調偏電阻 的英文怎麼說

中文拼音 [diàopiāndiànzǔ]
調偏電阻 英文
bias adjusting resistance
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  2. Second, since input bias currents are not always small and can exhibit different polarities, source impedance levels should be carefully matched to minimize additional input bias current - induced offset voltages and increased distortion

    其次，因為輸入偏置電流不一定都小，且可能體現不同的極性，而且源阻抗水平應該仔細地進行匹配，以將輸入偏置電流引起額外失調電壓和增加的畸變減到最小。
  3. After putting the 150 mg / m3 electrostatic needle filtration fabric on the home air condition, the air condition ' s purifying efficiency can get to 71. 0 % ~ 73. 6 % and the resistance is 56 ~ 92pa which is a little higher. and the blast air ' s speed becomes lower and the quality of ventilation becomes less which affect the air condition ' s work

    櫃式家用空調器上使用150g m3的針刺荷電纖維后，過濾pm _ （ 10 ）的效果顯著，過濾效率可以達到71 . 0 73 . 6 ；阻力稍微偏高，達到56 92pa ，送風口風速降低30 ，通風量減少，延遲了空調製冷時間，製冷效果沒有原來好，使用時應注意。
  4. On the base of the fujian power system that has the special configuration of " large power generator with small power system " in 2000, constructs power system models of fujian and fujian interconnected with other parts, does a lot of calculation and analysis and simulation, researches the security mechanism and rule of the fujian special power system interconnected with large power system. the above connection can keep security and stability and can make obvious benefits, but when the transmission power reach to excessive quantity the main power grid will increases interconnected flow - in or flow - out exchange power load. the power operation state tended to instability ; the infirmable interconnection make s the damp infirmable

    本文以2000年前後具有「大機組小電網」特殊結構的福建電力系統為背景，建立了福建電力系統及其與外部互聯的數學模型，開展大量的模擬計算分析，研究了「大帆組小電網」電力系統與大容量電力系統互聯偏弱的安全穩定性的機理和規律：前述互聯可以安全穩定運行，取得顯著效益，當傳輸功率達到一定量后，主網架增加了送出或吸收互聯交換功率的負載，系統運行狀態向穩定性水平有所下降的方向轉移；聯絡偏弱使阻尼偏弱，聯絡線小幅低頻振蕩和大幅低頻振蕩易被激發，聯絡線一旦重載斷開，系統高周或低調嚴重。
  5. Firstly, set the all - purpose meter at r x 10k rank, and set it at zero, then connect the two connectors of the all - purpose meter to each end of the resistance to check if the finger will shakes, if the finger shakes to the right hand side, then it states that this resistance is good

    首先，將萬能表跳到r 10k檔位，然後把望能表調0 ，再用萬能表的黑紅兩只筆去接觸電阻的兩端，看萬能表的阻值是否有偏轉，如果萬能表上指針向右偏轉，表示該電阻是合格產品
分享友人
分享到 Line

分享到臉書