載頻放大 的英文怎麼說

中文拼音 [zǎibīnfàngdà]
載頻放大 英文
carrier amplification
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 放 : releaseset freelet go
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. The power of the modulated carrier wave is increased by the rf power amplifier

    射頻功率放大器增加了調變載波的功率。
  2. In wavelength conversion based on four - wave mixing ( fwm ) in soa, balance efficiency can be obtained in larger range when increasing saturation power of the optical amplifier and decreasing the saturation power of spectral hole burning and carrier heating

    而在基於soa的四波混頻（ fwm ）波長轉換中，在提高光放大器飽和功率的同時減小光譜燒孔（ shb ）和載流子加熱（ ch ）飽和功率可有效提高較大頻率間隔處的轉換效率，並保持其在較大頻率失諧范圍內的效率均衡。
  3. The class - d voltage switching amplifier technology is adopted to develop the rf amplifier

    載頻放大器採用高效率的class - d開關放大技術。
  4. According to the eer theory, using the amplified envelope signal as the power supply of the class - d amplifier, the envelope will modulate the magnitude of the rf signal. the modulated impulse rf signal is added to the impedance match circuit, so the amplified am signal is achieved

    將放大的包絡信號作為class - d載頻放大器的電源，根據eer原理， class - d載頻放大器輸出載頻信號的幅度將受到包絡信號的線性調制，達到同時實現對載頻信號的放大和am調制的目的。
  5. In the thesis, a high efficiency linear am amplifier is developed, which is based on the basic theory of eer linearization amplifier technique [ 1 ]. the high efficiency digital audio amplifier technology [ 2 ] is adopted to develop the power supply modulator and the class - d switching amplifier technology [ 3 ] is adopted to develop the high efficiency rf amplifier

    本論文利用eer （ envelopeeliminationandrestoration ）線性功放技術的基本原理[ 1 ] ，採用數字音頻功放技術[ 2 ]實現高效率電源調制器，採用class - d開關放大技術[ 3 ]實現高效率載頻放大器，開發了一個集am調制和放大於一體的高效率線性功率放大器。
  6. Investigation on rf power amplifier imd detection and carrier cancellation

    射頻放大器互調失真檢測和載波抵消的研究
  7. Based on the analysis of commercial banks " current concept about fund management, this paper brings forward that fund management is the main - string in its operation, and that the concept of fund management, including security and profitability, is extended from current " forrying fund " to the management of the fund cost and fund risk the paper comprehensively discusses the principle of fund management, the management of fund costs, the tactics of management about fund liquidity, the measures of management about fund risks and how to solve the problems on interest risk in the period of frequent interest fluctuation. the paper puts forward ideas on how to improve the fund management. the security, liquidity and profitability of the fund, which are both contradictory and integrated with one another, are internal factors of fund management. fund liquidity is traditional core question. commercial banks face with a number of risks of witch credit risk is the greatest one because our country has adjusted interest rates 8 times since 1996, which covered a period of frequent interest fluctuation

    商業銀行面對許多風險，但最大風險是信用風險。由於我國自1996年以來已連續調整了8次利率，近幾年是利率波動頻繁時期，研究利率的敏感性問題顯得特別重要。要改善資金管理，提高商業銀行的經營水平，就要建立資金管理是商業銀行經營主線的理念，對資金要統一規劃和管理；要改革銀行的體制，建立現代企業制度和法人治理結構，在體制上為資金管理提供有利的運行平臺；增加改善資金流動性管理所需的貨幣政策工具，擴大資金調控手段；打破貨幣市場的僵化局面，為資金管理創造有利的宏觀環境；續續優化負債結構和負債載體設計；增強資金信用風險規避和化解的措施；通過銀行資源整合，努力尋找資金的安全投放渠道，最終完成經營模式由傳統型向現代型的轉變。
  8. In technique rebuilding of system, discharge curve of ni - mh battery was measured, and power supplies in uav were improved. the security, adaptability and efficiency of miniature aerial rs systems could be improved obviously by microwave video transmission system and self - regulating blocking net in landing

