調速器油壓 的英文怎麼說

中文拼音 [diàoyóu]
調速器油壓 英文
governor oil pressure
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 壓構詞成分。
  • 油壓 : [機械工程] oil pressure
  1. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合控制空燃比;通過提高縮比來彌補動力性的損失;以動力性為主控目標,對最大功率點、最大扭矩點、中等轉、最低轉點所對應的發動機轉做了點火特性的調節;通過空燃比的合理控制,直接改善發動機的動力性、經濟和排放指標;作為對缸內燃燒過程的理論分析,進行了燃燒特性的實驗測試;對原汽機和新開發的液化石氣發動機,進行了外特性和部分負荷特性以及怠的排放及噪聲對比性測試。
  2. Voltage meter, current meter, frepuency meter, oil pressure meter, water temperature meter, timer, battery voltage or charging current meter, protection indicator, speed and voltage inching switch and etc

    表電流表頻率表表水溫表計時電池電或充電電流表保護指示燈轉及電調開關等。
  3. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調技術的發展概況,在回顧電梯液控制系統節能技術的基礎上,介紹了本課題研製的「採用蓄能的液電梯變頻節能控制系統研究」的基本原理,分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式;詳細地介紹了本課題節能系統液動力泵站的結構設計和參數設計,重點研究了液動力泵站的結構設計、液泵馬達可逆性問題及其選型設計計算、蓄能迴路泄漏損失機理的研究及其補償裝置的設計、蓄能-泵馬達力能量轉換裝置的設計、多功能集成控制閥組的設計等內容;最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  4. Diesel engines. hydraulic speed gavernors. specifications

    機.液調.技術條件
  5. For the relative units like remote control panel, electronic vit control, oil eject, speed pick up unit and spc - 33 external interface the hotspot information is also made and displayed by visual components

    調相關的單元:遙控控制臺、電子vit控制、高泵、轉檢測單元、 spc - 33外部介面等建立熱點信息,並以圖形界面顯示。
  6. In addition, in order to make the pumps realize constant injection pressure, the expert tuning pid vfvs constant injection pressure control sub - system for pumps is established and relevant software module is developed. the sub - system can control automatically the quantity and rotate speed of the pumps running to realize the pumps optimum run according to the seawater injection plan of the oil field, which realizes constant injection pressure, energy saving and decreases the consumption to a large degree

    此外,為平臺注水泵機組的優化運行構建了基於專家整定pid控制的變頻調注水控制子系統,並開發了相應的軟體模塊,完全省卻了pid控制的硬體設備,使得注水泵機組可以根據田注水量的配注方案優化運行,自動控制注水泵的轉和運轉臺數,既能實現平穩增注水,又能在很大程度上節能降耗。
  7. This difficult task of adjusting oil pressure, and adjusting to variable driving conditions is handled completely by the ecu, and allows the transmission to extract the maximum performance out of an engine - making this a revolutionary automotive transmission

    調的艱難任務和調整多變驅動條件完全由電子控制單元( ecu )控制,並允許變工作到超過發動機的最高性能? ?使得這是一個具有革命意義的自動變
  8. The tap - changer is made with solid state relay as its working mechanism and controlled by microprocessor. this switch has totally cancelled the mechanical drive organization, by the microprocessor according to the voltage of second side microprocessor decide the working condition of solid state rely, high regulation speed, need not transition resistor, rush current is low. operating frequently ; there is no electric arc to produce, can put in the fuel tank of the voltage transformer directly ; the structure is simple, the fabrication cost is low, benefit and use widely among the voltages transformer of distribution

    其中的有載調分接開關,它是一種完全由固態繼電作為分接開關執行機構,由單片機控制的有載自動調的變分接開關。該開關完全取消了機械傳動機構,由單片機根據變二次側電的高低,決定與變各分接頭聯接的固態繼電的工作狀態。調度快,改變分接頭時不需過渡電阻,沖擊電流小,可頻繁操作;無電弧產生,可以直接放在變箱中;結構簡單,造價低,便於在配電變中推廣使用。
  9. Governors and oil hydraulic devices

