諧振模濾波器 的英文怎麼說

中文拼音 [xiézhènmólǜbōqì]
諧振模濾波器 英文
resonant mode filter
  • 諧 : Ⅰ形容詞1 （和諧） in harmony; in accord; in tune 2 （詼諧） humorous Ⅱ動詞（商量好; 辦妥） come t...
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 濾 : 動詞（除去液體雜質） filter; strain
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 濾波器 : [電子學] electric filter; （electric） wave filter; filter
  1. The siw was analysed by the poynting ’ s theorem and eda software. the relation between the leakage of electromagnetism energy and structure size was obtained

    從理論和軟體模擬上充分分析基於siw結構的諧振器濾波器的基礎電路。
  2. Through theoretic reckoning and simulating analyzing, several control strategies for shunt apf were compared and chose ip - iq arithmetic of the instantaneous reactive power theory control strategy as the right scheme to produce the instructing current. based on it, some new control arithmetic was subjoined to suppress the resonance in system and balance the dc side capacitor voltage. two topologies of main circuit were compared and chose the three - phase voltage - source converter with a split - capacitor as its main circuit structure

    通過理論計算和模擬分析，比較了並聯型apf的幾種控制策略的優點和缺點，從中選擇瞬時無功理論控制策略i _ p - i _ q計算方式為指令電流產生的演算法，並在此基礎上增加了抑制系統諧振和平衡直流側電容電壓的控制；比較了並聯型apf主電路的兩種常見形式，從中選擇了三相電壓型變流器的主電路形式；算出適合該apf的直流側電容和出線電感的參數；設計出能有效消除apf產生的高次諧波的高通濾波器。
  3. At this time, the approximate mechanical model of devices has been put forward, which frequency is 70 mhz, then we analyzed the euler ? bernoulli equation, find that the frequency is determined by the resonator ’ s density thickness and length ; the free - free - beam 、 coupled beam 、 support beam 、 transducer have been designed ; the model was simulated and modal analyzed on the coventorware and were consistent with the designed parameter. the silicon surface microfabrication process was developed and emphatically introduced several key surface microfabrication technologies, and was simulated by coventorware

    本文通過分析歐拉-貝努立方程，得出濾波器的共振頻率主要由諧振梁的密度、厚度和長度決定，考慮切變形和轉動慣量的情況下，完成微機械諧振梁、支撐梁、驅動電容的設計;在coventorware軟體上進行模擬，分析結果與理論設計比較好地吻合;對微機械濾波器的加工工藝進行設計，給出器件的完整的工藝流程，重點介紹微機械表面加工工藝，並在coventorware上進行模擬。
  4. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
  5. Several issues that are crucial for hts filters packaging and jointing are discussed in detail

    本文詳細介紹了屏蔽盒的設計思路，並對屏蔽盒諧振模式對超導濾波器的影響進行了討論。
  6. Abstract : since piezoelectric resonant filter can not effectively prohibit higher - frequency harmonic, the mechanism of this problem has been discussed by means of a specific example which shows that there exists lots of undesirable resonant frequencies of piezoelectric that would let pass undesirable signals. to solve this problem ， an ameliorated electrostatic mechanical resonant filter is proposed and a specific case is demonstrated. the example of electrostatic resonant micro - bridge asserts that by adjusting the gap of exciting capacitance the higher - frequency vibrating model of micro - bridge cannot be excited based on orthogonal character of intrinsic vibrating shape of micro - bridge, so that this kind of resonant filter can effectively filter out undesirable higher - frequency harmonic

    文摘:提出壓電諧振濾波器不能很好地濾除高頻諧波的問題，結合一個具體例子理論推導了壓電諧振濾波器存在許多干擾諧振頻率，從而不能有效濾除一些特定頻率的干擾信號.為了解決這個問題，提出一種改進型的靜電激勵諧振濾波器.為了說明其可行性，具體分析了改進型雙端固支微梁靜電激勵諧振濾波器，理論推導證實基於雙端固支微梁的各階振型正交的原理，通過適當調整激振電容的間距，雙端固支微梁的高階振動模態受到很好的抑制，因此這種諧振濾波器可以有效阻止濾波器中心頻率的高頻諧波的通過
  7. Since piezoelectric resonant filter can not effectively prohibit higher - frequency harmonic, the mechanism of this problem has been discussed by means of a specific example which shows that there exists lots of undesirable resonant frequencies of piezoelectric that would let pass undesirable signals. to solve this problem ， an ameliorated electrostatic mechanical resonant filter is proposed and a specific case is demonstrated. the example of electrostatic resonant micro - bridge asserts that by adjusting the gap of exciting capacitance the higher - frequency vibrating model of micro - bridge cannot be excited based on orthogonal character of intrinsic vibrating shape of micro - bridge, so that this kind of resonant filter can effectively filter out undesirable higher - frequency harmonic

    提出壓電諧振濾波器不能很好地濾除高頻諧波的問題，結合一個具體例子理論推導了壓電諧振濾波器存在許多干擾諧振頻率，從而不能有效濾除一些特定頻率的干擾信號.為了解決這個問題，提出一種改進型的靜電激勵諧振濾波器.為了說明其可行性，具體分析了改進型雙端固支微梁靜電激勵諧振濾波器，理論推導證實基於雙端固支微梁的各階振型正交的原理，通過適當調整激振電容的間距，雙端固支微梁的高階振動模態受到很好的抑制，因此這種諧振濾波器可以有效阻止濾波器中心頻率的高頻諧波的通過
  8. The steady compensation characteristic and the damping resonance characteristic of the equipment are analyzed in detail, theoretic analyze and experiment results have verified the feasibility and the correctness of the proposed topology

    模擬和實驗結果表明該裝置具有良好的穩態補償特性，並且可以較好的抑制無源濾波器與電網阻抗之間的串並聯諧振。
  9. Theoretical analysis and simulation results have shown that the circuit can not only improve filtering performance but also suppress the resonance between passive filter and power systems

    理論分析與模擬結果驗證了該電路不僅能改善系統性能，而且能抑制無源濾波器與電網之間的諧振。
分享友人
分享到 Line

分享到臉書