調度理論 的英文怎麼說

中文拼音 [diàodùlǐlún]
調度理論 英文
scheduling theory
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 調度 : 1 （調遣） dispatch （trains buses etc ） 2 （調度員） dispatcher 3 （安排） manage; control 4 （...
  • 理論 : theory
  1. The analysis of data and uncertainty of the test upon different simulant target properties and atmospheric condition has proved that noncooperative regulable attenuation method and setting described in the paper can achieve a quantitative output

    不同目標特性、不同大氣條件下的地面性能驗證實驗數據和精度理論分析結果均表明，非合作目標可調衰減法可以實現對激光高度計最大測程的定量化驗證。
  2. Based on the research into real - time middleware and relative scheduling theoretic, this thesis implements a real - time corba integrated scheduling service modal, by extending the scheduling service of tao

    本文在對實時中間件及相關調度理論進行研究的基礎上，對tao系統的調度服務進行了擴展和改進，實現了一個實時corba的集成調度服務模型。
  3. Based on analysis of the iso - rigidity of the gyro assembly, the requirement for making the joints match each other is offered, which has a guiding significance for joints assembly and selection. based on analysis of rigidity and drift error for the dynamically tuned gyro, a cross model including an inner and an outer flexible hinges is established

    在對動力調諧陀螺剛度和漂移誤差分析的基礎上，建立了由內外撓性接頭裝配所形成的十字型鉸鏈模型，並利用偽剛度理論對該模型進行了分析，得出了內外撓性接頭兩鉸鏈的相對位置關系對十字型鉸鏈模型的影響曲線。
  4. The forecast module uses the realtime data to calculate the forecast values. this thesis based on no. 3 blast furnace of the xiangtan iron and steel company. it match esthe hardware and software of the blast furnace

    在預測模塊中，用即時數據來計算預測值，並用調整系數進行調整，得到可靠的預測值，如鐵水溫度、理論燃燒溫度、直接還原度、焦比等。
  5. An evaluation method of color design on nc machine tools was proposed based on mospencer ' s color harmony theory through experiment and correlation analysis

    摘要基於孟斯賓瑟色彩調和理論對機床產品色彩設計評價環節進行研究，通過相關分析實驗，求取美度公式的參數，建立針對機床產品的色彩調和新評價標準。
  6. Kandinsky used color in a highly theoretical way associating tone with timbre ( the sound ' s character ), hue with pitch, and saturation with the volume of sound

    康丁斯基是運用一種極度理論性的手法串聯起色調與音質（聲音的要素） ，色彩與音高，以及色彩飽和度與音效的音量大小。
  7. Statistics and reliability theory are used as the basic theory in this paper to deal with the key and difficult questions in engineering risk analysis and risk decision area. some important structures in south - north water transfer project ( snwtp ) of middle route as the engineering examples are detailed studied in the paper. the main contents researched in this paper are as follows : 1

    本文以概率論及可靠度理論為基礎，以南水北調中線工程為背景，從工程角度針對當前工程風險分析及風險決策領域的熱點和難點進行了研究，主要工作內容如下： 1 、分析了南水北調中線工程中的風險因素，及可能採取的應對措施。
  8. Second, a virtual task set relevant to timing constraints is elicited from the object model, and it is validated against end - to - end timing constraints

    本文研究了從對象模型中提取出和時間約束有關的任務集合，並應用傳統的實時調度理論驗證端到端時間約束的方法。
  9. As to the situation that long - term dispatching has weakness to the real - time dispatching, there is a emergent requirement from the power plant press that the theory circles should make a deep study into the shot - term dispatch theory which can be the guide of the operation

    針對中長期水庫調度的實際操作性不強的情況，各電廠迫切要求理論界能深入研究能夠指導其實際操作的短期調度理論，筆者就梯級水庫短期優化調度問題進行了研究。
  10. The core theory of workshop produce plan and control is scheduling theory

    車間生產計劃與控制的核心理論是調度理論。
  11. Theory and practice of temporal and spatial dispatch of water and sediment in middle - lower reaches of yellow river

    黃河中下游水沙的時空調度理論與實踐
  12. Scheduling problems are known to be in general np - complete, only sub - optimal can be obtained by classical scheduling approaches in most cases

