超微粉末 的英文怎麼說

中文拼音 [chāowéifěnmò]
超微粉末 英文
ultra-micro powder
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 粉 : Ⅰ名詞1 （粉末） powder 2 （用澱粉製成的粉條或粉絲） noodles or vermicelli made from bean potato o...
  • 末 : Ⅰ名詞1 （東西的梢;盡頭） tip; terminal; end 2 （非根本、非重要的事物） nonessentials; minor detai...
  • 超微 : advanced micro devices
  • 粉末 : powder; flour; stive; smalls
  1. Lead hydrogen phosphite superfine powder, lead oxide phosphite hydrate superfine powder and tribasic lead sulfate superfine powder were prepared by micro - liquid - phase synthesis method ( mlps method ) in this paper. at room temperature, acetic acid worked as catalyst, lead oxide and phosphite or sulfate were blended thoroughly, then were ground for tens minutes

    本文採用微液相合成法制備了亞磷酸鉛、二鹽基亞磷酸鉛和三鹽基硫酸鉛超細粉末，以氧化鉛和亞磷酸或硫酸為原料，以醋酸為催化劑，在室溫下充分混合、研磨幾十分鐘，乾燥后即可得到產物。
  2. Nanometer ultra micro powder technology makes the ultra micro powder pearl powder more fine and smooth, like feather adhering to your skin, aiming to modify yellow and uneven skin color tone, presenting transparent, sunny, and crystal white perfect skin condition for 24 hours

    好處：納米超微細粉末技術使超細珍珠粉更細更滑，如羽毛般輕柔附著于肌膚，修飾偏黃和不均的肌膚色調，讓肌膚24小時呈現清透明媚、白皙晶瑩的完美狀態。
  3. Alumina is then extracted from the furnace and passed over vibrating sieves to obtain an extremely fine powder with a diameter of less than one micron

    將鋁氧粉從煅燒爐中提取出來。通過振動篩，篩出直徑不足1微米的超細粉末。
  4. In this thesis, the structure and basic characteristic of hexagonal ferrite absorbent were summarized, and popular methods to prepare ultrafine ferrite particles and hollow microspheres were introduced. hexagonal ferrite hollow microspheres were prepared by flame powders spraying technique and flame suspending solution spraying technique

    本文較為系統地概述了六角晶系鐵氧體吸收劑的結構和基本特性；介紹了當前鐵氧體超微粉末及空心微球的主要制備方法；用氧乙炔火焰粉末噴霧技術與等離子火焰溶液噴霧技術制備了六角晶系鐵氧體空心微球，對其結構和性能進行了一系列的探討工作。
  5. ( 3 ) the most principal factors that influence the supersonic atomization process include the flow ratio of the gas - liquid metal ( gmr ) value, the flow of atomizing of gas and the range of the inverse vortex taper. the more of the value of three factors, the more advantage they are for the atomization and the more fine the powders are. ( 4 ) the produced powders are the best in efficient atomization efficiency, particle diameter, particle shape and dispersion when the solder alloy is zhl63a, atomizing medium is n2, the protrusion h = 6. 0mm, atomizing gas pressure p = 100mpa, over - heat temperature t = 167 ( t = 350 )

    研究結果表明： （ 1 ）超音速霧化器的氣體流場在導液管下端形成一個倒渦流錐，在二維空間上呈軸對稱的雙峰分佈，負壓形成於這個倒渦流錐內； （ 2 ）修正後的霧化氣體速度公式可以滿足超音速霧化的要求； （ 3 ）影響超音速霧化工藝最根本的因素有氣液質量流率比（ gmr ）的大小、霧化氣體流量和倒渦流錐范圍，三個因素的值越大，對形成細粉越有利； （ 4 ）在焊錫合金為zhl63a ，霧化介質微n _ 2 ，導液管突出高度取h = 6 . 0mm ，霧化氣體壓力取p = 1 . 0mpa ，合金過熱度取t = 167 （ t = 350 ）時，所制得的粉末在有效霧化率、顆粒球形度、粒度及其離散度三個方面綜合性能最好。
  6. 2u. s nuoxin 360 circling spray coating technology : the entire coating procedure is controlled by microcomputer to be of constant temperature an constant velocity. spry gun circles by 360 spraying powder ensuring complete atomization as well as evenness and stability of powder on plate surface after static absorption. and ultra - long process of high - temperature solidification in furnace resuls in still better performance of adhesion surface evenness and smoothness without blistering or color difference

