輸出光束 的英文怎麼說

中文拼音 [shūchūguāngshù]
輸出光束 英文
output beam
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 束 : Ⅰ動詞1 （捆; 系） bind; tie 2 （控制; 約束）control; restrain Ⅱ量詞（用於捆在一起的東西） bundle;...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. Futhermore, we have two questions about " the propagation properties of hermite - cosh - gaussian laser beams " in optics communications 186 ( 2000 ). one is the eq

    第三章提出了ehchg光束，用collins公式研究了ehchg光束在光學abcd系統中的傳輸，得到傳輸表達式。
  2. The principle of the interleaver with output spectra similar to cosine function, based on mzi, is analyzed theoretically. by using the tandem of two mzis, we get the flattop spectrum ; last, grounding on the polarized light interference and multi - beam interference, we analysis the principle of bgti interleaver, and simulate the relations between output spectra and reflectance of g - t resonator. furthermore the flattop output spectrum of bgti interleaver is achieved

    4 、分析了fmzi型interleaver濾波器的工作原理，其輸出光譜曲線為類餘弦函數；採用級聯fmzi方案，實現了interleaver濾波器的光譜平頂光譜輸出；最後，基於偏振光干涉和多光束干涉原理，分析了bgti型interleaver濾波器工作原理，模擬了g - t腔部分反射系數r與輸出光譜的關系，獲得了50ghzbgti型interleaver濾波器平頂化輸出光譜。
  3. The optical near - field distribution and propagation properties of solid immersion lens system are analyzed in detail when illuminated by linearly polarized focusing gauss beam. the change of the optical intensity and beam dimension at the bottom of solid immersion lens with different refractive index and different distance are discussed. the simulated results reveal that the higher the refractive index is, the stronger the optical intensity and the smaller the beam dimension at the bottom of the solid immersion lens will be

    編制了對固體浸沒透鏡近場超高密度光存儲系統進行模擬的二維時域有限差分程序，實現了對固體浸沒透鏡光存儲系統的數值模擬；著重研究了線偏振的高斯光束通過固體浸沒透鏡的光傳輸和近場光場分佈特性；分析了固體浸沒透鏡底面出射光強、光斑直徑隨固體浸沒透鏡折射率的變化、光透過固體浸沒透鏡后的強度、光斑直徑隨離開固體浸沒透鏡底面距離的變化。
  4. The experiment of intracavity doubling of a 946 nm nd : yag laser with an lbo crystal has been done at room temperature. a continuous wave 473 nm laser is obtained with 235mw output power at a pump power of 20w. the laser beam quality of 473 nm is good as well

    對腔內倍頻輸出473nm激光進行了初步的實驗研究，在泵浦功率為20w時， l獲得了光束質量較好的連續波形式的藍光激光輸出，其功率為200mw 。
  5. It is discoverde that with a looped feedback circuit, the dds acousto - optic mode locking has the function of tracking the frequency interval of the laser resonator longitudinal mode, and stabilizing the quality of the laser beams

    Dds聲光鎖模器在增加閉環反饋環路后，可以跟蹤激光諧振腔縱模頻率間隔變化，穩定激光光束輸出質量。
  6. On the other hand, the electric field and intensity distributions of the he11 mode in the hollow fiber are calculated by using the exact solutions of maxwell equations based on the vector model, and the diffracted near - and far - field distributions of the he11 - mode output beam under the fresnel approximation are studies. we derive an analytical expression on the far - field distribution of the he n - mode output beam in free space and discuss its applicable condition. we also analyze and compare the differences between the he11 - and lp01 - mode output beams, and find that the near - field distribution of the lpoi - mode output beam is a gaussian - like one, but the near - field distribution of the he11 - mode output beam is a doughnut - like one, whereas the far - field distribution of both the lp01 - and he11 - mode output beams are a doughnut one

    此外，我們把中空光纖中lp _ （ 01 ）模（標量模型）和he _ （ 11 ）模（矢量模型）的場分佈以及它們各自的輸出光束的近場與遠場分佈進行了比較，發現兩種模式的輸出光束在近場分佈有很大的區別， lp _ （ 01 ）模輸出光束在近場是一個高斯分佈，而he _ （ 11 ）模輸出光束在近場是一個中空光束，在遠場兩種模式的輸出光束分佈是基本一致的，這正是由於在中空光纖中採用了弱波導近似以後所引起的誤差。
  7. ( 3 ) the thickness of the liquid crystal and the arrangement of liquid crystal molecule are flexible, there are no deviation in the outgoing beams

    摘要第2頁3 、濾光片中的液晶厚度、液晶分子的排列方向比較靈活，輸出光束不發生偏離。
  8. Due to the inevitable absorption of crystal window, the crystal window will be distorted even burst while the power of high energy laser apparatus is several hundred thousand watt even mega - watt, so the quality of laser beam will be influenced and the laser apparatus will not work properly

    由於晶體材料窗口不可避免的部分吸收作用，對于目前幾十萬瓦甚至兆瓦級的高能激光器來說，晶體窗口會產生熱畸變甚至炸裂，從而影響輸出光束質量甚至使激光器根本無法工作。
  9. Only the main transmitted light from the glued layer or the first - order transmitted light also, is considered at most in the existing study outcome about light intensity transmission. on occasion, some experimental results about light transmission are given as a performance index. and nearly no one considers the contribution of the higher - order transmitted lights and the effects of the inaccuracy in glue technology on light distribution

