
  17. Article 18 the state shall encourage enterprises to establish and improve their technology development organizations, and also encourage them to join forces or cooperate with research and development institutes, and institutions of higher learning, with a view to increasing their capabilities in research and development, pilot trial, and industrial test

    第十八條國家鼓勵企業建立和完善技術開發機構,鼓勵企業與研究開發機構、高等院校聯合和協作,增強研究開發、中間和工業性試驗能力
  18. The content of pema affects on interplanar distance of pe / mmt composite. the content of pema increases as the interplanar distance, barrier properties and melting point of composites increased, when the critical content of pema ( wpema = 30 % ) could get exfoliated composites. the interlayer spacing of pe / mmt composites depends on content of mmt, but not the content of mmt increases as the interlayer spacing increases

    同時用x射線衍射( xrd )衍射實、紅外光譜( ir )實、差熱分析( dta ) 、學性等手段,研究了採用不同的相容劑改善聚乙烯與蒙脫土之間的相容性的情況;相容劑的用量對聚乙烯/蒙脫土復合材料層間距、性的影響;蒙脫土的含量對pe / mmt對復合體系的層間距影響;以及工藝條件對復合體系的層間距和性的影響。
  19. The paper introduces a multiparameters static load test method. compared with a routine test, the bottom and the top settlements can be observed by this method and multiparameters are aquired. based on these parameters, we can get a generally analysis on the elastic - plastic compression of the pile, the side bearing and the bottom bearing as well as the properties of the soil under pile

    介紹了一種既觀測樁頂沉降又觀測樁端沉降的樁身壓縮量的實測方法,區別于常規的靜載荷,該靜載荷夠提供多方面的參數,可以對樁身彈性壓縮量、側阻、端阻的發揮程度、樁端持層性狀有一個比較全面的了解。
  20. Now people are adopting the simulation test to resolve this question. and, withal, 1 : 1 scale specimen can be employed in simulation test that can avoid appearing the " distortion " in the scale - down test. in simulation test, the same test can be made times without number and results of test are more full - scale and exact

    而且它可以進行1 : 1的模型,避免出現進行小比例所產生的「失真」現象;它還可以反復多次進行同一個夠更加全面觀察模型上所有點的受情況,夠更加準確測量出模型的變形和應
分享友人