試驗臺試驗 的英文怎麼說

中文拼音 [shìyàntáishìyàn]
試驗臺試驗 英文
bench run
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 臺 : 臺名詞（指臺州） short for taizhou （in zhejiang province）
  • 試驗 : trial; experiment; test
  1. Docking mechanism test - bed is mainly used to simulate dynamics process of two aerocraft ’ s docking on the ground, validate rationality of the mechanism ’ s design and estimate stability of the docking process

    對接機構綜合試驗臺主要用於地面模擬空間兩飛行器對接的動力學過程，對機構設計的合理性、對接過程中的穩定性進行驗證和評估。
  2. Design and analysis on high speed static air bearing test - bed

    高速徑向氣體靜態軸承試驗臺的設計與分析
  3. Falling body type shock testing machines

    落體式沖擊試驗臺
  4. The first electric test - bed for catenary accessory in our country was born

    接觸網零件電氣試驗臺研製成功，填補了國內無專業試驗設備的空白。
  5. To eliminate the errors, the parallel double - sensor scheme which can eliminate the influence of the tooth space error of the measurement tooth - wheel and the contraposition double - sensor scheme which can reduce the influence of the installing eccentric error of the measurement tooth - wheel are demonstrated in detail and realized in this paper

    為消除這些誤差，詳細論證並實現了用並聯式雙傳感器方案消除測量齒盤分齒誤差的影響和用對置式雙傳感器方案消減測量齒盤安裝偏心誤差的影響。構建了試驗臺，驗證了誤差研究和雙傳感器方案的正確性。
  6. Dynamometer selecting for power train test bench

    傳動試驗臺吸功設備選型研究
  7. But there has been no track spectrum that can reflect the real condition of chinese rail for a long time. many organizations have put forward some conclusions of track spectrum, but there is no unite conclusion at present in china. power calculation of locomotive and experiment on the rolling and vibration test - bed have to adopt foreign track spectrum

    但長期以來沒有能反映我國實際軌道狀況的軌道譜，雖然國內很多機構都已提出一些軌道譜的結論，但尚沒有統一性的結論提出，機車車輛動力學計算和滾動振動試驗臺試驗均只有採用國外軌道譜。
  8. Calibration norm of gpwc ramp test set

    近地警告計算機外場試驗臺試行檢定規程
  9. Method for testing fuel injection pump test - stand

    噴油泵試驗臺試驗方法
  10. Testing - bed test

    試驗臺試驗
  11. Bench test method for frictional characteristics of sintered metal friction materials run in lubricants

    濕式燒結金屬磨擦材料磨擦性能試驗臺試驗方法
  12. Safety of machinery - evaluation of the emission of airborne hazardous substances - emission rate of a specified pollutant - bench test method using the real pollutant

    機械安全.空氣中有害物質排放的評估.特定污染物的排放率.實體污染物的試驗臺試驗方法
  13. Safety of machinery. evaluation of the emission of airborne hazardous substances. part 3 : emission rate of a specified pollutant. bench test method using the real pollutant

    機械的安全性.空氣中危險物質散發的評定.第3部分:特定污染物質的散發率.使用真污染物的試驗臺試驗
  14. And considering the uncertain factors that the system may meet during the operation, a h robust control algorithm is employed when devise the controller of the system to compensate disturbances and unmodeled factors of the system. finally, simulation and experiments are done to test the system ' s robustness and performance

    鑒于系統工作過程中存在的各種不確定性因素，系統控制器的設計採用了h _魯棒控制演算法，以抑制系統的外界擾動以及被控對象的模型不確定性，並進行了系統模擬和試驗臺試驗研究。
  15. Experiment of the helical axial seal in laboratory is designed, the experimental results have been analyzed and these experiments make the relevant mechanism and structural parameters of the helical axial more sure

    設計製造了螺旋密封試驗臺架，驗證了螺旋密封相關理論和螺旋結構參數的優化結果合理性。
  16. Comparing with the traditional test method which has many limitations, the engineering vehicle testing system has many advantages, such as the higher test efficiency and no potential accident in road. therefore, the successful development of the system do have significance in both economy and society

    工程機械（平地機、裝載機）跑合試驗臺檢驗，來替代傳統的道路磨合和可靠性試驗，提高了生產效率、防止了道路試驗的事故隱患，在經濟效益和社會效益兩個方面，都具有很大意義。
  17. Then the experimental data was analyzed in time domain and frequency domain. thirdly the hilbert translation method was used to detect the nonlinearity of the system. at last the model of this kind of system was identified, the result show that the theory model is the same format as the experiment model

    然後利用振動臺做掃頻試驗，對試驗數據在時域與頻域進行分析處理，利用hilbert變換檢測系統的非線性，分析系統的非線性特點，在此基礎上進行系統的模型識別，並將實驗建立的模型與理論模型進行比較。
  18. At the same time, the corresponding programs on the above two methods can be compiled in frotran90 respectively, which are used to analyze the influence of several factors on behaviour of barrette pile group and barrette pile group - soil - cap interaction, including collocation of pile, ratio of length to width, pile spacing, ratio of depth to equivalent diameter, ratio of modulus of pile to soil, possion ' s ratio, the finite layer, the number of piles etc. lastly a series of model tests on vertically - loaded bahaviour of single pile are made, tests results are analyzed, and the causes of tests failure are preliminarily discussed in this paper

    分析了群樁布置形式、長寬比、樁與樁之間的相對距離，樁徑比、樁土剛度比、泊松比、有限壓縮層深度以及群樁根數等因素對壁板樁群樁和壁板樁群樁?土?承臺的相互共同作用問題的影響。論文最後做了一組壁板樁和圓形樁單樁模型試驗，對試驗數據進行了分析，並對試驗中存在的問題進行了初步探討。
  19. Testing equipment and testing method for centrifugal pump was introduced, and experimental steady - state hydraulic performance during changing outletangle was obtained through changing outlet angle and the result was discussed at the end

    摘要介紹了離心泵性能試驗的試驗裝置和試驗方法，通過對一臺離心泵的試驗，給出了水泵在改變其葉輪出口角時各參數的穩態性能曲線，並對其進行了分析。
  20. Protective clothing for users of hand - held chain saws - test rig for testing resistance to cutting by a chain saw

    手持式鏈鋸使用者用防護服.耐鏈鋸切割試驗用試驗臺
分享友人
分享到 Line

分享到臉書