起始誤差 的英文怎麼說

中文拼音 [qǐshǐwùchā]
起始誤差 英文
initial error
  • 起 : 起Ⅰ動詞1 （站起; 坐起） rise; get up; stand up 2 （取出; 取走） draw out; remove; extract; pull 3...
  • 始 : Ⅰ名詞1 （最初; 起頭） beginning; start 2 （姓氏） a surname Ⅱ動詞（開始） start; begin Ⅲ副詞[書面...
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 起始 : origin; origination; parentage; germ; initiation
  • 誤差 : error
  1. It is especially attractive for the downlinks and suppressing intercell mai. when multiuser detector is adapted in blind mode, it usually adopts eignvalue decomposition or singularvalue decomposition of received sample correlation matrix and tracking alrithgms, which result in high computational complexity. at the same time, approximation computation in tracking alrithgms also result in slow convergence

    為實現盲自適應檢測，通常採用對接收信號樣本矩陣進行特徵值分解（ evd ）或奇異值分解（ svd ）后進行跟蹤，由此帶來的子空間秩跟蹤使得實現復雜度很高；另一方面，在跟蹤演算法中考慮一些實際情況而作出近似處理，從而引起誤差積累和正交性誤差，導致每次跟蹤開始階段跟蹤速度變慢。
  2. Abstract : the attitude error performance of electrostatic gyro should be understood and the relevant error equations must be set up in order to ensure the navigation precision of esgm. the relation between the navigation errors and the attitude errors of gyro was derived by use of spherical triangle. the simulation results show that the temporal performances of the longitudinal and distance errors which come from the initial alignment errors are periodically variational. they also show that the longitudinal and distance errors resulted from gyro drifts are not convergent in time. thus, the effects of initial alignment errors and gyro drifts can not be neglected and must be estimated and compensated

    文摘:為了保證靜電監控器的導航定位精度，需要了解靜電陀螺的姿態誤差特性，建立相應的誤差方程.本文採用球面三角形原理推導了導航定位誤差與陀螺姿態誤差的關系式.模擬結果表明，由初始定向誤差引起的經度誤差和距離誤差的時間特性是周期變化的；由陀螺漂移引起的經度誤差和距離誤差是隨時間發散的.因此，初始定向誤差和陀螺漂移的影響不能忽略，必須對其進行估計和補償
  3. In order to solve the problems of flux estimation using the voltage model, such as the initial value and the drift of pure integrator, a flux - observer - based method is applied

    利用磁通觀測器，可避免用電壓模型推算轉子磁通時遇到的積分運算問題（初始值確定和誤差積累引起的積分漂移） 。
  4. In order to improve the quality of the voltage signals, this paper has adopted the scheme of three phases and six organs in signal - generator part, which can eliminate the errors caused by the assembly warp and the zero shift of organs. this paper also has analyzed the distribution and varying rules of the magnetic field in the signal - generator part, then based on the conclusion of the analysis improved the structure of signal - generator, which could completely eliminate the noise signal caused by the roughness of the face on the magnetic steel ring. the improvement not only met the requirement of this study, but established the theory foundation for the super - high precision magnetic encoder in future research

    因此，為提高原始電壓信號的質量，本文採用三相六元件的信號發生方案，通過差分處理濾除了由於裝配偏差和零點漂移帶來的信號誤差;本文對編碼器信號發生結構進行了磁場分析，依據磁場分析的結論對編碼器常用的信號發生結構進行了改進，改進后的結構利用積分原理在理論上能夠完全消除信號中由磁鋼環表面粗糙度引起的信號噪聲，進一步提高了信號質量，此結構不僅滿足了本課題的需要，而且為今後研製超高精度的磁電式編碼器奠定了理論基礎。
  5. Meanwhile it retains evenness on lift force to prevent leakage of residue that is caused by installation clearance error or changes in welding criteria, flow off molten iron as well as break - over welding, so that the ideal fosion depth and finishment have been fulfilled

