超高阻表 的英文怎麼說

中文拼音 [chāogāozǔbiǎo]
超高阻表 英文
high megohm meter
  • 超 : Ⅰ動詞1 （越過; 高出） exceed; surpass; overtake 2 （在某個范圍以外; 不受限制） transcend; go beyo...
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
  • 超高 : 1 （鐵路彎線的外軌加高） superelevation2 （船的出水高度） freeboard; freeboard height3 super high...
  1. Since the discovery of colossal magnetoresistance effect ( cmr ) in per - ovskite manganites, it has sparked considerable renewed interests in these long - known materials with an eye towards both an understanding of the cmr and related properties and potential applications in magnetic information store and low - field magnetic sensors

    以鈣鈦礦結構氧化物為代表的巨磁電阻材料，由於它們所表現出來的超大磁電阻效應（ colossalmagnetoresistance ）在提高磁存儲密度及磁敏感探測元件上具有十分廣闊的應用前景，因而受到人們的廣泛關注。
  2. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  3. The cmr materials have complex physical properties. some phenomena of the lacamno3 films are discussed, such as the effects of mismatch between the substrates and the films, the variation of the resistance of films under different bias currents. and the effects and improvements are discussed with details after the films are annealed in high temperature and high oxygen pressure

    超巨磁電阻材料有著復雜的物理性質，我們對lacamno _ 3薄膜材料所表現出來的一些現象進行了討論，如應力變化對薄膜性質的影響、不同偏置電流與薄膜電阻變化的關系等，還特別討論了薄膜在高溫、高氧壓環境中退火所帶來的影響以及薄膜性質的改善。
  4. We apply the system to the ultra - fine grain steel welding, the simulated mean grain size in cghaz agreed well with the corresponding independent experimental data. in this paper, three factors influencing the grain growth, the steep temperature gradient in haz. the grain boundary liquid and the precipitates particle, were studied specially using mc technique

    研究表明溫度梯度造成的「熱釘扎」現象和晶界液化現象都對靠近熔合線附近的晶粒長大有明顯的阻礙作用，對最終的晶粒大小分佈有重要的影響：而800mpa超細晶粒鑰中的tin粒子山于溶解溫度高，抑制奧氏體晶粒長大的效果十分顯著。
  5. Hardware circuit is designed. at the same time software is developed and optimized. it is testified that this move - control - system achieves the requirement for high resolution ( resistance trimming error is + 0. 1 % ) and high speed ( 55 resistances per second ) of laser - resistance - trimmer

    結果表明，該運動控制系統很好地實現了對激光調阻機高精度（調阻誤差為0 . 1 ）和超高速度（調阻速率為55隻/秒）的要求。
  6. A measurement method of microwave surface resistance of large area high tc super - conductive thin films

    高溫超導薄膜微波表面電阻測試方法
  7. Bounded convergence of forgetting factor least square algorithm for time - varying systems

    本系統是按照目前國際上高溫超導薄膜的微波表面電阻的測量標準方案
  8. Though both of the methods have it ’ s own advantage and disadvantage, the rs can be measured with high sensitivity

    這兩種方法雖然各有優缺點，但都能夠測量高溫超導薄膜的微波表面電阻，而且測試靈敏度較高。
  9. As the manufacture technology of high temperature superconductor ( hts ) film is improved continually, it is applied more and more widely. then it is becoming urgent to measure the microwave surface resistance of hts film that is one of the most important parameters of hts film

    高溫超導薄膜制備技術的不斷提高使得薄膜的應用日益廣泛，因而對薄膜各種性能指標的測定也顯得更加重要，這就迫切需要對超導薄膜最主要特性之一微波表面電阻進行精確的測試。
  10. As the manufacture technology of high temperature superconductor ( htsc ) film is greatly improved, it is applied more and more widely. then it is becoming urgent to precisely measure the surface resistance of htsc film that is one of the most important parameters of htsc film

    高溫超導薄膜制備技術的不斷提高使得薄膜的應用日益廣泛，因而對薄膜各種性能指標的測定也顯得更加重要，這就迫切需要對超導薄膜最主要的微波特性參數微波表面電阻進行精確的測試。
  11. With the developing highway communications, the traffic is increasing and axle is becoming heavier and heavier, all of these demand the high quality of cement concrete pavement the experience of past ten years in highway construction shows that the practical life time of cement concrete pavement is far more shorter than anticipated. damages such as cracking are offen occurred in first serval years they caused direct and indirect economic losses and bad social influences. in addition to control overloaded vehicles by means of administration, the compressive strength, bending strength wear - ability should be improved to solve all these problems

    十幾年的高等級公路建設實踐表明，水泥路面的使用壽命遠遠小於其設計壽命，往往在通車幾年後就出現一些病害，如坑槽、斷板等病害，帶來的直接、間接經濟損失和不良的社會影響。解決這些問題，除了運用行政強制手段控制超載車輛外，必須提高水泥混凝土的彎拉強度、疲勞強度、耐磨強度、阻裂限縮能力，從而提高水泥混凝土路面的使用壽命。
  12. Two kinds of microwave surface resistance rs measurements of high tc superconductive thin films are introduced in this paper, two - resonator method and the sapphire resonator method

    本文介紹了兩種測試高溫超導薄膜微波表面電阻的方法:雙諧振器法和藍寶石介質諧振器法。
  13. He said that the two systems, which will come into operations in parallel to the current wet film camera systems, would greatly increase the deterrent effect against these activities, thus improving the road safety in the terrority

    他表示，這兩款系統連同現時的一般菲林攝影機系統一同運作時，將可大大加強對超速及沖紅燈違例事項的阻嚇效果，從而提高本港的道路安全水平。
  14. The sapphire resonator method studied in this paper is used to apply for the national measurement standard of rs for high tc superconductive thin films, in which the rs value of hts film can be determined by measuring the change of the unloaded quality factors of the loaded resonator

    在國內，本論文研製的藍寶石介質諧振器法正在申請高溫超導微波表面電阻rs國家測試標準。此法通過測量加載超導薄膜后介質諧振腔的固有品質因數的變化來確定超導薄膜的微波表面電阻。
  15. Sapphire resonator working in te011 + mode is used in this paper to nondestructively measure the microwave surface resistance rs of a single piece of hts thin film at 77k. the microwave surface of htsc film under test can be determined by measuring the change of the unloaded quality factors of the loaded resonator

    本文就對超導薄膜的微波表面電阻的測試進行了系統的研究。本文介紹了一種利用te011 +模式的藍寶石介質諧振器測量高溫超導薄膜微波表面電阻的方法，通過測量加載超導薄膜前後介質諧振腔的固有品質因數的變化來確定超導薄膜的微波表面電阻。
  16. Two - resonator method is using to build the draft of international measurement standard of rs for high tc superconductive thin films, in which the rs value of the hts films can be determined by unloaded q ’ s measured from two resonators by using simple formulas

    目前，國際上用雙諧振器法建立高溫超導薄膜微波表面電阻rs國際測試標準草案。此法是基於模式匹配方法，通過嚴格的推理得到簡單的方程，從諧振器的諧振頻率和固有品質因數可以求出超導薄膜的rs 。
分享友人
分享到 Line

分享到臉書