負荷載 的英文怎麼說
中文拼音 [fùhézǎi]
負荷載
英文
negative load-
2. sritable for revolve aport and swing sport when under heavy weight and slow speed, aswell the ccoasion that not form fluid impetus lubrication because of frequently open and closed in the course of loading
2適用於高載低速下的旋轉運動搖擺運動及經常在超負荷下啟閉頻繁而不易形成流體動力潤滑的場合。Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system
發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。Finally, with caparisons of that three parapets properties cantilevered parapets has been adopt to the steel structure of light - weight buildings with gabled frames, numerical simulations have been carried out with that buildings, results of simulations show that device can also significantly reduce the area - averaged coefficient of wind pressure and high negative suction peaks on zones susceptible to wind pressure. formula has been proposed about the height of that parapet
最後通過三種女兒墻的性能比較確定對門式剛架設置懸挑女兒墻進行數值模擬，結果同樣表明懸挑女兒墻能明顯地降低門式剛架屋面風荷載敏感區的負壓峰值及屋面風荷載體型系數，並給出了女兒墻高度限值公式。Full load running
滿載負荷滿載運轉The products is of high water hydrophobe device usedin suitable and has the characteristics of aging resistance, resistance, tracking resistance, and corrosive resistance. it can withstand high bent load, strong impact force fn12 - 12 series indoor use high voltage load switch fn12 - 12 and fn12 - 12r is of three phases indoor use ac high voltage load switch for breaking and making the circuit of 50hz, 12kv system under rated loading
Fn12 - 12和fn12 - 12r組合電器是額定電壓12kv額定頻率50hz的三相高壓開關設備用於分合負荷電流閉環電流空載變壓器和電纜充電電流關合短路電流配裝接地開關的負荷開關，可以承受短路電流Many survey data refer to mortal down load and sedimentation be produced due to the negative friction in pile foundation. the inequable sedimentation endanger the pile foundation greatly
國內外一些實測資料表明樁基礎在使用階段負摩擦力可能產生非常大的下拉荷載和沉降，尤其產生的不均勻沉降對基礎危害最大。The characteristics of high pressure gyratory sprayed pumping discusses is presented, which is applicable in wide range of scope and ground layers, convenient for construction, long durability, wide source of materials. mechanism for subgrade strengthening : complex foundation of cement solid and earth between piles was formed by pulsant load of flowing pressure and spraying flow, water wallop, cavitation phenomenon, water wedge effect, extrusion force and air flow agitation etc so as to enhance foundation bearing force and reduce settlement and deformation
高壓旋噴注漿技術具有適用范圍、適用地層較廣，施工方便，耐久性好，材料廣闊等特點；其加固地基機理主要是通過流動壓、噴射流的脈動負荷、水塊的沖擊力、空穴現象、水楔效應、擠壓力、氣流攪動等效應形成水泥固結體與樁間土的復合地基，從而提高地基承載力，減少沉降變形。The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
為了避免劃傷，軸承上的最大負荷應該總是小於其卸載負荷。The simulated workload for a load or stress test
用於負載測試或壓力測試的模擬工作負荷。Five - yearly operational testing should be done by lowering the boat loaded to a proof load of 1. 1times the maximum working load of the winch, or equivalent load
五年度操作測試應該使船裝載超過最大裝載負荷的1 . 1倍或者等於裝載負荷的貨物，然後下沉。Electricity metering - data exchange for meter reading, tarif and load control - part 31 : use of local area networks on twisted pair with carrier signalling
電量計.抄表電費和負荷控制的數據交換.第31部分:帶有載波信號傳輸的雙絞線局域網的使用Contrast between this machine and traditional rolling screen : adopt lower driving, the carrying ability is great, running is stable which settle the problem, such as great torsional moment of central drive, startup loading is great with shock of chain driving
本機與老式滾筒篩相比，因為採用下傳動有承載能力大運轉平穩，特別克服了中心傳動扭矩巨大，起動負荷大，鏈傳動沖擊等缺點。In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high