    人們對它的研究，往往只考慮棱鏡膠合層的兩切割斜面上的主透射光束，至多同時考慮次級透射光束對出射光強的影響，或直接將光束光強透射比的實驗值的平均結果作為棱鏡的一個性能指標給出，很少考慮棱鏡膠合層間光束的多次反射對輸出光強的影響以及結構誤差和使用調整誤差對棱鏡光強分佈的影響。
  10. How to improve the output energy and beam quality were two most noteworthy problems in the building of high power solid - state laser facility

    提高系統能量轉換效率與輸出光束質量一直是研製高功率固體激光系統極為關注的兩類重要問題。
  11. Calculations show that the near - field profile of the output beam is strong function of the laser launching conditions

    計算表明，激光入射條件與光纖輸出光束的近場功率密度分佈有著函數關系。
  12. Under the weakly guiding approximation, we derive the electric - field distribution of the lp01 mode in the hollow fiber. the far - and near - field distribution of the lp01 - mode output beam in free space is calculated numerically from fraunhofer and fressnel diffraction theory

    在弱波導近似下導出了中空光纖中lp _ （ 01 ）模的電場分佈，數值推算了lp _ （ 01 ）模輸出光束的遠場和近場分佈。
  13. In fast axis the divergentce of each beam is 0. 28o, in slow axis is 1. 4o, the area of field from the end of ld stack 20cm is 42 25mm2, average wave is 9. 3 %. so, it can meet the requirement of pumping, and the effect is fairly good

    具體數據為:各輸出光束在快軸方向的發散角為0 . 28o ，在慢軸方向的發散角為1 . 4o ，輸出光場在距ld面陣發射端面20cm處的面積為42 25mm2 ，平均波紋起伏為9 . 3 % ，可見整形效果較好
  14. Applying 200 m quartz fibers in the ld - pumped laser system with double - pass configuration, 57 % sbs reflectivity, near 92 % sbs fidelity and 85 % relative stability have been obtained. and high beam quality of phase - conjugated laser close to that of oscillator has been achieved

    應用200 m光纖經雙通放大最高可獲得57的能量反射率、 85的相對穩定性以及92的相位共軛保真度，並觀察到激光系統的輸出光束質量被顯著改善。
  15. High power diode laser array coupling with optical fiber not only make the use of diode laser easier, but also improve the dissymmetry of its output light beam and in the meantime, the output light coupling between the ld sources becomes easier and the power becomes higher

    大功率半導體激光器採用光纖耦合輸出方式不僅簡化了器件的應用，改善了輸出光束的非對稱性，同時還可以簡便地實現多個半導體激光器的光源之間的輸出光耦合或組合，得到更高的功率輸出。
  16. 3. because traditional coupling system composed with cylinder lens and focus lens has the disadvantages of difficult to encapsulation and modulate, a new practical method brings forward : the output light from laser diode is collimated using a section of optical fiber with the diameter of 600 m instead of cylinder lens, and a sphere ? end lens

    3 .針對由柱透鏡和聚焦透鏡組成的組合透鏡耦合系統中存在的封裝和調試困難等問題，提出了:用一段直徑為600 m的裸石英光纖代替柱透鏡，對半導體激光器輸出光束進行準直整形;用球透鏡光纖對準直后的光束進行聚焦，直接實現和光纖耦合，來代替聚焦透鏡和光纖耦合的環節。
  17. The theoretical analysis shows that mz - ifog can be used to detect the rotation rate of moving objects. a systematic analysis of transfer characteristics of mz - ifog is made. performance - limiting factors, including the path - length difference, the disturbance of temperature fluctuation and stress from working environment, the quality of light source, are all discussed along with methods to reduce their effect on the output signal

    本文用系統的方法分析了mz型干涉式光纖陀螺儀的光傳輸特徵，指出了其較大的非互易性因素-臂長差的存在，分析了工作環境因素（溫度，應力） 、光源質量（輸出光束中心波長、光功率波動及偏振態波動）對系統工作性能的影響，並指出了減少系統非互易因素、抑制噪聲、提高檢測穩定性的措施。
  18. ( 3 ) another method using liquid crystal spatial light modulator can control the small region of incident laser, which can change the intensity distribution and uniform temperature distribution. the related driver circuit of liquid crystal spatial light

    （ 3 ）採用液晶空間光調制器方案實現溫度分佈均勻化通過液晶空間光調制器對入射光束不同位置的微小局部進行幅度調制，從而改變輸出光場分佈，達到均勻化的目的。
  19. To the simplification of the kind of special medical treatment fiber, a study on the optical fiber at the output angle 90o relative to the central axis of the fiber is presented. this article includes the following segments : 1 the basic theories are offered which include the optical transmission theory in fiber and tilt effect on the fiber end

    針對目前專用醫療輸出光纖品種較少的現狀，利用光纖金屬化:研磨-活化-鍍膜-熱處理等一系列成熟工藝，研製了一種可以改變光路、使激光束能沿著垂直光纖中心軸的方向輸出的一種新型的90o出光輸出光纖。
  20. In recent years, high power laser diode array has been widely applied in many application fields such as pump solid laser, material processing and laser medical exposure, however, because of the bad performance of its output beam, which affects its direct application, thus make it a hot view which people pay much attention on how to transform the beam of the high efficient laser diode array, institutions internal and abroad have been doing much research on the problem

    近年來，大功率半導體激光器列陣被廣泛用於泵浦固體激光器?材料加工及激光醫療等應用領域中，但由於其輸出光束的質量不好，影響了它的直接應用，因此大功率半導體激光器列陣的光束整形成了人們關注的一個熱點問題，國內外的研究機構對此進行了大量的研究
分享友人
分享到 Line

分享到臉書