負載載入 的英文怎麼說

中文拼音 [zǎizǎi]
負載載入 英文
load
  • : Ⅰ名詞1 (負擔) burden; load 2 (虧損) loss 3 (失敗) defeat Ⅱ動詞1 [書面語] (背) carry on th...
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • : Ⅰ動詞1 (進來或進去) enter 2 (參加) join; be admitted into; become a member of 3 (合乎) conf...
  • 負載 : [電學] load
  • 載入 : load
  1. In this paper, a kind of output current feed - forward circuit is added into the input of the current loop. by adding this compensatory circuit, the output character of the inverter is improved greatly

    本文還研究了一種提高逆變器輸出電壓外特性的思路,通過將電流正反饋給逆變器的電流環輸端,從而達到提高輸出電壓的外特性的目的。
  2. As a rule, the immunosensors is to coat the surface of crystal with antibodies or antigens, immerge to muster solution, binding to the immobilized antigens or antibodies and take place immuno - reaction, can cause a frequency change of the quartz crystal, and the frequency changes are proportional to content of antigens or antibodies in muster solution

    通常將抗體(或抗原)固定於晶體表面,浸樣液時,與抗原(或抗體)產生免疫反應,使晶體表面質量增加,頻率降低,其頻移值與樣液中抗原(或抗體)含量成正比。
  3. The former was related to mn doping, both of p - carries supplied by la3 + or oxygen hole and n - carries induced by changing mn4 + into mn3 + can be locally displaced and simultaneously response with external electric field., furthermore due to the overlaps between positive and negative carries. the latter was due to the phase transformation between orthorhombic and cubic, which was in fact the curie point

    前者為la ~ ( 3 + )和氧空位等產生的p型流子和mn離子變價引的n型流子在外電場下發生局域重排產生的流子極化,且由於正流子的迭加效應所致,該介電峰與mn離子的摻相關;後者為體系出現相應的正交與立方結構的轉變所致,也即居里點。
  4. Then will the earth tremble, and the sea bear no ships ; heaven will not support the stars in their orbits, all voices of the gods will be forced into silence ; the fruits of the earth will rot ; the soil will turn barren, and the very air will sicken with sullen stagnation ; all things will be disordered and awry, all good will disappear

    然後大地會顫動,海洋不能船隻;天空不能支持星星自身的軌道,所有眾神的聲音會被迫進寂靜,大地的果實會腐爛;土壤會變成荒地,每處空氣都有沉沉不樂的停滯而使得惡心,所有事物都變得無序和歪曲,所有的美好都消失。
  5. Finding a feasible and efficient load balanced strategy for the ultra - scalable multi - plane multi - stage switch architecture is a top of nowadays research. the dissertation proposes a two - stage load balanced scheme for the ultra - scalable multi - plane multi - stage switch architecture based self - routing and non - blocking permutation benes network. the approach uses reasonable and efficient logical queueing strategy and schedule scheme in ingress traffic managers and switch planes to realize the two - stage load balancing of ip traffic which for different destination addresses

    本文提出一種適用於基於完全可重排無阻塞benes拓撲構建的多平面多路徑(多級)超大容量交換結構的兩級均衡策略,通過在輸流量管理器和benes交換平面內部實施合理而高效的隊列組織調度方法,有效實現了基於不同目的地址的ip流量在兩個層次上的均衡,較好彌補了ciscocrs - 1系統在平面選擇和中間級選擇時所採用的簡單隨機或輪循方案的不足。
  6. To the zvt - pwm soft - switching converter, not only the resonant parameters but the input and output voltage and the load can affect the converter efficiency. a detailed research of a typical zvt - pwm buck converter is done in this paper

    對zvt - pwmbuck變換器而言,除了諧振參數對工作效率有很大的影響外,變換器輸輸出電壓和所帶對工作效率都有影響。
  7. While network - based intrusion detection systems usually detect packet headers or part of those headers, this system examines the packet payload as well as headers. not only the attributes are detected respectively, but also the relationships of attributes occurrence are detected according to a set of conditional rules, which is generated automatically by a machine learning algorithm

