負電極 的英文怎麼說

中文拼音 [fùdiànjí]
負電極 英文
negative electrode; cathode
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電極 : electrode; pole
  1. Presence of vulcan xc - 72 active carbon powder in the pt / moox / gc composite electrode by electrochemical codeposition made peak potential of methanol oxidation a further negative shift of about 50mv and a further promotion of co - tolerant performance for methanol oxidation

    催化劑中vulcanxc - 72活性碳粉的引入即共沉積制備的pt moo _ x c gc電極催化劑甲醇氧化峰電位又進一步負移50mv左右，抗co中毒催化性能又進一步提高。
  2. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  3. The elect rons, being negative charges, arerepelled by the negative pole

    21由於電子是負電荷，所以為負極所排斥。
  4. A molecule where the centers do not coincide is called a polar molecule.

    正負電荷中心不重合的分子稱為極性分子。
  5. A lot of experiments have been done in the process of exploiture soft packaging li - ion battery about how to choice the rational arts and crafts. the content include : how to deal with the collector, add how much pvdf in the material, how long the material need to stirring and the right viscidity, how much condubtivity agent the electrode need, what theckness is best, choice different collectors, the degree of dryness of the electrode, theckness of pressed model, how much electrolyte will be added, placement how long after added the electrolyte, system of formation how to influnce the battery, in formation the battery need or not need preesure from outside, how to vacuumize and the optimize matching positive pole and negative pole. with these practice make sure the parameter of the positive pole should less than 90 m ; according to different vacuumize order the conduc - tivity agent in anode will be 5mass % and 9mass %, respectively, and in cathode the data is 2mass % ; every 100mah added to 0. 4 ml electrolyte ; before formation the battery should be placement 8 hours and the system of formation must be less than 0. 01c before the voltage reach to 3. 0v ; should press in outside when battery in formation ; to these batteries which capacity more than 350mah the vacuum time not excess 15s ; the optimize matching positive pole and negative pole between 2. 10 : 1 and 2. 15 : 1. finally make out the battery which cycling performance and security are all very well

    液態軟包裝鋰離子電池的研究主要是對關鍵工藝進行了優化設計，具體包括:集流體的處理、 pvdf的加入量、漿料攪拌時間和粘度、導電劑的加入量、電極膜的厚度、不同集流體的選擇、電極膜的乾燥程度、壓型的厚度、電解液的加入量、注入電解液后靜置時間的長短、化成制度的影響、化成時電池所具有的壓力影響、抽真空的處理、正負極活性物質的匹配。最後確定出液態軟包裝鋰離子電池最佳工藝參數:正極膜的厚度小於90 m ;根據化成時不同抽真空順序，確定正極膜中的導電劑的加入量分別為5mass %和9mass % ;負極膜中導電劑的加入量為2mass % ;電解液的加入量為每100mah添加0 . 4ml ;化成前電池的靜置時間應當大於8h ;電池在3 . 0v之前採用小於0 . 01c的化成制度;在化成過程中應當施加一定的外部壓力;對於350mah的電池抽真空的延時不應大於15s ;而正負極活性物質的質量比應當在2 . 1 : 1 2 . 15 : 1之間。
  6. One was using the cyclic ether to pretreat the lithium metal electrode. and a favorable surface sei film was wished to form on the lithium metal, to enhance the interface stability of lithium electrode and the cycleability of lithium battery

    方法一:嘗試採用環醚類化合物對金屬鋰電極進行表面預處理，預先在金屬鋰表面形成良好的表面sei膜，提高鋰電極界面穩定性和鋰負極的電化學性能。
  7. The dopping of clo4 - had a great effect on the sensitivity of the sensor. the glucose oxidase could be immobilized in the polypyrrole membrane when the pyrrole is polymerizing on the electrode

    當聚吡咯在電極上氧化聚合時，會形成帶正電荷的聚吡咯骨架，帶負電荷的酶就會通過電荷吸引摻雜到骨架中，從而得到固定。
  8. Lithium metal is one of the electrode materials those have the highest specific mass energy, and the lithium secondary battery with lithium metal anode always attracts people ’ s attentions. whileas, before the commodity of lithium secondary battery, it is the dissatisfactory cycleability and safety of lithium metal anode that must be resolved firstly

    金屬鋰是目前已知的質量比能量最高的電極材料之一，以金屬鋰作為負極材料的鋰二次電池長期受到人們的關注，但在其商品化之前，必須解決金屬鋰負極在循環性能和安全性能上的不足。
  9. The results show that : nano - nickel powder is not useful for mh electrode during the high rate discharge phase as a conductor or additive ; superfine nickel powder is applicable for the conductor of the negative because of the good performance especially the cyclic stability at 1c rate by using 5 % ( mass percentage ) nickel powder ; the utilization of alloy, specific mass and volume capacity are increased with the decreased particle size of nickel powder in negative, however, the capacity fading rate at 1c discharge rate is also increased, so the capacity and the cyclic stability should be taken into account to make a choice of the particle size

    結果表明： mh電極中加入納米鎳粉對負極的大電流放電性能不利。 mh電極中加入超細鎳粉后電極綜合性能好，尤其是1c循環穩定性，其最佳添加量為5wt 。減小鎳粉粒度提高了電極合金利用率、質量比容量、體積比容量，但增大了負極1c容量衰減率，因此鎳粉粒度的選擇應綜合考慮mh電極容量和循環穩定性。
  10. Experience shows that the positive electrode always burns away more rapidly than the negative.