針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行特性進行詳細分析，變頻器輸出的電壓波形諧波大，沖擊大，電壓上升率高達6600v / s ，是普通正弦交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低，額定頻率在8 - 20hz ;調速范圍寬，最低運行頻率低到0 . 5hz ，起動次數相當頻繁，每小時高達600 - 800次，沖擊負荷大，過載能力要求較高。Because traffic flow greatly increases in recent years and the rank of actual driving load enhances, causing this bridge to be at the excess load the service condition, so in order to guarantee the bridge ' s transport security, the main body structure of the bridge should be reinforced
摘要長沙市八一路跨線橋由於近年來交通流量大增，實際行車荷載等級提高，使得該橋處于超負荷的營運狀態，為了保證大橋營運安全，需要對此橋的主體結構進行加固，在選擇加固方案時對比了三種加固方法：鋼混凝土組合結構加固方法、混凝土結構擴大截面加固方法、粘鋼加固方法。The elastic methods are beam - columns method, the pseudo load method, the pseudo lateral load method, the iterative gravity load method and the negative rigidity method
常用彈性分析的方法有：樑柱法、虛擬荷載法、虛擬側向荷載法、迭代重力荷載法和負剛度法。Product this company, brush of british, high - handed limit that manufacturing technology produce to flow fuse box, products suitable for family exchenge 50hz, specified voltage 3kv kv, 6kv 7. 2kv, 12kv 15kv system, can cooperate and is used with other protection electric apparatuses such as the on - load switch, vacuum contactor, as high - handed motor, electric power voltage transformer and electric power overload or holding up of equipment, etc. protect the component
本產品是英國brush公司高壓限流熔斷器製造技術生產的，產品適用於戶內交流50hz ，額定電壓3kv 3 . 6 kv ， 6kv 7 . 2kv ， 12kv ， 15kv系統，並可與其它保護電器如負荷開關，真空接觸器配合使用，作為高壓電動機，電力變壓器及電力設備的過載或短路等保護元件。Css packaging - small load carrier systems - column stackable system
包裝.低負荷載運系統.柱形疊架制Bss packaging - small load carrier systems - bond stackable system
包裝.低負荷載運系統.聯結式疊架制The positive load take absolutely advantage in the first spatial pattern of year and seasons. especially that the precipitation field load of winter is all positive. not in the southwest of china because of southwest monsoon etc. system ; the characteristics of the second spatial pattern are that most of the area is taken up by positive load in year and four seasons, the west of talimu basin is the center of negative load of the year, spring and autumn vector fields ; east of zhungeer basin is the center of positive load of the third spatial pattern of year, spring, summer and winter, the center of negative load is often in east of chaidamu basin, but the distribution center of autumn is in east of zhungeer basin ; the distribution of the fourth spatial pattern is difficult to describe and forms several centers of positive and negative load ; several centers of positive and negative load also appear, the distribution of load fields of the fifth spatial pattern of year, spring and winter represents the situation of " +, -, + " from southeast to northwest ; the complexity of the sixth spatial pattern is more stonger than that of the fourth and the fifth spatial pattern, several centers of load fields of year and each season often appears inverse situation of the positive and the negative load. but the centers are still most in zhungeer basin, chaidamu basin and talimu basin
第一空間型中，年和四季都是正荷載占據絕對優勢，特別是冬季降水場皆為正值，只是西南地區由於受西南季風等系統的影響，表現為與其它地區的不同；第二空間型的特點如下：年和四季分佈皆為正荷載占據大部分區域，負荷載中心年、春季和秋季分佈中都是位於塔里木盆地西部地區；第三空間型正荷載高值中心除秋季外都是處在準格爾盆地以東地區，負荷載中心多在柴達木盆地以東地區，秋季卻處于準格爾盆地以東地區；第四空間型分佈就較復雜無章法可言，形成多處正負荷載中心；第五空間型特徵是這樣的，同樣是多個荷載中心出現，年、春季和冬季中的荷載場分佈從東南到西北大體呈現「 + 、 - 、 + 」的特點；第六空間型分佈的復雜程度較之第四、第五空間型更大，年和各季分佈比較中多個荷載中心常出現正負相反的情況，但中心仍以柴達木盆地、準格爾盆地和塔里木盆地為主。Packaging - small load carrier systems - common requirements and test methods
包裝.低負荷載運系統.通用要求和試驗方法分享友人