    在需原動力的條件下，該機利用彈性夾角變化，隨著筒體轉動，使墊層焊劑始終緊貼筒體外側環向焊接區，並保持托力均勻防止因裝配間隙誤差或焊接規范變化而引起漏渣，鐵水下淌及焊穿現象，達到理想的熔深度和光潔度。
  6. Feedrate planning of continuous micro - line ' s start and end points are discussed, and the constraining conditions, including the machine ' s acceleration and deceleration capability, allowable error of corner machining, maximum acceleration and dynamical behavior of the machine, are established 。

    摘要針對連續小直線段高速高精插補演算法中起始點和終止點的速度規劃，建立了包含機床加減速性能、轉接處誤差控制、最大加速度以及機床負載功率等的速度約束條件。
  7. Because the ins error equation is unstable, some initial states error will cause error floating and error accumulating, if the filter observations were only position error, kalman filter will converge very slowly, and some states error ( such as yaw error ) will be great. since the milemeter altimeter and piloting could only output position information, this paper put forward a method, firstly estimateing states and then kalman filtering, to improve filtering effect. simulation proved that this method could effectively reduce the system states error, quicken filtering convergence and improve filtering precision

    由於慣導系統（ lsins ）的誤差方程是發散的，某些初始狀態的誤差會引起誤差的漂移和積累，當觀測量只有位置誤差時，卡爾曼濾波的收斂速度很慢，某些狀態（如方位角）誤差很大，而以上除慣導外的其它導航傳感器直接提供的只是位置信息，為了改善濾波器性能，本文根據里程計等傳感器的特點，提出了首先對狀態做出估計，然後在狀態估計的基礎上，進行卡爾曼濾波的方法。
  8. Different filtering methods have been tested to examine the effects of all kinds of filters. the correction of inertial sensor errors, navigation algorithm, coning motion, and sculling motion have also been investigated. based on the above works, the initial alignment on stationary base using imu with mdrlg has been carried out, and an usable navigation software has been completed

    對機抖激光陀螺引起的高頻振動的補償方法進行了研究，對不同的濾波方法進行了試驗;對機抖激光陀螺捷聯系統的儀表誤差補償、導航解算演算法、圓錐補償演算法和劃槳效應補償方法進行了研究;對靜基座條件下機抖激光陀螺捷聯慣導系統的初始對準方法進行了研究，編寫了實用的導航軟體。
  9. On the basis of deep research of its working principal, basic algorithm and error spread character, the gyro constant drift, acceleration zero error and constant initiation error of static pedestal strapdown inertial navigation system are quantitatively analyzed. furthermore with the medium precision inertial navigation device as the simulation object, we made some mathematical simulation

    詳細研究了捷聯式慣性導航系統的工作原理、基本演算法和誤差傳播特性；對靜基座條件下捷聯慣導系統中陀螺常值漂移、加速度計常值零位誤差和常值初始條件誤差引起的系統誤差進行了定量分析；以中等精度的慣性器件構成捷聯慣導系統作為模擬對象，進行了數字模擬。
  10. This controller has some advantages : when the initial error is large, the pd feedback part plays main role, and it avoids too large initial torque output ; when the initial error is small, the adaptive part plays main role, such guarantee the system has good dynamic character

    該控制策略的優點在於當初始誤差較大時， pd反饋部分起主要作用，而非線性pd的採用又避免了過大初始力矩輸出；當誤差較小時，自適應控制器起主要作用，從而保證了系統具有良好的動態性能。
  11. Finally, the effectiveness of the proposed method is verified through theoretical and numerical results for systems with both unknown time - invariant and time - varying parameters

    理論分析與模擬結果表明，跟蹤誤差信號在一預先指定區間上收斂到零，在起始區間段上被囿於死區所確定的區域中；並保證閉環系統中所有信號是有界的。
分享友人
分享到 Line

分享到臉書