    在對系統的技術改造中，測定了ni - mh電池組放電曲線，對無人機機載電源做了改進，配合加裝的微波視頻傳輸系統和自行研製的降落阻尼攔阻網可以大大提高無人機航空遙感系統的安全性、適應性和作業能力。
  9. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  10. Multi - carrier power amplifier linearization based on adaptive rf predistortion

    基於自適應射頻預失真的多載波功率放大器線性化技術
  11. Based on equivalent four - terminal networks of the longitudinal ultrasonic transformer, the resonant frequency equation and the amplitude magnification coefficient, with reactive load, are studied

    摘要在負載為純力抗的狀況下，利用縱振型變幅桿等效四端網路，對頻率方程和放大系數進行了研究。
  12. The formulas of three kinds of loaded ultrasonic transformers are presented ; then, the graphs of resonance frequency and the amplitude magnification coefficient, following the change of load, are charted by the programs of matlab

    得到了三類常用變幅桿頻率方程和放大系數的表達式；並通過matlab編程，分別繪制了三類變幅桿共振頻率及放大系數隨負載變化的曲線圖。
  13. At present the manufacture of surface acoustic wave use the technology of the final submicron. a series of the devices of low insertion loss, high q saw rayleigh surface acoustic wave resonators or stws that insertion loss has less than 5db, load quality factor ( ql ) is more than 1000 on the quartz piezoelectric with zero of first temperature factor in the research. these difference frequencies are 60mhz, 280mhz, 739mhz and 1ghz of normal frequency and at also surface acoustic wave. using 1. 25db noise factor amplifier, careful design curcuit, good setting printed curcuit board, and using the 1ghz surface transverse wave resonator as frequency element, researching the low phase noise surface acoustic wave with sideband phase noise near ? 120dbc / hz deviating 1khz on carrier, spurious suppress with 80db

    本研究採用一階溫度系數為零的壓電石英基片上製作出損耗小於5db 、有載品值因素（ ql值）超過1000的一系列低損耗、高q值聲表面波rayleigh波或stw諧振器，頻率分別為60mhz 、 280mhz 、 739mhz和1ghz等不同頻率的高性能聲表面波諧振器。並採用噪聲系數為1 . 25db的低噪聲系數放大器，精心設計電路，優化設計布置印製電路板，用標稱頻率為1ghz的聲表面波諧振器為頻率控制元件，製作出在偏離載頻1khz處的單邊帶相位噪聲近- 120dbc / hz 、雜波抑制達80db以上的低相位噪聲聲表面波振蕩器。
  14. Secondly, we used the dsp assembly language to perform the carrier phase tracking based on a digital processing system. this system is designed according to the idea of software radio. this digital processing system realized the intermediate frequency digitalization. with the diverse configuration of the digital upconverter and digital downconverter in this system, it can carry through many signal modulation modes. and because the carrier phase trac king is performed using software in dsp, it brings great convenience to this system and makes this system available in many digital communication systems

    在該數字處理平臺上可通過加載不同的軟體對平臺中的數字上下變頻器進行靈活的配置以實現不同的數字調制解調制度，通過將載波的相位跟蹤工作放在dsp軟體中進行帶來了很大的靈活性，能夠適用於當前許多種數字通信系統。
  15. Since the energy of 18 - information track signal is concentrated around upper frequency and lower frequency, the frequency of the modulation signal is low, and it must have high resolution, we use zfft to detect it. as the energy of um - 71 signal is more concentrated, we use extreme value method to detect the frequency of modulation signal in frequency domain, which can satisfy the frequency resolution

    針對18信息軌道信號能量集中在上、下邊頻附近且低頻信息頻率低的情況，提出了用zoom - fft （ zoom指頻率擴展或細化，簡稱zfft ）演算法進行信號的局部放大檢測低頻信息，以提高信號的頻率解析度，而um - 71軌道信號能量集中在載頻附近，在頻域上採用極值法檢測低頻信息，即可滿足信號頻率解析度的要求。
分享友人
分享到 Line

分享到臉書