超導薄膜 的英文怎麼說

中文拼音 [chāodǎobómó]
超導薄膜 英文
superconducting film
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 導 : 動詞1. （引導） lead; guide 2. （傳導） transmit; conduct 3. （開導） instruct; teach; give guidance to
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 薄膜 : thin film; film; diaphragm
  1. Superconducting thin films ; pulsed laser deposition

    超導薄膜脈沖激光沉積原位後退火
  2. Growth and properties of tl - based superconducting film coated conductors

    系超導薄膜金屬塗層的生長與特性研究
  3. There are better performances in the films prepared by ba2ca2cu3ox target than by ba2cacu2ox target. the single - phase tl2ba2cacu2o8 hts thin film was obtained with a tc0 of 107k at the optimal tl2o partial pressure and thallination temperature 750. on excursion from the optimal conditions, there exist some impurities in the resultant films resulting in a reduction in tc0 and surface quality with change in the microstructure morphology

    研究結果表明，採用成分為ba2ca2cu3ox的靶材制備的薄膜性能要優于成分為ba2cacu2ox的靶材；使用組成式為tl1 . 9ba2ca2cu3oy的鉈片做鉈源時，形成的tl2o分壓達到最佳值；在最佳tl2o分壓和最佳鉈化溫度750的條件下，制備出了純相完全c軸取向的tl2ba2cacu2o8高溫超導薄膜，其tc0高達107k ，膜面均勻平整光滑，呈圓片狀組織；偏離最佳制備工藝參數的條件下，制得的薄膜中都含有一定量的雜相，雜相的生成使得tc0值下降，薄膜表面質量下降，薄膜組織形貌發生變化。
  4. Phase ; thermostability ; superconducting film

    相熱穩定性超導薄膜
  5. A measurement method of microwave surface resistance of large area high tc super - conductive thin films

    高溫超導薄膜微波表面電阻測試方法
  6. The purpose of this work is that preparing single - phase tl2ba2cacu2o8 hts thin film

    本文以實現制備純相的tl2ba2cacu2o8高溫超導薄膜為目的。
  7. It indicats that the growth temperature, annealing temperature and time greatly affects the quality of mgb

    超導薄膜表面形貌晶體結構超導電性的影響。
  8. Bounded convergence of forgetting factor least square algorithm for time - varying systems

    本系統是按照目前國際上高溫超導薄膜的微波表面電阻的測量標準方案
  9. The dc electric resistance test method for the critical temperature tc of a yba2cu3o7 - superconducting thin film

    釔鋇銅氧123相超導薄膜臨界溫度tc的直流電阻試驗方法
  10. Though both of the methods have it ’ s own advantage and disadvantage, the rs can be measured with high sensitivity

    這兩種方法雖然各有優缺點，但都能夠測量高溫超導薄膜的微波表面電阻，而且測試靈敏度較高。
  11. Besides, a 3 inch double - sided epitaxial ybco super - conducting thin film has been deposited on laalo3 ( 100 ) substrate with the optimum deposition conditions

    論文的最後階段，利用優化的工藝條件制備出了具有超導性能的3英寸ybco雙面超導薄膜
  12. First, we prepared amorphous bacacuo precursor thin films on single crystal laalo3 ( 001 ) substrate by rf magnetron sputtering. then tl2ba2cacu2o8 hts thin films were obtained by an ex situ post annealing

    本文採用射頻磁控濺射法在laalo3 （ 001 ）單晶基片上制備了bacacuo非晶前驅物薄膜，然後將前驅物薄膜進行非原位鉈化處理，制備了tl2ba2cacu2o8高溫超導薄膜。
  13. In the first step, effect of the target ' s components on properties of thin films was investigated. influences of tl2o partial pressure and thallination temperature on the component phases and properties of tl2ba2cacu2o8 hts thin films were studied in the second step of ex situ post annealing treatments

    在濺射沉積前驅物薄膜的過程中，研究了靶材成分對薄膜性能的影響；鉈化后處理過程中，研究了tl2o分壓和鉈化溫度對tl2ba2cacu2o8高溫超導薄膜相組成及其性能的影響。
  14. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
  15. With sem, x - ray diffraction analysis, magnetic measurement by magnetic property measurement system, the effects of growth and annealing conditions are analyzed

    超導薄膜，採用磁測量m - t x射線衍射掃描電子顯微鏡技術分析了各種沉積及退火條件對mgb
  16. As the manufacture technology of high temperature superconductor ( hts ) film is improved continually, it is applied more and more widely. then it is becoming urgent to measure the microwave surface resistance of hts film that is one of the most important parameters of hts film

    高溫超導薄膜制備技術的不斷提高使得薄膜的應用日益廣泛，因而對薄膜各種性能指標的測定也顯得更加重要，這就迫切需要對超導薄膜最主要特性之一微波表面電阻進行精確的測試。
  17. As the manufacture technology of high temperature superconductor ( htsc ) film is greatly improved, it is applied more and more widely. then it is becoming urgent to precisely measure the surface resistance of htsc film that is one of the most important parameters of htsc film

    高溫超導薄膜制備技術的不斷提高使得薄膜的應用日益廣泛，因而對薄膜各種性能指標的測定也顯得更加重要，這就迫切需要對超導薄膜最主要的微波特性參數微波表面電阻進行精確的測試。
  18. The obtained thin films were characterized by x - ray diffraction ( xrd ) - 2 scan. sem and edx were used for the films " morphology and compositional analysis. the temperature dependence of the resistance was measured by the standard four - probe technique

    運用x射線衍射的- 2掃描對薄膜的相組成進行了分析；採用sem和edx分別對薄膜的表面形貌和成分組成進行了分析；採用標準的四引線法測量了超導薄膜的臨界轉變溫度。
  19. At present, superconductor filter subsystems have been deployed abroad in the field of mobile communication and offered exceptional commercial performance. the design of hts filters is a comprehensive problem of network analysis. according to the condition of calculation and practical size of superconducting films, we configured compacted forward - coupled microstrip filter, with the aid of tumic and sonnet software

    高溫超導濾波器的設計是一個網路綜合的問題，根據我們目前的設計條件和超導薄膜的尺寸因素，我們選用了結構緊湊的前向耦合型電路設計，應用tumic和sonnet模擬軟體，設計了用於移動通訊頻段的高溫超導濾波器，並對幾個重要參數進行了實驗測試和分析。
  20. Superconducting mgb2 thin films were fabricated on single - crystal sapphire substrate by hfcvd and hpcvd, respectively. the experiments were carried out both in situ and ex situ. in situ method refers to acquiring mgb2 thin films directly during the deposition process. ex situ method is defined as obtaining mgb2 thin films indirectly by post - annealing of precursor b film in high mg vapor pressure at high temperatures

    實驗分原位法和非原位法兩種工藝，原位法是在薄膜沉積過程中直接生成了mgb2超導薄膜；非原位法是先在基片上沉積前驅物b膜，然後將b膜在mg蒸氣中高溫退火得到mgb2超導薄膜。
分享友人
分享到 Line

分享到臉書