輸出信號平衡 的英文怎麼說

中文拼音 [shūchūxìnháopínghéng]
輸出信號平衡 英文
output signal balance
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 號 : 號Ⅰ名1 （名稱） name 2 （別號; 字） assumed name; alternative name3 （商店） business house 4 （...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. The harmonic balance simulation and envelope simulation are applied in the cad progress of pulse oscillator, the results of simulation are listed, and the output signal of pulse oscillator is analyzed by mathematical method

    以脈沖振蕩器的cad為例，對脈沖振蕩器分別進行諧波平衡模擬和包絡模擬，列出了模擬結果，並對脈沖振蕩器輸出信號進行數學分析。
  2. The improved algorithm not only inherits the fast convergence trait from rls and realizable systolic array from qr _ rls, but also eliminates square - root operation and gets directly equalizer output signals from systolic array. so this algorithm has more simple operation, faster executing speed, less hardware resource and lower hardware cost. some different equalization algorithm are imitated on the qpsk communication system with multipath channel

    其次對一些成熟的自適應均衡演算法（如lms演算法、 rls演算法、 qr _ rls演算法、逆qr _ rls演算法）進行了分析;介紹了一種改進后的無平方根的qr _ rls演算法，該演算法不但繼承了rls的快速收斂特性和qr _ rls演算法的systolic陣列可實現性，還取消了qr _ rls演算法的平方根運算，使演算法在硬體實現時運行速度更快，佔用資源也更少，同時該演算法還可由systolic陣列直接得到均衡后的輸出信號，運算量更小。
  3. Become a kind of new electronics circuit - current - mode circuit. it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components, they are stronger modified standard current - mode parts in fuctions on this foundation. mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ), they are all function very strong standard current - mode parts, they all can provide some circuit functions of better than general operation amplifier, because they have the voltage importation and the current importation, therefore use it since can carry out the voltage - mode signal processing circuit expediently, can also carry out the current - mode signal processing circuit expediently, and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode, but have their advantages more according to the current - mode filter of the modified current conveyor, because it constitutes in brief, the filter wave function is stronger and they are better than in general use operation amplifier of many advantages, be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small, the impedance is different from etc. advantages, otherwise they have biggish dynamic range, and flexible circuit synthesize, so they are the best active parts

    從第二代電流傳輸器ccii入手，重點研究了以下幾種改進型的第二代電流傳輸器:改進的差動差分電流傳輸器mddccii 、全平衡第二代電流傳輸器fbccii 、多輸出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、電流差分緩沖放大器cdba的電路結構及其模型。然後在此基礎上系統地研究了基於這幾種改進型的第二代電流傳輸器的濾波器的設計方法，主要方法和結果如下:利用mddccii設計了差分式連續時間電流模式低通、帶通濾波器;電流模式跳耦結構考爾低通濾波器;利用fbccii設計了帶通二階節濾波器及電流模式雙二階通用濾波器;設計了基於多輸出端ftfn的電流模式二階通用濾波器電路;通過數字化開關選擇的基於fbftfn的電流模式通用濾波器;設計了基於最少個數電流緩沖放大器（兩個cdba ）的多功能通用電流模式濾波器及其在非理想因素情況下分析。設計濾波器的主要方法是採用級聯設計、運算模擬（信號流圖法）和反饋設計（跳耦法） 。
  4. The theory of this novel gyroscope is analysed, the output optical power formulae is deduced. the balance - output or the single - port - output can be used in this novel gyroscope, and the signal measure methods of the sagnac interferometric optical fiber gyroscope can be used in it too

    本文分析了其工作的基本原理，推導了輸出光功率表達式，指出可以採用平衡輸出或單端輸出兩種信號輸出方法，可以採用類似於sagnac干涉式光纖陀螺的信號檢測方式。
  5. This dissertation presented two new methods of robust adaptive track control for a class of mimo strong nonlinear system with external disturbance. one method makes use of taylor approximation principle to linearize the mimo strong nonlinear system at the ideal equilibrium point, meanwhile external disturbance is considered, and then designs two on - line neural network controller respectively, which can dynamically compensate the high order items of taylor series and the control signals at ideal equilibrium point under the drive of state error between linear and nonlinear system. a linear feedback controller obtained by pole assignment and two on - line neural network act on the practical mimo high nonlinear system together, guaranteeing the whole system robust stable and tracking the specified signal ; the other method designs three on - line neural networks for this class of system

    本文對於一類含有外部擾動的多輸入多輸出（ mimo ）強非線性系統，提出了兩種新的魯棒自適應跟蹤控制方法，第一種利用了taylor近似的原理，在考慮了外部擾動的情況下，將mimo強非線性系統在理想平衡點處線性化，分別設計了兩個在線神經網路控制器，在線性和非線性系統之間的狀態誤差驅動下動態補償系統的taylor近似高階項及理想平衡點處的控制信號，滿足極點配置方法的線性反饋控制器和兩個在線神經網路聯合作用於實際的被控mimo強非線性系統，在保證整個系統魯棒穩定性的情況下，能夠跟蹤給定的指令信號；另一種方法是針對這類系統設計了3個在線神經網路，分別實時抵消這類非線性系統中的非線性部分、與控制量耦合的非線性項以及外部擾動，使得受控系統的輸出可以完全跟蹤給定輸入參考信號。
  6. With this feedback, the density of the half - cycle pulses in the synthesized output is modulated by the amplitude of the reference signal

    這個面積的平衡導致輸出半個周期脈沖的密度由參考信號的幅值來控制。
  7. A new dsp algorithm for doppler frequency measurement is constructed in the second method, where the circuit configuration is simplified, the balanced i / q channels can be available and the time for digital signal processing is reduced

    在第二種方案中，提出了一種測量多普勒頻移的數字信號處理演算法，簡化了硬體，獲得了平衡的i q通道輸出，縮短了dsp處理時間。
  8. The main advantage of this pdm converter is that one half - cycle of the high - frequency voltage becomes the basic unit of synthesis of the low - frequency signals. the area difference under the reference signal and synthesized signal and the next pulse with the polarity will reduce thi s difference

    Pdm技術的特點是將高頻交流脈沖信號的一個半周期作為合成低頻信號的基本單元，通過比較同時刻參考波形和輸出波形的面積差，使得兩個曲線包圍的面積可以基本維持平衡。
分享友人
分享到 Line

分享到臉書