超塑性 的英文怎麼說

中文拼音 [chāosùxìng]
超塑性 英文
superplasticity超塑性變形 superplastic deformation; 超塑性成型 superplastic forming; 超塑性鍛造 superplastic forging; 超塑性合金 superplastic alloy
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 塑 : 動詞（塑造） model; mould
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  1. When the specimens are deformed in a long time at the optimal superplastic deformation condition, the microstructure is coarsened sharply. if the deformation time is shortened properly or the deformation temperature is decreased appropriately or strain rate is increased, homogeneous and fine equiaxed crystal microstructure can be obtained

    在最佳超塑性條件下長時間變形時，合金顯微組織將發生明顯粗化，適當縮短變形時間、或適當降低超塑變形溫度及提高應變速率，可得到均勻細小的等軸組織。
  2. Isothermal superplastic solid - state welding of 4ocr and qcr0

    5的恆溫超塑性固態焊接
  3. Superplasticity of sic whisker aluminum matrix composite

    晶須增強鋁基復合材料超塑性
  4. High - strain - rate superplasticity of metal matrix composites

    金屬基復合材料的高速超塑性
  5. Progress in the study of superplasticity of silicon nitride ceramics

    4陶瓷超塑性的研究進展
  6. High strain rate superplasticity of mmcs

    復合材料的高應變速率超塑性
  7. High strain rate superplasticity in mb2 sic magnesium matrix composites

    復合材料的高應變速率超塑性
  8. High strain rate superplasticity in sicp reinforced az31 magnesium matrix composite

    金屬基復合材料的高應變速率超塑性
  9. High strain rate superplasticity and cavity behavior in mb2 sic magnesium matrix composites

    復合材料高應變速率超塑性及空洞行為
  10. Cavity behavior of sic mb2 magnesium matrix composites during high strain rate superplasticity deformation

    2復合材料高應變速率超塑性變形的空洞行為
  11. The quasi - superplasticity of as - cast lead brass was studied by monodirectional elongation experiment

    摘要採用單向拉伸對鑄態鉛黃銅進行了準超塑性研究。
  12. Study on superplastic diffusion bonding of different steels

    異種鋼材的超塑性擴散連接工藝研究
  13. Direct - reverse superplastic bulging can improve the thickness distribution greatly

    超塑性脹形存在厚度分佈不均和空洞等缺點。
  14. Variation of surface roughness of a sheet during superplastic deformation

    板料超塑性變形時表面粗糙度演化
  15. Fatigue property and superplastic deformation of bulk amorphous alloys

    塊體非晶態合金的疲勞性能與超塑性變形
  16. Superplastic co - deformation strengthening terms of flame spraying coating

    表面噴熔層超塑性變形強化及其協調變形條件
  17. Microstructural evolution during superplastic deformation in large - grained single phase ni - 48al intermetallics

    金屬間化合物超塑性變形過程中的組織演化
  18. Exploration enhancing strain stress of superplastic deformation using pendant hammer type tensile tester

    採用吊垂式拉伸試驗機探討超塑性變形速度的提高方式
  19. The superplastic behavior of tc6 titanium on the condition of different temperature and different strain rate was explored

    本文對不同初始應變速率和變形溫度條件下tc6鈦合金的超塑性變形行為進行了系統研究。
  20. The effects of temperature and strain rate were analyzed too. furthermore, the tensile fracture surface of tc6 titanium was analyzed by sem

    分析了tc6鈦合金在變形過程中不同變形溫度、初始應變速率對流變應力的影響規律，並且對變形溫度、初始應變速率在tc6鈦合金超塑性變形中的顯著性進行了探討。
分享友人
分享到 Line

分享到臉書