    常見的基於網路的侵檢測系統一般只對網路數據包的包頭或包頭中的某些內容進行考察,而本文實現的原型系統不僅考察數據包的包頭,而且還考察數據包應用的部分內容。
  8. Considering that electromechanical actuator ( ema ) has the feature of being sensitive to the parameter perturbation and load disturbance, being poor in rigidity etc., deep research has been done to the principle and design method of the ema control system by using the robust control theories

    針對電動舵機存在的易受參數攝動及擾動影響、剛度較差的特點,採用魯棒控制理論,對電動舵機控制系統設計理論及方法進行了深研究。
  9. In this paper, the drive theory of the large ratio friction transmission is studied ; a new type elliptical cam wave generator is designed ; the large ratio friction transmission prototype is designed and manufactured ; based on the ansys finite element method software, structure of the elliptical cam is analyzed ; precision index of the manufactured large ratio friction transmission prototype, such as transmission accuracy, least step, stability of the least step, load capacity is measured by the absolute rotary encoder. by analyzing the measurement data and research content, it is think that the new elliptical cam wave generator could overcome a good many problems brought by processing errors, facilitate size precision adjustments, input moment can be achieved in the form of a pure force couple importing ; through this study, " the large ratio friction transmission prototype " could apply in practical engineering basically

    本文研究了大速比摩擦傳動的傳動理論;設計了新型橢圓凸輪波發生器,設計製作了大速比摩擦傳動樣機;用軟體ansys對所設計的橢圓凸輪結構進行了有限元分析;用19位絕對式編碼器測試了大速比摩擦傳動機構的傳動精度、最小步距、最小步距的穩定性以及帶能力等各項精度指標;對測量數據和研究內容進行了歸納和整理,認為新型橢圓凸輪波發生器克服了加工誤差帶來的諸多問題,新型橢圓凸輪波發生器可以進行尺寸精度調整,能夠達到輸力矩以純力偶的形式輸;通過本項研究,基本可以使「大速比摩擦傳動機構」在工程中得以應用。
  10. In order to solve the default of the limited valid scope and discontinuity characteristic, introducing the state continuous conversion gene based on establishment of respective mathematics model for low and magnitude current scope, and integrate with them reasonably then having established the mathematics model of suitable whole scope and having solved present mathematics model existent problems

    本文針對目前電弧爐數學模型存在的適用范圍有限、特性不連續等缺點,在建立了分別適合大、小電流區域運行特性的數學模型的基礎上,引狀態連續轉換因子,將分別適合大、小電流區域運行特性的數學模型有機結合為一個整體,建立了適合全范圍的數學模型,解決了目前數學模型存在的問題。
  11. Based on the six - port relative power theory that for a given load the relative power ratios of different ports are left unchanged with the input power to the six - port varied, characteristic parameters of detectors can be obtained through the least - square method

    根據六埠相對功率理論即對某一各埠相對功率比值不隨輸功率變化,由最小二乘法得到檢波器的特徵參數,結合四標準法,確定六埠網路的系統常數。
  12. The subject inducts digital time division technology ( pwm ), which is more advantageous at the accuracy and the predigest of hardware than simulant multiplication. what they call measuring power energy reasonably is that measuting except harmonics power energy fed back power. yet it realizes reasonable measurement of power energy which measures by base wave ac parameters method base on digital time division

    本課題引了數字時分割( pwm )脈寬調制技術,在測量的準確性、硬體電路的簡化等方面都比模擬乘法器具有較高的優越性。所謂合理的計量電能,就是不計非線性回饋給電網的的諧波電能,而採用基於數字時分割的基波交流參數測量的方法,真正實現了電能的合理計量。
  13. The voltage ir on core adopts semienclosed insert model. the current element adopts two - stage compensation to have wide load property. the whole plasticenclosed voltage coil. can withstand instantaneous large voltage impulse. the double jewels bearing or the magnetic - propelled bearing can ensure long lifetime. the bipolar aluminium nickel cobalt damping magnet steels have high coercivity, stable magmetic property. the electric function is in accordance with iec521 international standard

