載頻偏置 的英文怎麼說

中文拼音 [zǎibīnpiānzhì]
載頻偏置 英文
carrier offset
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  1. E., the carrier frequency of a gaussian beam deviates from the resonant frequency of a fabry - perot etalon ), variations of the peak intensity, the position of the peak intensity and the dwdm systems, has received considerable attention. in this work, after taking into account the wavelength - depended reflectivity distribution profile of a fiber bragg grating, the oscillation wavelength # _ ( 1 ) of long external cavity fiber bragg grat

    與共振情況（即高斯光束的載波頻率與法布里一拍羅濾波器的諧振頻率一致）相比，非共振條件（即高斯光束的載波頻率與法布里一拍羅濾波器的諧振頻率存在偏差）一透射光束的峰值強度、峰值強度所對應的位置、以及光斑的大小隨入射角的變化都發生了顯著的改變。
  2. Carrier frequency offset

    載波頻率偏置
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
分享友人
分享到 Line

分享到臉書