軸棱鏡 的英文怎麼說

中文拼音 [zhóuléngjìng]
軸棱鏡 英文
axicon
  • : 軸Ⅰ名詞1. (圓柱形的零件) axle; shaft 2. (對稱部分的直線) axis 3. (圓柱形的纏繞器物) roller; spool Ⅱ量詞(用於纏在軸上的線以及裝裱帶軸子的字畫)
  • : 棱名1. (物體上不同方向的兩個平面接連的部分) arris; edge; corner 2. (物體上一條一條的凸起部分) corrugation;ridge;raised angle
  • : Ⅰ名詞1 (鏡子) looking glass; mirror 2 (幫助視力或做光學實驗的器具) lens; glass 3 (姓氏) a s...
  1. By using a reflector and two pentaprisms, one beam of light is separated into two parallel beams, then respectively they are received by two optical systems of the large scale photoelectric theodolite with certain imaging d - value which correspondingly represents each optic axis parallel error of these two optical systems

    方法是利用一塊反射和兩塊五將一束準直光束分光成兩束平行光束,大型經緯儀的兩個光學系統分別接收這兩束平行光,兩束平行光所成像的脫靶量差值即為兩光學系統的光平行度。
  2. The outcome suggest that, firstly, the change of light transmission with the continuous change of parameters is periodic ; secondly, as far as the degree of effect is concerned, the light transmission of air - spaced prisms is much more sensitive to the change of the parameters than that of the glue spaced ones ; thirdly, as to the prisms glued with the same dielectric, the effect of prisms whose optical axis parallels to the glued layer is intense than those whose optical axis parallels to the plane determines by the normal of incident face and that of the cut face

    研究認為,激光偏光的光強透射比隨各參量的連續變化都呈現出一定的周期性;各參量對空氣隙型偏光的影響要比對膠合型的影響大的多;同種介質膠合的,各參量對光平行於切割斜面的設計類型比光平行於切割面的法線和入射端面的法線所組成的平面的設計類型的影響要大。
  3. If they are observed under polarized light with a red compensator, they appear yellow ( negatively birefringent ) in the main ( " slow " ) axis of the compensator and blue in the opposite perpendicular direction

    如果用紅光補償在偏振光下觀察,在補償的主( 「慢」 )方向呈黃色(反雙折射)而在相反的垂直方向呈藍色。
  4. Reflecting prisms - optical axis, length of optical axis, axial section and optical parallelism

    反射長度光截面與光學平行度
分享友人