負輸入電阻 的英文怎麼說

中文拼音 [fùshūrùdiànzǔ]
負輸入電阻 英文
negative input resistance
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. The results show that the electron mean drift velocity is affected by the cathode radius, the impedance of the load diode, the inner radius of vanes and the input voltage

    結果表明電子平均漂移速度決定於陰極桿半徑、負載二極體阻抗、陽極慢波葉片內徑和輸入電壓。
  3. If line length is half wave at a certain frequency and both the load resistance rt and source resistance rs are higher than the characteristic impedance zo, then both the voltages at input and at load are maximum at that frequency and both the voltages at input and at load are minimum at half of that frequency

    負載端電阻及電源電阻均高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最高，在該頻率之半時則電壓均為最低。
  4. If line length is half wave at a certain frequency and the load resistance rt is lower while source resistance rs is higher than the characteristic impedance zo, then both the voltages at input and at load are minimum at that frequency and both the voltages at input and at load are maximum at half of that frequency

    負載端電阻低於傳輸線特性阻抗及電源電阻高於傳輸線特性阻抗情況下，當線長為某頻率波長之半波，則輸入端與負載端電壓在該頻率均為最低，在該頻率之半時則電壓均為最高。
  5. Firstly, under the assumption that the output driving torque generated by the stepper motor of the mirror is constant, such influence analysis is conducted. secondly, a mathematic model of the stepper motor is given. under the assumtion that the input impulse frequence is constant, the rotational motion of the stepper motor of the mirror with the mutual exertions of damping torque, friction torque and disturbance torque generated by satellite platform ' s attitude motion is simulated and analyzed

    對衛星平臺姿態振動對紅外相機掃描機構轉動的影響進行了系統深入的模擬分析:首先在步進電機驅動力矩一定條件下，模擬分析了星體姿態運動干擾力矩對紅外相機掃描鏡轉動的影響;接著建立了步進電機的數學模型，在步進電機輸入脈沖頻率一定條件下，模擬分析了步進電機在阻尼力矩、干摩擦力矩、平臺干擾力矩等負載轉矩的共同作用下的轉動情況。
  6. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  7. When the input voltage varies from 40v to 60v and the output side varies from no load to rated resistance load, the output voltage will vary within 1. 3 % with the thd of less than 2 % and the highest efficiency of 86. 3 %

    當輸入電壓變化、輸出從空載變化到額定阻性時，輸出電壓變化量小於1 . 3 ，正弦輸出電壓波形失真度小於2 ，變換效率最高為86 . 3 ，額定阻性負載時效率為84 . 4 。
分享友人
分享到 Line

分享到臉書