超過壓力 的英文怎麼說

中文拼音 [chāoguòyālì]
超過壓力 英文
oerpressure of a safety ale
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 超過 : exceed; outnumber; outstrip pass forereach; outclass; override; overrun; overtake; surpass
  1. The paper can concern the soil ' s instantaneous fallout, soil ' s main settlement due to concretion, and the coactions of soil and pile by applying the contact surface to simulate the coactions. the paper can analyze the service behavior of reuniting foundation and the effect of the pile ' s intensity, length and distance. the paper is concerned with the stressing of pile and the arrangement of pile for the smaller cost to fit the subsidence of throughway

    通過有限元計算，分析了復合地基樁土工作性狀，分析了樁的剛度，長度，樁距對地基沉降及超孔隙水壓力的影響，並根據復合地基中樁的受力特點，提出合理的樁的布置方式，在滿足高速公路路面沉降要求的前提下，節省工程投資，加快建設進度。
  2. The gas pressure eventually overcomes the force of solar gravity and the corona inevitably expands into space as the solar wind.

    這里的氣體壓強最終會超過太陽的引力作用，使日冕終于只好以太陽風的形式向空間膨脹。
  3. Ultrafiltration is the movement of the liquid passing through the half film when the liquid is affected by the pressure grads, which can be described precisely as the molecule moves from the blood to the dialytic solution

    液體在壓力梯度作用下通過半透膜的運動，稱為超濾，具體是指水份從血液側向透析液側移動。
  4. The ultrahigh - voltage direct current ( uhvdc ) link comprises two substations and a power transmission system using breakthrough technology to transmit electricity at ultrahigh voltage ( 800 kilovolts ), which will minimize the amount of power lost in transmission

    該超高壓直流輸電（ uhvdc ）線包括兩個變電站以及一個採用了突破性超高壓（ 800千伏）電力傳輸技術的電力傳輸系統，這將減少傳輸過程中的電力損失。
  5. Base on discuss, choosing mongolian scotch pine and manchurian ash as experiment species, using three kinds of wood fire - retardant treatment methods which included soaking at some pressure, pressurized soaking under ultrasonic wave and the pressurized soaking under ultrasonic wave after treated by microwave, the result is that ultrasonic wave may apply in wood fire - retardant treatment production

    在討論的基礎上，以樟子松和水曲柳為木材試樣，選擇壓力浸漬、超聲波加壓浸漬和微波處理后超聲波加壓浸漬3種木材阻燃處理方法，經過試驗，說明在生產阻燃木材的浸漬方法中引入超聲波技術是可行的。
  6. The numerical results show that the elephant foot bulging is in fact buckling failure which is caused by the overcritical compressive stress rather than intensity failure

    分析表明：立式儲液罐罐壁「象足」變形主要是由罐壁縱向壓應力超過臨界應力而產生的局部屈曲破壞，並非強度破壞。
  7. The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter

    本課題主要是對不同加工工藝及不同表面處理過程的曲軸，對其內應力進行跟蹤檢測，分析各工藝過程中跳動量、變形量、恢復量與應力改變的關系，找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常溫壓力校直」 、 「熱壓力校直」 、 「支撐時效校直」等方法的校直，檢測校直過程中曲軸應力的變化及校直后組織和性能的改變，進而對各校直工藝進行綜合評價，給出安全可行的工藝參數。
  8. The dynamic tensile stresses of earthquake may balance or exceed to the precompression stresses due to static watef, this may arouse opening of joints along the normal direction. if the altemate actions of earthquake join, the joints may behave gradual opening and closing

    由於地震作用時的動拉應力將抵消並超過靜載作用下的壓應力，導致橫縫面沿法向張開，加上地震的交變作用，橫縫可能會呈現反復的「漸開漸合」現象。
  9. Spherulites dimension also decreases due to the chemical changes occurred during pan - milling. viscosity test shows that chain scission occurred during pan - milling, which caused slight reduction of mechanical properties. polypropylene / polyamide 6 ( pp / pa6 ) ultra - fine powder was prepared through pan - milling at ambient temperature

    通過磨盤碾磨在常溫下制備了聚丙烯/尼龍6 （ pp / pa6 ）超細復合粉體，其粒徑可通過碾磨時間、磨盤轉速、磨面靜壓力、碾磨溫度等工藝參數控s摘要一制。
  10. Surface tension makes the pressure inside a bubble exceed the pressure of its surroundings.