    任務分配與調度問題是一類np問題，經典調度理論一般僅能獲得問題的近似最優解。
  13. At the end of this paper, an integrated fms simulation platform is presented. this platform integrates the whole sequence of modeling and simulation procedure

    國內外很多學者提出了很多調度理論用於fms調度，但是迄今為止還沒有通用而高效的調度方法。
  14. This paper analyzes the temporal character of profibus using the worst case scheduling and obtains the sufficient and necessary condition satisfied to schedulability

    論文借用實時調度理論的基本方法對其實時特性進行理論分析，得出滿足信息實時傳送的充要條件。
  15. In chapter 2, on the basis of reference to classical static priority scheduling theory for hard real - time systems, we proposed a delay computation method with partition algorithm

    第二章在借鑒強實時系統靜態優先級調度理論的基礎上，提出一種通過引入分區演算法來計算atm交換延遲的方法。
  16. With the support of the key national preresearch project for the 10th five - year plan, this paper has deeply studied scheduling theory and engineering practice of rtdcs, aimed at large amount of existing real - time relevant period multitasks ( rtrpmt ) and tasks to be fault - tolerant ( tft )

    本文以「十五」國家重點預先研究項目為背景，針對實際應用中大量的實時相關周期多任務及容錯任務，對分佈實時系統的調度理論與工程實踐問題進行了深入的探索與研究。
  17. The main topics of the thesis are listed below : the current research status of real - time scheduling theories is discussed. popular scheduling algorithms, including static scheduling algorithms such as rate monotonic analysis ( rma ), deadline monotonic analysis ( dma ), and dynamic algorithms such as earliest deadline first algorithm ( edf ), least leisure first algorithm ( llf ) etc., and their strong points and weakness are discussed

    本文的主要內容如下：介紹了實時調度理論的發展現狀，分析了當前流行的各種調度演算法的優缺點，其中包括靜態調度演算法，比如速率單調調度（ rms ） 、截至時間單調調度（ dms ） ；和動態調度演算法，比如最早截止時間優先調度（ edf ） 、最小空閑時間優先調度（ llf ）等。
  18. We studied the basic construction of fmc and bring forward the concept of job scheduling. job shop work static scheduling of fmc is mainly considered. and it is developed that static scheduling consists of three sections : optimized job group, optimized load distribution and optimized job - machining sequencing

    本文對fmc的建模及調度問題進行了探討和研究，研究了fmc的基本結構，提出了作業調度的概念，著重分析了fmc作業靜態調度理論，提出了零件最優分組、負荷最優分配和零件加工的最優排序等問題，並針對這些問題詳細研究了它們的演算法和計算步驟。
  19. This thesis is based on the simulation of researching discrete event system. under the instruct of workshop scheduling theory, we analyse each simulation strategy which is suit for discrete effect system, and combine the practice instance of cylinder body product line of dalian diesel oil machine factory

    本論文在研究離散事件系統模擬的基礎上，在車間調度理論指導下，分析了適用於離散事件系統的各種模擬策略，結合大連柴油機廠氣缸體生產線的實際情況，採用事件調度法對流水線製造系統的模擬進行研究。
  20. The thesis is organized as follows : chapter 1 is an introduction to the research background ; chapter 2 is the theoretical part which includes a summary of real - time scheduling algorithms and the researches of deadline monotonic theory ; chapter 3 proposes the design considerations and objectives of the real - time task scheduler, and introduces the experiment platform qnx real - time operating system ; the design and implementation of the scheduler are discussed in detail in chapter 4 ; chapter 5 summarizes the thesis and discusses applying the scheduler on real systems and its future improvements

    本文組織如下:第一章為研究背景介紹;第二章為實時調度綜述和對截止時間調度理論的研究;第三章介紹了實時調度器的設計考慮和設計目標以及試驗平臺qnx實時操作系統:第四章詳細闡述了實時任務調度器設計和實現細節和關鍵演算法:第五章為全文總結和對實時任務調度器在真實系統中的應用和進一步改進的討論。
分享友人
分享到 Line

分享到臉書