輸入信號反相 的英文怎麼說

中文拼音 [shūrùxìnháofǎnxiāng]
輸入信號反相 英文
input inversion
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 輸入 : 1 （從外部送到內部） import 2 [電學] input; entry; entering; in fan; fan in; 輸入變壓器 input tra...
  1. The major job is manufactured a transmitter, which has three upmixer channels. its function is to up convert the signals from c - band to ka - band. the input local oscillator is provided by a low frequency crystal oscillator which has a good performance of phase noise, through 512 times multiply to ka band. this sysetem is used in the laboratory as transmitter source of the fuze, for the multidimensional objects in practise, which lead to the complexity of the reflect signal, so the amplitude, frequency and the phase of the transmit signals both have a key role in dealing with the reflection signals. therefore, this system requires for both the coherence of the single channel ’ s amplitude, phase and multi channels

    本文的主要工作是應用戶要求製作一具有三發射通道的上變頻系統，可以將c波段的微波信號上變頻到ka波段的毫米波信號。系統的本振輸入基頻由一相位噪聲非常好的低頻率晶振提供，經過512次的倍頻放大至ka波段。本系統作為實驗室中引信的發射源，由於目標反射信號具有時變的多維性，反射信號變得極為復雜，在信號處理時，不僅信號幅值、頻率有決定意義而且相位關系也很有決定意義。
  2. With the noise being added to a proper value, the system will show shochastic resonance and enhance the output signal. the sr technology is better than the traditionary signal detecting method. the best virtue of it is using the noise to enhance the capability of detecting the weak signal. and it will not harm the signal at the same time

    隨機共振系統是一個非線性系統，在一個小的周期性調制信號作用下同時輸入噪聲和信號，當噪聲增強到某一強度的時候，信噪比不僅不會降低，相反系統會產生隨機共振從而使輸出信號得到顯著的增強。
  3. To accept the current signal from high negative voltage circuit, the analog ground is raised to a certain positive voltage, which makes it possible for the signal amplitude to be compressed at the same time of its polarity reversion. a pi control program special for laser gyro current control is brought forward according to the conventional pid control method, in which the control signal is figured out corresponding to the difference between the sample and the reference value by turn of proportion - short step integral - long step integral. and at the end of this paper, a comparison of system performance on different conditions is made and the key elements influencing system performance are educed

    利用集成a / d 、 d / a轉換器的新型晶元aduc824 ，實現了電流（電壓）采樣?數據處理?電流控制的閉環控制結構；地電位的抬升解決了a / d轉換器對負高壓迴路電流采樣時的輸入范圍匹配問題；控制信號反相的同時進行幅度壓縮，使得輸出調整電壓的解析度提高；根據常規的比例?積分?微分（ pid ）調節模型，針對陀螺系統的特性，給出了一種可以滿足系統要求、據采樣值偏差大小進行的比例?大步長積分?小步長積分、分層次比例?積分演算法；不同條件下系統穩流性能的對比、分析在論文最後給出，並據此找出了決定該系統穩流精度的關鍵因素，提出了系統的改進意見。
  4. The glitch may, in turn, reduce the relative magnitude, causing the output node of the input inverter to switch states

    此干擾脈沖反過來又減小（輸入信號）的相對幅度，造成輸入反相器的輸出節點改變狀態。
  5. The results show that wavelength locates in gain zone of semiconductor optical amplifier, and have higher peak power and proper time delay between the two pulses for the second order super gauss control pulse in semiconductor optical amplifier. a high quality amplified signal pulse can be achieved. the chirp can be reduced notability by using cascading soa in cross gain modulation based on soa, and the distance and the peak power of conversion optical pulse can be increased notability, and we can let down the demand for wavelength based on xgm in soa and enhance the flexibility of wavelength conversion

    我們應用二階超高斯光脈沖與高斯信號脈沖同時注入soa和應用soa與非線性光學環鏡（ nolm ）相結合的方案來對信號脈沖進行壓縮整形，模擬顯示，在調節系統合適參數的情況下，波長位於soa增益區的二階超高斯控制光脈沖在具有較高的峰值功率和適當時延下輸入soa時，最後可以得到放大的高質量超簡訊號光脈沖；在基於soa的交叉增益調制（ xgm ）全光波長轉換中，採用級聯的soa能有效地使反轉光脈沖的頻率啁啾得到有效降低，波長向下轉換的距離和反轉光的峰值能量都得到明顯提高，降低了利用交叉增益調制（ xgm ）波長轉換中對波長精度的要求，從而提高了波長轉換的靈和性。
  6. Compared with the similar research results, the weighted control ic here has the following characteristics : ( 1 ) the circuit structure is simpler ; ( 2 ) the chip ' s fabrication is compatible with standard cmos process ; ( 3 ) n - mosfets with high w / l ratio and short channels are used for weighting and output to reduce the insertion loss ; ( 4 ) the weighting factor varies in a relatively wide range with the controlling signals ; ( 5 ) input and output impedance approach 50 in low frequency ( e. g. 50mhz ), while in higher frequency they slightly deviate from 50, hence the energy reflection lower than 0. 1 ; ( 6 ) it completes the functions of sampling, weighting, controlling and summing of high frequency analog signals