    經驗表明，正電極比負電極燒蝕得快得多。
  11. The combination of negative electron affinity ( nea ) photocathode and micro channel plate ( mcp ) brings the iii image intensifier. because of its high performance, the iii image intensifier has been developed rapidly and used widely in the short several decades after it had been found

    負電子親和勢（ nea ）光電陰極和微通道板（ mcp ）的結合產生了三代像增強器，由於這類像增強器具有優良性能，在發現后的短短數十年中獲得了迅猛發展和廣泛應用。
  12. Thirdly, a new method of compositing zno nanometer particles was studied

    Cds在電場下電泳到負極上，構成ai cds電極。
  13. It has high selectivity in adsorpting water, polar molecule or polarizable molecule on account of the existing of mighty coulomb field and polar interaction in the internal of crystal cave of zeolite, the high electric field gradient and the uneven surface caused by the exposure of exchangable cation of equilibrium framework negative charge in framework structures

    由於分子篩晶穴內部有強太原理工大學碩士學位論文摘要大的庫侖場和極性作用，再加上骨架中大量平衡骨架負電荷的可交換陽離子的暴露造成的高電場梯度及表面的不均性，使其對水、極性分子及可極化的分子具有高選擇的吸附性能。
  14. The other was to research new li - al solid solution alloy material and use it as anode in lithium battery. by the trace alloy component, aluminum, doping in lithium metal, it was hoped to improve the sei film stability of lithium / electrolyte interface and consequentially enhance the performances of lithium anode. meanwhile, different form the previously studied lial alloy that had very high content of aluminum, such alloy should not decrease the mass specific energy and electrochemical potential of lithium electrode

    方法二:研究新型鋰鋁固溶體合金材料並將其應用於鋰二次電池中，通過微量合金成份鋁的摻雜提高鋰電極/電解質界面sei膜的穩定性，進而提高鋰負極性能;而該合金不會像以往高鋁含量的鋰鋁合金那樣降低鋰電極的質量比能量和電化學反應電勢。
  15. All analysis and simulations results indicate several methods improving the insulation recovery of spark gap switch : ( 1 ) using the gas with good thermal conductivity, such as h2 and sf6 ; ( 2 ) using the gas flow ; ( 3 ) utilizing the v / p cure ; ( 4 ) modifying the geometry and size of the electrode ; ( 5 ) using the gas with good electronegativity, such as sf6. some experiments on the multi - pulse operation of high power spark gap switch are carried out. the insulation recoveries of switch without and with gas flow are both investigated

    結合理論分析和模擬結果，提出了氣體火花開關多脈沖運行特性可採用如下方法: （ 1 ）使用導熱性能好的氣體，如h2 、 sf6等; （ 2 ）採用吹氣的方法; （ 3 ）增大氣壓，在電極表面增加細小結構，構造平穩的v / p曲線; （ 4 ）改良開關電極結構和尺寸，採用奶頭-半球結構的電極; （ 5 ）使用電負性強的氣體作為開關絕緣氣體，如sf6 。
  16. Hyperpolarization and repolarization both describe increased electronegativity within the cell.

    超極化及再極化都表明細胞內負電性的增強。
  17. In addition, it is found that dc electric field weakens the effect of release agent and strengthens the binding strength between epoxy resins and anode in the condition of the existence of release agent. but this effect of electric field is not discovered between epoxy resins and cathode

    另外，本文通過實驗研究還證實：在有脫模劑存在的情況下，固化過程中直流電場的存在會弱化脫模劑的作用進而強化環氧樹脂固化物與金屬正電極間的粘接強度，但直流電場對環氧樹脂固化物與金屬負電極間的粘接強度沒有明顯影響。
  18. Tending to attract electrons to form a chemical bond

    負電極的有吸引電子以形成化學鍵的傾向的
  19. Method of measuring discharge capacity of hydrogen absorbing alloys for a negative electrode of a rechargable nickel - metal hydride battery

    可再充電的鎳金屬氫化物蓄電池的負電極用氫吸收合金的放電能力測量方法
  20. Positive electrode and negative electrode that execute spanning crack prevention are simulated as the source point and merged point, so the temperature field owing to the concentration of current around the crack tip is educed at the moment when the current is switch on

    將實施跨越止裂時的正、負電極比擬為電流場中的源和匯，從而導出了在瞬間電流作用下，裂紋尖端附近區域因繞流而形成的溫度場。
分享友人
分享到 Line

分享到臉書