    2美國諾信360o旋轉噴塗技術：噴塗過程全程微電腦恆溫怛速控制，噴槍360o旋轉噴射粉末塗料，保證粉末塗料完全霧化，由板面靜電吸附后均勻穩定，通過超長程的固化爐高溫固化，附著力更強，表面更均勻更平滑，無起泡無色差。
  7. With a variety of active skin beautifying element of selected natural pearl essence, chlorophyll time - inverse non - trace repair factor and 100 pure aloe oil etc. adopting international advanced nanometer ultra micro powder technology and biological enzymolysis technology, it can perfectly cover face defect and line crack, adjust uneven skin tone, smoothen skin, build up skin transparency, in the meantime, it can resist pollution, improve skin tone, make your skin like crystal and lotus flower

    好處：精選天然珍珠精華、葉綠素逆時無痕修復因子、 100 %純蘆薈油等多種活性美膚成份，採用國際先進的的納米超微細粉末技術和生物酶解技術，完美遮蓋面部瑕疵及細紋，調整不均勻膚色，平滑肌膚，締造肌膚透明感的同時，抵抗污染，提亮膚色，令肌膚晶瑩剔透宛如出水芙蓉。
  8. Current situation of ultrasonic oscillation atomization process for producing spherical metal powder

    微細金屬粉末超聲波振動霧化技術的發展現狀
  9. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究，並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末，研究了溶劑量，溫度， ph值，煅燒溫度等對溶膠-凝膠過程的影響，以及摻雜稀土量對相結構的影響，從而確立了最佳的工藝參數。
  10. According to the significant improvement in properties of ions and particles doped perovskite, tb and cnt doped pt materials were prepared, and the properties studied. tb and cnt doped pt powders and films were successfully prepared by sol - gel method. by differential thermal analysis ( dta ), scanning electron microscopy ( sem ), transmission electron microscopy ( tem ), x - ray diffraction ( xrd ), fluorescent analysis and dielectric constant analysis, the morphology and phase transformation, crystalline properties, fluorescent properties and dielectric properties of the materials were studied

    本研究中採用溶膠凝膠法制備了具有優良結晶性能的稀土離子tb及納米碳管摻雜的鈦酸鉛（ pt ）超細粉末和（ 100 ）取向生長的薄膜，並利用差熱分析、掃描電子顯微鏡、透射電子顯微鏡、 x射線衍射、熒光分析和介電常數等多種分析測試手段對摻雜后的pt薄膜及超細粉末的相結構、光學性能、結晶性能以及介電常數等進行了研究。
  11. Based on the basic principles of densified systems containing homogeneously arranged ultra - fine particles ( dsp ) and reactive powder concrete ( rpc ) adopted by foreign researchers specialized in building materials, silica rume, ultra - fine fly ash, quartz powder, 52. 5 - class portland cement and superplasticizer were selected and mixed, the theoretic of mixed steel fiber reinforced cement - based composite materials and of micro - aggregate filling voids were applied, the composition was adjusted, the mixture ratio of rpc was optimized, a suitable curing schedule was adopted, in the result, an ultra - high performance concrete designated rpc was successfully prepared by normal technology methods

    本文基於超細粒聚密材料（ dsp ）和活性粉末混凝土（ rpc ）配製的基本原理，選用硅灰、粉煤灰、石英粉和硅酸鹽水泥，輔以高效減水劑，採用多重復合的技術路線，運用混雜鋼纖維增強理論和微集料填充密實原理，調整材料組成，優化混凝土配合比，結合適宜的養護制度，在現有技術條件下，成功制備出了rpc200材料。
  12. Between metal, alloy nanopowder as well as nanocrystalline intermetallic compound has extremely extensive application prospect in a lot of high - tech fields. the demand of nanosize particle will increase increasingly with technology to develop

    金屬、合金納米粉體材料以及金屬與金屬間化合物納米復合材料在許多高科技領域有著極其廣泛的應用前景，隨著工藝水平的發展，對微粒尺寸在納米級的超細粉末的需求將日益增加。
分享友人
分享到 Line

分享到臉書