    它的加權控制電路與已報道的相關電路相比具有如下特點：電路結構簡單；製造工藝與普通cmos工藝兼容：短溝道，高寬長比的nmos晶體管具有低的通導電阻，將其作為加權、輸出器件可降低由電路引起的插入損耗；改變加權信號，可實現權值在較大范圍內的連續變化；輸入、輸出阻抗在低頻（如50mhz ）下接近50 ，而在高頻下略有偏離50 ，但反射系數均低於0 . 1 ；實現了對高頻信號的取樣、加權、控制、疊加功能的迭加。
  7. New fet - input amplifiers, like the ad820 family of amplifiers, incorporate design improvements that prevent output voltage phase reversal for signals within the rated supply voltage range

    新型的fet輸入管放大器（如ad820系列放大器） ，在設計上做了改善，對于額定電源電壓范圍之內的信號，能夠防止輸出電壓相位反轉。
  8. A specific device equipped with sensing instruments for detecting input signals or environmental conditions, but with a reacting or guidance mechanism that can perform sensing, calculations, etc., and with stored programs for resultant actions

    一種特殊的裝置，上面安裝有檢測輸入信號或環境條件的傳感儀器，還裝有反應或導引機構，使它能完成感知、計算等功能，並有使它作相應的反應動作的存儲程序。
  9. The phase shifter circuit consists of five digital bits corresponding to differential phase shifts of 180, 90, 45, 22. 5 and 11. 25 cascaded in a linear arrangement. the three lower phase shift circuits are of loaded - line type, in which the 11. 25 phase shift bit use a single loaded - line configuration. the 90 and 180 phase shift bits are of reflection type, using lange coupler to realize the separation between the incident and reflection signals

    移相器電路由五位移相電路級聯而成， 11 . 25 、 22 . 5和45移相電路為加載線型，其中11 . 25採用了單加載線形式； 90和180為反射型移相電路，使用蘭格耦合器實現輸入、輸出信號的隔離。
  10. This thesis discusses detailedly the flow process of ip multicast, error discovery method and error recovery method, and also proposes a new error control method to implement reliable multicast in computer supported cooperative design system : serial integrates with timer are used to discover error, arq mechanism based on nak feedback is modified to correct error, " sliding window " mechanism is imported to make up the drawbacks of traditional nak, and " slotting and damping " technique is used to resolve the question of " feedback implosion " which results from multicast reliability control

    詳細研究了ip多播傳輸的流程、數據傳輸的差錯檢測方法及差錯恢復方法，提出在協同設計系統中實現可靠多播的控制方法：利用序列號和計時器相結合的方法進行傳輸數據的差錯檢測，改進了基於nak反饋信息的arq重傳機制來實現差錯恢復，並引入了滑動窗口機制來解決傳統nak方法的不足，採用「時間分槽?抑制」技術來解決由於進行多播可靠控制而產生的「反饋內陷」問題。
  11. In this control scheme, the voltage error is processed by pi algorithms first, and then the current of the capacitor which equal to the differential of the voltage is imported to compose a two - loop control

    該方案先對輸出電壓誤差進行pi調節，在此基礎上引入相當于輸出電壓微分的電容電流反饋信號構成雙環控制，使逆變器輸出電壓具有良好的靜態特性和動態特性。
  12. However, since there are numerous and interlaced variables that drastically affect the si, here focus on reflection crosstalk and other si problems of differential input / output lines of sfp. based on the circuit analysis, through adjusting the board layout to optimize the signal transfer and ensure the signal integrity

    由於影響信號完整性的因素是多方面的，是相互交錯的，本文在理論分析基礎上主要介紹了sfp光收發模塊的差分輸入輸出線影響信號完整性的反射、串擾等幾個方面的模擬分析項目。
分享友人
分享到 Line

分享到臉書