    表面張力使氣泡內的壓力超過其環境的壓力。
  11. The inhalation at 1 atmosphere of 80 % oxygen for more than 12 hours can cause irritation of the respiratory tract, progressive decrease in vital capacity, coughing, nasal stuffiness, sore throat, and chest pain, followed by tracheobronchitis and later bypulmonary congestion and / or edema

    在含氧80 % 、壓力為1個大氣壓的空氣中呼吸超過12小時會導致刺激呼吸道，漸進性肺活量減少，咳嗽，鼻阻塞、疼痛/水腫。
  12. In the second place, based on the asu of buggenum igcc plant in netherlands, both static and dynamical model for distillation tower of the asu are created and some valuable conclusions are gained as well. finally, a compartmental simplified model is created for distillation tower of the asu, in order to reduce the simulation time and increase the simulation efficiency. the new model will be helpful to the further simulation and on - line optimal control for the asu of the igcc plant

    其次，本文以荷蘭buggenum電站的空分系統為原型，基於matlab建立了空分系統精餾塔的半圖形化動、靜態數學模型，並通過模擬，得出了一些有價值的結論：當空分系統的壓力變化時，氧氣產品濃度的響應時間常數為兩小時左右，說明空分系統是igcc電站最大延遲環節；而且雖然氧氣濃度最後會穩定在igcc電站所要求的范圍之內，但在過渡過程中會超出限制，這些都為igcc電站的安全運行及控制系統設計提供了有價值的信息。
  13. But there are over 1m people receiving incapacity benefits because depression and stress have left them unfit to work

    但有超過100萬人因為抑鬱癥和壓力而使他們不能工作領取喪失工作能力福利津貼。
  14. Abstract : reviewed are five methods for the analysis of the penetration of jacked - in piles, namely, cavity expansion method, strain path method finite element method, slip line method and calibration model test. after analysis, it is pointed out that it is more rational to adopt sub - statical spatial axisy numerical formulas based on traditional plane - strain cavity expansion method in the analysis. after spatial closed - form solutions are obtained for soil movements, stresses and initial excessive pore pressures generated durihy pile penetration are found out. it is suggested that finite element analysis together with centrifugal model test be used in verifying the results

    文摘:在分析飽和粘土中靜壓樁的貫入機理的基礎上，對靜壓樁沉樁分析的圓孔擴張理論、應變路徑法、有限元分析、滑移線理論和模型槽試驗等五種方法逐一進行評述，並提出在傳統的平面圓孔擴張理論基礎上加以改進，採用準靜態空間軸對稱方程組對靜壓樁貫入過程進行模擬，從而得出土體位移、應力、初始超孔壓的空間解析解，同時採用有限元分析、模型槽試驗相互印證的研究方法
  15. The indirect answer to this question is simple ; the peak cylinder pressure is not allowed to exceed the mechanical limitation of the engine parts or the knock limit of the fuel, which ever comes first

    婉轉的針對這個問題回答，汽缸壓力的峰值不能超過引擎機械零件本身的限制或汽油爆震的極限，以上兩個狀況何者先出現，就是極限的發生時機
  16. When alveolar pressure exceeds 80 - 100mmhg, air can be forced into pulmonary capillaries

    當肺泡的壓力超過80至100水銀汞柱時，空氣便會被強迫的進入肺部血管內。
  17. If you often feel angry and overwhelmed, like the stress in your life is spinning out of control, then you may be hurting your heart

    如果你動不動就生氣、茫然失措，就像你生活中的壓力正在快速加劇並超過了你的承受范圍，那麼你可能是在愛損害你的心臟了。
  18. Through analyzing the in - situ data such as total settlement, layered settlement and pore water pressure, the actual deformation behavior of soft foundation are mastered. after summarizing the methods of predicting settlement of soft foundation and bring forward a method to predict the post construction settlement of the surcharge preloading soft foundation. and the engineering application of the predicting foundation settlement based on “ law of massaction ” and the traditional predicting methods are compared, the results shows that the model is useable and it deserves more validation in more projects

    本文以深圳灣軟基處理工程試驗區為背景，通過對淺層沉降、分層沉降、孔隙水壓力等資料的分析，掌握了軟基變形的實際性狀;在總結軟基路堤沉降預測方法的基礎上，探討了軟基超載預壓工后沉降預測的參數反演法;並對地基沉降預測的「質量作用定律」模型的工程應用與傳統的預測方法進行了對比，驗證這種方法是可行的，得出了一些有用的結論。
  19. Abstract : through analyzing & quot; two basic facts ， one striking contradiction & quot; existing in present thermal power mix in china ， it is thought that to develop such commercialized and matured electricity generation technology as supercritical pressure units is an effective way to improve thermal power mix ； indicated that to develop supercritical pressure units is confronted with design ， manufacturing and operation etc. technical difficult points ， and deemed that we should make every effort to realize pressure units in china on the basis of mastering new knowledge and new technology

    文摘:通過分析目前我國火電結構存在的「兩個基本事實，一個突出矛盾」 ，認為發展超臨壓力機組這種已商業化的、成熟的發電技術是改善火電結構的有效途徑；指出發展超臨界壓力機組面臨著設計、製造和運行等幾項技術難點，認為應在掌握新知識和新技術的基礎上，努力實現我國發展超臨界壓力機組的技術跨越。
  20. Under working conditions the pressure difference should not exceed the full - scale value of the gauge

    在工作時，壓差不應該超過壓力表的量程值。
分享友人
分享到 Line

分享到臉書