    :電壓鐵芯採用半封閉插式,電流元件採用二級補償使表計具有寬的特性。全塑封的電壓線圈能稱說瞬時大電壓沖擊。雙寶石軸承或磁推動軸承確保表計長壽命。
  14. Because of block in head of line ( hol ), input buffer strategy make the whole switch system performances declining drastically at heavy oflbred load, and some improvements of input buffer strategy are put forward to overcoming tlle head of line block. virtual output queues ( voq ) is chosen as input buffer strategy. dpa and ilqf ce1l scheduling algorithms for voq are silllulated

    由於輸緩存的隊頭阻塞使得高條件下輸緩存策略的交換系統各方面性能急劇下降,由此提出了克服輸緩存隊頭阻塞的改進方法,最後本文決定選用虛擬輸出隊列( voq )的輸緩存策略,並且研究了與虛擬輸出隊列相對應的ilqf (最長隊列優先)和dpa (對角線優先)信元調度演算法,為交換系統的asic設計提供依據。
  15. Thirdly, it simulated the pumping circuit & dividing circuit with the widely used software matlab / simulink. the displacement of the rod piston and the impact of hydraulic are analyzed in the different input flow ( frequency of pump ) and different reversing time. it found out the cause of hydraulic impact ( one - to - one incorrespondence between the response time of dividing circuit and the operation time of rod piston ), and gave some methods to weaken hydraulic impact. in the final part of the paper, the reliability of the theory analysis is further verified by the experiment of hydraulic system

    首先在流變學原理的基礎上,深分析混凝土在輸送管道內的流動狀態,得出混凝土泵的特性方程;然後根據功率鍵合圖的建模方法,建立泵送迴路和分配迴路的數學模型,並運用模擬軟體matlab simulink對泵送和分配迴路模型進行了模擬,分析了在不同的輸流量(泵送頻率)和換向時間下,活塞桿的位移和系統的液壓沖擊情況,找到了引起液壓沖擊的根本原因(即分配迴路的響應時間(固定值)與活塞桿的運動時間(變化值)不相匹配) ,並提出了相應的改進方法。
  16. This article analyses the nqs thoroughly, including its job management functions, its load sharing and its architecture

    較深的分析了nqs ,包括nqs的作業管理功能、共享、系統結構等。
  17. Implants for surgery - wear of total knee - joint prostheses - loading and displacement parameters for wear - testing machines with displacement control and corresponding environmental conditions for test

    外科植物.全部膝關節假肢的磨損.帶位移控制和相關試驗環境條件的磨損試驗機械的和位移參數
  18. The type zk01. 720 is a self aligning rubber foot, combining excellent load introduction with low profile design

    型號zk01 . 720是一個自調整橡膠底座,有很好的方式,而且是低外形設計。
  19. The inductive voltage of the thunder and lightning and the produced disturbance voltage when the inductive load turns on or is separated from the power network is main disturbance pulse voltage

    摘要雷電感應電壓和感性或脫離電源電路時所產生的干擾電壓是電源網主要的干擾脈沖電壓。
  20. For the cell working range ascertainment, the algorithm determines the maximum output load, the minimum output load, the maximum input signal slope and the minimum input signal slope ; for the cell working surface representation, the algorithm inserts the characterization points dynamically. the table optimization algorithm for redundantly characterized points is proposed. its result table can represent the whole parameter surface accurately and concisely

    通過計算單元在各測試狀態下的最大、最小輸出,輸信號的最大、最小斜率,演算法能精確計算單元的工作曲面范圍;通過參數測試點的動態插,演算法能獲得最佳的參數測試點,最大程度地表徵整個參數曲面空間。
分享友人