超聲波放大 的英文怎麼說

中文拼音 [chāoshēngfàng]
超聲波放大 英文
ultrasonic amplification
  • : Ⅰ動詞1 (越過; 高出) exceed; surpass; overtake 2 (在某個范圍以外; 不受限制) transcend; go beyo...
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : releaseset freelet go
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. Design of microwave ultra - broad band low noise amplifier

    寬帶低噪器的設計
  2. With the purpose that people in countryside and rural area can listen to the sounds of communist party and chinese government, “ xi xin project ” has been carried out state general bureau of the radio and television and set up tens of 500kw sw radio transmitters, ten of them were installed, whom were th558 with find power amplifier, a kind of ultrahigh power mental - ceramic tetrode from french thomson company

    為使我國廣農村和邊遠山區群眾能聽到黨和政府的音,國家廣播電視總局組織實施了「西新工程」 ,部署了數十部500kw短廣播發射機,其中十部的末級功率管採用法國湯姆遜( thomson )公司生產的th558功率金屬陶瓷四極管。
  3. The ultrasonic motor is a kind of direct driver which is uses the converse piezoelectric effect of the piezoelectricity ceramics, by using transformation and the coupling of each kind of expansion and contraction vibration pattern enlarging the material microscopic distortion by resonate effect and transforming it to macroscopic movement of the rotor or the slide by the friction coupling

    馬達是一種利用壓電陶瓷的逆壓電效應,通過各種伸縮振動模式的轉換與耦合,將材料的微觀變形通過共振和摩擦耦合轉換成轉子或者滑塊宏觀運動的直接驅動器。
  4. According to the shortages of the traditional ultrasonic detectors in online inspection, such as low anti - interference capability and sensibility, through introducing the theory of ultrasonic detection system, a circuit module for signal collecting and amplifying of multi - functional ultrasonic detection system is designed

    摘要針對傳統探傷儀在進行在線檢測時存在抗干擾能力差、靈敏度低等缺點,通過對檢測系統原理的介紹,設計了一種用於多功能檢測系統檢測信號的採集及電路模塊。
  5. In the following chapters, a 16 - channel experimental phased array ultrasonic testing system is thoroughly explained, including digital beam forming, low noise programmable amplification of received ultrasound signal, multi - channel hi - speed hi - precision data acquisition, hi - speed real - time processing of multi - channel ultrasound signal, and hi - speed data transfer based on pci bus. in addition, the frame of software system is built

    本文詳細闡述了作者所獨立研製的16通道相控陣檢測實驗系統,包括數字化發射/接收束形成、信號的低噪程式控制、多通道高速高精度數據採集、多通道信號高速實時處理、基於pci總線的高速數據傳輸等全部電路模塊的結構及工作原理,並說明了所編寫的底層軟體系統的框架。
  6. This paper presents the characteristics of htsc ( high temperature superconductor ) materials, design and manufacture of a htsc filter and a low noise amplifier, which works at low temperature, and the basic theory of a cooling system

    本文介紹了高溫導材料的基本特性,導濾器及低溫低噪器的設計、製作與調試,並且詳細的介紹了製冷系統,最終設計研製出了「高性能接收機前端」 。
  7. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素( ql值)過1000的一系列低損耗、高q值表面rayleigh或stw諧振器,頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能表面諧振器。並採用噪系數為1 . 25db的低噪系數器,精心設計電路,優化設計布置印製電路板,用標稱頻率為1ghz的表面諧振器為頻率控制元件,製作出在偏離載頻1khz處的單邊帶相位噪近- 120dbc / hz 、雜抑制達80db以上的低相位噪表面振蕩器。
  8. This complex network is highly subject to producing ultrasonic oscillations which can overload the input circuitry of the device at the receiving end ( preamp, amp, etc. )

    這個復雜電路通常會產生震蕩,這能使接收端器材(前級,后級器等)的輸入電路過載。
  9. Meanwhile, with the development of wdm / dwdm communication systems, more and more attention is paid on the edfas with broader bandwidth, good gain and noise feature, and gain clamping, etc. according to the tianjin natural science foundation project : intelligent fiber amplifiers and light sources, the tianjin natural science foundation project : ( c + l ) broadband fiber amplifier and the nankai - delta ( tianjin ) project : development of gain flattened erbium - doped fiber amplifiers, this dissertation is mainly focused on the study of novel gain - clamped edfa, light sources, multi - wavelength fiber laser and variable optical attenuator for gain - clamped usage, gain and noise improvement of edfa, and broadband edfa

    Wdm / dwdm通信系統的發展又需要edfa具有更的帶寬、優良的增益和噪特性和增益控制等功能。基於上面的情況,並結合天津市重點基金項目? ?智能光纖器光源的研究、天津市重點基金項目? ? ( c + l )寬帶摻雜光纖器和南開-達爾泰(天津)項目? ?開發增益平坦的摻鉺光纖器等課題,論文主要圍繞新型增益控制edfa 、增益控制用光源、多長激光器及可調光衰減器、 edfa性能優化和寬帶edfa等方面進行了理論和實驗研究。
  10. During designing hardware circuit, we have used the supreme limitation to raise driving - ability and raise the distance of measurement to returning ware by taking some measurements just like multi - polar enlarging, according to the ultrasonic characteristic of index attenuation when it ' s spreading because we need to measure longer distance ( from several meters to dozens of meters )

    在硬體電路的設計中,由於需要測的距離較長(幾米到十幾米) ,針對振幅在傳播時呈指數衰減的特性,最限度地提高驅動能力,對回進行多級,達到了設計要求。
分享友人