軸向拉力 的英文怎麼說

中文拼音 [zhóuxiànglālì]
軸向拉力 英文
axial te ion
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 拉 : 拉構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 拉力 : pulling; pulling force; thrust; traction; tension拉力表 draw bar [pull] dynamometer; 拉力測定儀 [...
  1. The plating in ships is generally subjected to combined in - plane and lateral pressure loads. in - plane loads include biaxial compression / tension and in - plane bending and edge shear, which are mainly induced by overall hull girder bending and / or torsion of the vessel. lateral pressure loads are due to water pressure and cargo

    面內載荷分為軸向壓應力或拉應力、邊緣剪切應力以及面內軸向彎曲應力。實際的船舶結構中面內載荷通常由船體梁的總縱彎曲或者船體梁的扭轉引起。側向壓應力則由水壓力和貨物壓力引起。
  2. A volume speed controlling system is selected on the fluid drive system of sugarcane mill, which consists of cam type axial piston variable pump and ram marathon fixed motor. an individual hydraulic system is adopted by the up - axis of the mill

    甘蔗壓榨機液壓驅動系統採用斜盤式軸向柱塞變量泵與橫梁傳力內曲線馬拉松式定量液壓馬達組成容積調速閉式系統。
  3. The condition of uniaxial stress is closely approximated in prismatic bars subjected to pure axial tensile.

    單軸的應力狀態跟稜柱桿承受單純軸向拉伸十分近似。
  4. It is determined that with accurate knowledge of the complete stress - strain curve of concrete in compression, steel in tension, and with an iterative computerized non ? linear method, it is possible to predict the entire moment - curvature, moment - flexural rigidity and axial rigidity relation ship of a cross - section of a structure member

    可以確定，只要知道混凝土受壓和鋼筋受拉的完整的應力應變關系，採用選代的非線性計算方法，就有可能預測結構截面彎矩一曲率、彎矩一彎曲剛度和軸向剛度的關系。
  5. Non - linear finite element analysis of rubber layer bonded between two rigid spheres has been performed for rubber ’ s characteristic of large deflection and nearly incompressibility. the relationships between stiffness and deformation have been gained when large tensile deformations are imposed. the effects of different poisson ’ s ratios of rubber matericals on the stiffness and stresses of rubber layer have

    針對橡膠的大變形及接近不可壓縮的特點，對工程中常用的橡膠-剛球支座進行非線性有限元分析，了解了支座的剛度和應力的變化情況以及泊松比對兩者的影響，得出的支座受軸向拉伸時的剛度與軸向變形關系。
  6. Axial tensile stress

    軸向拉伸應力
  7. Agricultural tractors and machinery - power take - off drive shafts and position of power - input connection

    農業拖拉機和機械動力輸出萬向節傳動軸和動力輸入連接裝置的位置
  8. The results of computation show that the axial force on the impeller of pump pushes the pump impeller towards turbine, that axial force on the turbine makes the turbine close to the pump impeller, and axial force on guide roller propelles guide roller towards the pump impeller

    實例計算發現，泵輪的軸向力拉動泵輪向渦輪靠近；渦輪的軸向力拉動渦輪向泵輪靠近；導輪的軸向力拉動導輪向泵輪靠近。
  9. Secondly, the math model of the high - speed pm generator with a shielding is deduced. the method of how to analyze the electromagnetic field of the generator is introduced. and with the help of a kind of fem software, the parameters of a model machine are calculated and simulated, including the electromagnetic field, no - load voltage, single - side magnetic force, loaded torque and axial force

    其次，對轉子帶防護罩的高速永磁發電機數學模型進行了推導，介紹了利用有限元法對電機磁場進行分析的方法，並運用有限元軟體對一臺樣機的參數進行了模擬，包括電機磁場分析、空載電壓波形、單邊磁拉力、負載轉矩以及軸向力等方面的內容。
  10. In this thesis summarize how to avoid and deal with the negative friction in designing and using. researches indicate : ( 1 ) the negative friction in pile will lead to large number of down load in some designs. this friction must be considered in design to avoid the sedimentation and destroy in the building