    調裝置
  10. Terminology of speed governor and oil pressure supply unit for hydraulic turbine

    水輪機調裝置.術語
  11. Series table for governors and oil pressure supply units of hydraulic turbines

    水輪機調裝置.系列型譜
  12. Operation code of governors and pressure oil supply units for hydraulic turbines

    水輪機調裝置運行規程
  13. Specifications of governors and pressure oil supply units for hydraulic turbines

    水輪機調裝置技術條件
  14. Test acceptance codes of governors and pressure oil supply units for hydro - turbines

    水輪機調裝置試驗驗收規程
  15. Complying method of the symbols for governors and oil pressure supply units of hydraulic turbines

    水輪機調裝置.型號編制方法
  16. The new unit has following technical features : ( 1 ) the unit ' s load is balanced by means of the accumulator and hydraulic cylinder with special structure ; ( 2 ) the installed power of the unit can be reduced greatly by adopting the accumulator ; ( 3 ) variable frequency speed regulation ensures good energy saving effect, and the closed oil circuit requires less hydraulic oil ; ( 4 ) a bi - directional hydraulic lock in the oil circuit ensures the stability and safety of the operation of the pumping unit

    新型機具有4個技術特點: ( 1 )由於活塞柱塞式液缸的特殊結構和液蓄能的配合使用,在平衡抽機大部分載荷時,不需另外增加配重,可減小抽機體積、質量和佔地面積; ( 2 )抽機下沖程時,與活塞柱塞式液缸相連接的蓄能吸收能量,上沖程時儲存在蓄能中的能量補充載荷上行所需的能量,大幅度降低抽機裝機功率; ( 3 )利用變頻容積調節能效率高,閉式路節省液,同時大大減小液泵站的體積; ( 4 )在閉式路中採用雙向液鎖可使抽機的啟停更加平穩、迅,其工作的穩定性和安全性更好。
  17. The foundation of back is10 steel or spcc, the surface is agglomerated by different trademarks copper and lead powder, resistant against : tiredness, abrasion, heat, has good carrying capability, especially, be the same with the connecting rod clevel, rocker, gear case, cranking motor, trig chasis, and motor gear case, redirector, hydraulic pressure oil pump, engineer

    產品具有疲勞強度高,耐磨不發熱,承載能力大等特點,特別適用於汽車發動機的連桿搖臂,輪箱,起動馬達,制動底盤及摩托車輪箱,轉向,液泵,工程機械,空調機等場合,目前我廠是國內最大的發動機連桿襯套生產企業之一。
  18. The development of ship automation puts more requirement on the quality of electricity, whose standard can no longer be met by the traditional mechanical hydraulic pressure or analog speed regulator of marine diesel - engine generator system. as a result, speed regulator based on electronics and microcomputer appeared

    船舶輪機自動化的發展,對船舶的供電質量的要求也越來越高,傳統的柴發電機組的機械、液或模擬式調已不能滿足這種要求,因而出現了電子的基於微計算機的雙脈沖調調調
  19. The system can on - line measure axis tile of electricity temperature, axis tile of decelerate, transfer temperature and oil pressure which can influence equipment working state, at the same time, the system can measure process parameters of f1 - f6 rolling speed, rolling current, rolling voltage and tiny adjust quantity

    該系統能在線監測電機軸瓦溫度、減機軸瓦溫度、變溫度、等影響正常生產的設備運行狀態,還能監測軋鋼生產過程中的f1 - f6六臺軋機的軋制度、軋制電流、軋制電、軋制力和微調量等過程參數。
  20. Quick - adjustment hydraulic system : quick regulations on pincers & fingers, maximizing machine performance

    調整型系統- - -爪子及指頭等調整方便,發揮機最佳性能。
分享友人