豎直位置 的英文怎麼說

中文拼音 [shùzhíwèizhì]
豎直位置 英文
erected position
  • 豎 : Ⅰ形容詞（跟地面垂直的; 從上到下的） vertical; upright; perpendicular Ⅱ動詞（使物體跟地面垂直） se...
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  1. The microscope stage is now rotated about its own vertical axis into the 45°position.

    現將顯微鏡載物臺繞其自身的豎直軸轉到45位置。
  2. Capable of being raised to an upright position

    可豎直的可以被抬升到豎直位置的
  3. < uk > the microscope stage is now rotated about its own vertical axis into the 45 position. < / uk >

    < uk >現將顯微鏡載物臺繞其自身的豎直軸轉到45位置。 < / uk >
  4. When the deviation between the placing position and construction reference line of caisson for gravity wharf is big enough, the verticality of upper structure, i. e. crest wall will be affected, and furthermore the visual quality of the wharf will be influenced

    摘要重力式碼頭沉箱安裝的位置與施工準線的偏差過大，會影響上部結構胸墻的豎直度，進而影響到碼頭觀感質量。
  5. Considering the characteristics of internal force and structures of simply supported pc bridges, a novel automatically step - up method ( asum ), taking into account the influence of steel arrangement, steel ratio, stress losses of tendons and time - dependent concrete modulus, to analyze creep and shrinkage effects is presented. this method accepts all kinds of expressions of creep and shrinkage, and it is easy to calculate total stress, strain of concrete and steel and deflection of bridge at any time, the expected prediction accuracy will be obtained by further dividing the time - step within duration

    首先，針對預應力混凝土簡支梁橋的受力特徵和構造特點，提出了徐變效應分析的全量形式自動遞進法，可考慮截面上鋼筋位置、配筋率、預應力鋼筋鬆弛、混凝土彈性模量隨時間變化等影響，且計算式可適用於任何形式的收縮、徐變特性表達式；建立的公式可方便地求解任意時刻混凝土、鋼筋的應力與應變和跨中梁體的豎向變形，計算精度可方便地通過計算時段的細分來控制，直至給出滿意的結果。
  6. We using a he - ne laser as light source, an optical tweezers with one optical trap was set up. the laser light and the observation light normally incident the objective back aperture. we can always observe and manipulate dielectric spheres at the top layers

    在儀器研製方面，我們將he - ne激光器與顯微鏡系統耦合構建了一套顯微鏡物鏡正置光鑷系統，作為光鑷光的激光從物鏡上方豎直進入物鏡目瞳，這樣光鑷光位於樣品池的上方。
  7. Due to the existence of the eddy and the abrupt bend of the stream line, the pressure on the four faces has the distribution as follow : the lowest pressure appears at several centimeters after the angle point along the top boundary, the highest pressure appears near the center line of the vertical shaft on the bottom boundary, near the angle point, the pressure on the inner boundary decreases with the decreasing height, the pressure on the external boundary decreases slightly in the right - angle region, and increases obviously near the corner

    迴流漩渦的存在，以及直彎處流線的急劇彎曲，導致壁面壓力分佈在上表面距彎點一定距離后出現壓力最小值，下表面上，在豎井中心線略偏下游的位置出現壓力最大值，豎井內表面接近彎點處出現壓力沿程降低的現象，豎井外表面壓力在進入直彎后先是沿程略有降低，在直彎角落處又明顯升高。
  8. Hence, large, long, and complex - shaped parts must be properly supported at critical positions to avoid sagging or preferably are hung with the long axis on the vertical

    因此，對尺寸大，長度大，形狀復雜的部件，必須正確支撐其關鍵位置，以防產生弧垂，也可以將其長軸豎直懸掛。
  9. Please return your seatbacks to their full and upright position

    請將您的座椅調整到原來的豎直位置
  10. All marks to be painted with piece in an upright position as to be erected

    所有標識採用噴漆，且位於單件的豎直位置以便於安裝
分享友人
分享到 Line

分享到臉書