    研究結果表明： （ 1 ）在工程設計中，有些情況由於負摩擦力產生的下拉荷載數值相當大，在設計中應充分給予重視，以避免在使用中由於下拉荷載使樁的軸向荷載增加引起樁的沉降或不均勻沉降，而導致建築物的破壞。
  11. In other words, the process of analyzing relaxation zone related to one safety factor can also be regarded as the process of searching potential slide surface related to the same safety factor. elastic wedge model is used for analysis of relaxation zone of cutting homogeneous slope. on the basis of elastic plane - strain theory, the relaxation zone can be calculated according to mohr - coulomb or drucker - prager law and single tension intensity principle which are both related to one safety factor after three - dimensional stress field of the cutting slope is got

    提出均質邊坡開挖鬆弛區可以用彈性理論中的楔形體理論分析，在平面應變問題的基礎上得到開挖坡體的三向應力場之後，可運用考慮安全儲備后的強度條件（主要為摩爾?庫侖或德魯克?布拉格強度準則和單軸抗拉強度準則）解析坡體分步開挖過程中的鬆弛區范圍，給出了具體的計算步驟，並通過算例較詳細地說明了操作過程。
  12. A switchable and spacing - tunable dual - wavelength linear cavity edfl is demonstrated experimentally using this kind of bragg grating for wavelength selection. it exploits the birefringence characteristic of the fbg induced by transverse strain. transverse strain loading on the fbg allows the wavelength spacing to be controlled while axial strain shifts both wavelengths together

    2 .對軸向及側向應力共同作用下的光纖布拉格光柵的透射及反射光譜特性進行了理論及實驗研究，並首次把軸向及側向應力共同作用下的光纖光柵應用於光纖激光器進行波長選擇，得到了室溫下穩定工作的波長及波長間隔可調的可開關雙波長的摻鉺光纖激光器。
  13. The main causes, which have effects on redistribution of internal force in the prestressed frame, including the relative height compressive zone of section, secondary moment and types of load applying are taken into account. the horizontal braces force which results from the tension of the prestressing steel, reduces the pre - compress stress is analyzed

    並且探討了各影響因素對框架梁截面延性的影響和由於柱的抗側剛度在預應力鋼筋張拉時約束梁的軸向變形，從而影響預應力在梁中的建立所造成的梁中軸向預壓力的損失。
  14. Metallic materials - verification of static uniaxial testing machines - tension creep testing machines - verification of the applied load

    金屬材料.靜態單軸向試驗機的校正.拉伸蠕變試驗機.對作用負載力的校驗
  15. Axial tensile force

    軸向拉伸力
  16. This can be of significant benefit to cut down the cost and time limit for a project the program package gone with this paper may realizes the dynamic simulation for all of courses in hoisting, and may synchronously displays the axis force of derrick, the pull - force of the steel wire, obliquity of equipment and overloading instance

    這有利於工程實踐中方案變更、施工現場條件復雜多變等的方案驗算，節約成本和縮短工期。本論文程序為桅桿吊裝整個過程實現了動態模擬，顯示桅桿軸向壓力、鋼絲繩拉力、設備傾角和起重超載提示，為安全吊裝設備提供重要的數據，有利於作業過程的全程監控。
  17. As far as he hollow inclined column - wall transfer r. c joint is concerned, the stress state of transfer beam is very critical, because it bears not only the vertical load transferred from the wall, but also the axial load initiated by the inclined column

    對有孔斜柱轉換節點而言，轉換梁的受力最為不利，它不僅承擔由薄壁柱傳來的垂直荷載，而且還承擔由斜柱水平分力引起的軸向拉力，即截面上有彎矩、剪力和軸力的共同作用。
  18. Lastly, the author investigated the impact of the axial pressure gradient on three - dimensional chaotic mixing in eham by computing the mixing efficiency of a tracer

    最後，通過計算三維eham混沌混合中代表性流體質點的拉伸效率行為，確定軸向壓力梯度的影響。
  19. The dead - end is designed to terminate optical ground wire opgw while minimizing any compression stresses that may be transferred to the core or optical elements within

    此線夾不但能保護光纖不受損傷，傳遞軸向拉力，還能增加光纜抗振能力，延長使用壽命。
  20. 2. for frame supported double - short - pier shear wall under vertical loads, the non - noding area of transfer beams turns into a member of flexure and tension with small axial force, and bending stress dominates in the stress distribution on the cross - section. in the nodding area, the axial force increases while the bending effect is small

    2 、框支雙肢短肢剪力墻在豎向荷載作用下，轉換梁的非節點區為一拉彎構件，軸向拉力較小，截面的應力分佈以彎曲應力為主;在節點區，軸向拉力效應增大，而彎曲效應很小。
分享友人
分享到 Line

分享到臉書