調速率 的英文怎麼說

中文拼音 [diào]
調速率 英文
speed droop
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 率名詞(比值) rate; ratio; proportion
  • 速率 : speed; rate; tempo
  1. After the running test, the scope of speed is from 50 to 2500 r / m. the system has a good performance and high efficiency, achieves the anticipative result

    本系統經過試驗,調范圍可達50 2500轉分,效較高,性能優良,基本上達到了預期的目標。
  2. Muscarinic acetylcholine receptor machr genes and demonstrated that the embryonic bradycardia is regulated by the m

    並證明斑馬魚胚胎心跳受第二型蕈毒乙醯膽鹼受體調控。
  3. Early speed control systems on turbine all adopted pure mechanical hydraulic speed control systems, which had intrinsic defects. for example, the percentage of delay is large, dynamic regulation characteristic is bad, control accuracy is low, the operation is cockamamie, the running and maintenance are not convenient, and so forth. in order to solve these problems, it is necessary to substitute a completely new, advanced speed control system for previous mechanical hydraulic one

    早期的汽輪機調系統均採用機械純液壓調系統,機械液壓系統具有固有的缺陷,如遲緩大、動態調節品質差、控制精度低以及操作繁瑣、運行、維護十分不便等,解決這些問題均要求採用一種全新、先進調節系統來取代原有的機械液壓式調節系統。
  4. For increasing the effective material peak - value power ( empvp ), solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state and improving the efficiency of the pmsm, some solving method are taken as follows : the influence of length / diameter ratio to the empvp is analyzed, and the optimum size of length and diameter is chosen

    主要是從提高電機的有效材料峰值功、解決pmsm提高電動機運行狀態時的弱磁擴能力和減小發電機運行狀態時的電壓調之間的矛盾及提高電機的效著手,分析了長徑比、氣隙長度對有效材料峰值功的影響,並確定了它們的最佳尺寸。
  5. The thesis is devoted to exploiting a permanent magnet synchronous machine ( pmsm ) for the parallel hybrid electric vehicle ( phev ). three parts are included as follows : at first, in the electromotor state, the current control strategies of pmsm are determined. giving the elementary method for solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state

    本課題的研究工作主要圍繞開發一臺並聯式混合動力電動汽車( phev )用永磁同步電機( pmsm )展開,所作的工作主要包括以下幾個部分:首先,確立了phev用pmsm電動機運行狀態時的電流控制策略,針對pmsm在電動機運行狀態時提高弱磁擴能力和在發電機運行狀態時減小固有電壓調的相互矛盾,提出了初步的解決方法。
  6. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效不高、元件壽命短、抗污染能力差、驅動系統效低、存在流量及壓力脈動等缺陷,利用先進的交流變頻調技術改變液壓泵轉的容積調新方法,提出了在液壓系統中加一個定差減壓閥的新思路,較好地解決了液壓伺服系統存在的上述問題。
  7. Presents the energy saving principle of a frequency - controlled pump and points out the applicability of the law of similitude for centrifugal pumps and the conception of constant efficiency curves

    摘要闡述了循環水泵變頻調的節能原理,提出離心水泵相似定律的適用性和等效曲線概念。
  8. By introduction of two lif layers, the adjustment of the position of thin layer alq3 in the microcavity is achieved and the effect of the coupling strength between the emissive dipole and vacuum electric - field on the emission intensity in ( / 2 - length microcavity is studied for the first time

    在帶有dbr結構的高q值微腔中,觀察熒光壽命變短輻射提高的現象。通過使用填充層,來實現對薄層alq在腔中位置的調節,研究了輻射偶極子同光電磁場的耦合強度對輻射強度的影響。
  9. A new system of rapid roll carriage infeed and return, together with automatic selection of pressure and feed rate, has improved the already impressive floor - to - floor times achieved

    輥子進給和返回系統和自動壓力、進給調節器提高了工作效
  10. Through the analysis of the deduction process of harmonic function model, it is illustrated that some hypotheses in the deduction process are unreasonable and the harmonic function can not reflect the objective regularity of the vertical crust movement, so that it isnt an effective method to compile isoline map of the vertical crust movement rate

    對有關文獻提出的「地殼垂直運動調和分析」模型的建立過程作了全面分析,指出:該模型建立過程中所做的一些處理是不合理的,由此建立的模型不是地殼垂直運動規律的客觀反映,因而尚不足以成為編制地殼垂直運動面等值線圖的可靠手段。
  11. At first, according to the concrete requirement of the servo control system, a collective scheme, which provide guarantee to meet the requirements of the global performance, is established. in this scheme, the structure of gimbal and the torque motor driven mode are adopted, and angle measurement is accomplished by inductosyn and velocity measurement is accomplished by dynamically tuned gyro respectively

    首先,根據目標真值測量設備伺服系統的具體要求,確定了地平式常平架結構,力矩電機驅動,分別採用動力調諧式陀螺儀及圓盤式感應同步器作為及位置反饋元件這一總體方案,為伺服系統滿足整體性能指標要求提供了保證。
  12. After elaborating the principle of an 802. lib key modulation scheme - complementary code keying ( cck ), this paper proposes and realizes a hardware circuit solution of 802. 11b pcmcia wlan interface card, which can reliably offer a maximal 11mbps data rate and freely switch within 14 working channels in 2. 4ghz frequency band

    接著在詳細闡述了802 . 11b協議核心調制技術?互補碼鍵控( cck )的原理的基礎上,本文提出並實現了一種峰值傳輸為11mbps的802 . 11bpcmcia高無線網卡的硬體電路設計方案,在2 . 4ghz頻段該網卡可在14個工作通道上自動切換,實現高突發數據的可靠傳輸。
  13. In this thesis, firstly, we put forward a new algorithm of the synchronization of carrier reference phase, that is to use the curve synthesizing with the general digital carrier phase looper to have an estimation on carrier frequency within 10 ms so as to meet the need of meteor burst communication. we have done some simulations to get the performance of carrier frequency estimation using two modulation modes ( 16qam and 4 - qpsk ), and had some test on the carrier phase looper in conditions when using different baud rate transmission and when the baud tuning have windage

    我們對兩種正交調制方式( 16qam和4 - qpsk )進行了模擬工作並給出了模擬結果,同時討論了碼元同步定時誤差對鎖相環路工作的影響並根據流星通信中使用變傳輸時鎖相環路的載波同步性能進行了測試;然後在基於軟體無線電思想的數字處理平臺(該數字處理平臺實現了中頻數字化)上用dsp軟體完成了載波的相位跟蹤。
  14. Based on the tms320f240 controller produced by ti company, the hardware and software designation of the symmetrical voltage space - vector pwm is presented. designed a digital controller with tms320f240 to modulate the speed of the motor, in which the keyboard and led display are bedded. it can be to set the frequency of motor and display the run frequency of motor in real time

    基於ti公司的tms320f240控制晶元,介紹了對稱空間電壓矢量硬體設計和軟體設計,採用tms320f240設計了一款用於電機變頻調的數字控制器,該控制器上設計有鍵盤和led顯示,可以設定和動態顯示電機運行頻
  15. 2. machine will auto stop when the shute or weft opens, or weaving is done. it has higher output, quality than four shuttle circular looms. 3. controlled main equipment speed with frequency converter

    主機變頻調,改善起動性能,縮短定機時間,減少疵布,節約電能和方便度變換
  16. The outcome shows that such digital electronic speed governor is in possession of stable timing rate of 1. 0 % and instantaneous timing rate of 6. 2 %. and it is worth a wide popularization for its simple structure and low cost

    在對hondagx31汽油機進行了大量試驗后結果表明:在標定轉6000r min時,該電子調器可以達到1 . 0的穩態調速率和6 . 2的瞬態調,優于國家標準的要求。
  17. Rms ( rate - monntonic scheduling algorithm ) in acos is an optimal static priority algorithm for scheduling independent, preemptible, periodic tasks

    Acos中的單調速率調度演算法( rms )對于可獨立、可搶先調度的周期性任務是一種最佳的靜態優先級演算法。
  18. On the basis of investgation on the related literature of electronic speed governor at home and abroad, this proper control parameters are obtained through the experimental research of the pid digital control parameters with the orthogonality method and through the analysis of the speed change of gasoline engine rev. the electronic speed governor designed hereby performs its controlling fuction through programs, the stable rev and static timing rate of which are also set and controlled by software, has, therefore large universality and function flexibility. so for different types of gasoline engines, the obtainment of relevant parameters and the designing of relevant programs suffice to realize the control functions of the electronic speed governor

    本文在分析研究國內外有關電子調器的基礎分析方法及其研究狀況的基礎上,採用pid數字控制,並用正交試驗方法對pid數字控制的控制參數進行試驗研究,得到了合適的控制參數。所設計的電子調器是靠控制軟體來實現調節和控制功能,穩定轉、穩定調速率等都可以進行程序設定控制,具有很強的通用性和功能擴展能力。對不同型號的汽油機,只要經試驗取得合適的控制參數,編制出相應的控製程序,就可以使用此電子調器進行轉控制。
  19. Analysis of the reasons of high engine speed droop

    淺析發動機調速率高的原因
  20. Steady state speed governing rate

    穩定調速率
分享友人